Question

what is the safety , enviromential and hazerd for scrubber column use in prodection of acetone

what is the safety , enviromential and hazerd for scrubber column use in prodection of acetone

Homework Answers

Answer #1

safety

1) Adsorbing material should not be saturated otherwise pressure drop will be more and may cause incasuality to the surroundings.

2) The temperature to be maintained at optimum.

3) The optimum velocity of the acetone to be maintained so that properly it can separate may be some choking can happen which can cause damage to the column.

Environmental

1) proper scrubbing should be done otherwise chemical compound will reach to air and will damage the environment

2) optimum velocity to be maintained to seperate the gas from the column and prevent it to reach into the environment

3) entrainment should not take place

Hazard

1) Adsorbing material has to be checked on a regular basis and replaced after its surface is get clogged it may damage the equipment.

2) pressure drop should be monitored to prevent any hazard

3) column inspection should be there so that there is no leakage of gas

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
what would have been the result if the column was run with the acetone as the...
what would have been the result if the column was run with the acetone as the only eluting solvent? thoroughly explain your answer.
Separation of Acetone and Ethanol A distillation column with a total condenser and partial reboiler is...
Separation of Acetone and Ethanol A distillation column with a total condenser and partial reboiler is separating acetone and ethanol (equilibrium data is provided in the table below). The feed is 70 mole% acetone, flows at 1000 mol/h, and is a superheated vapor for which one mole of liquid must be vaporized on the feed plate to cool four moles of feed. We desire a bottoms composition of 5 mole% acetone and a distillate composition of 90 mole% acetone. The...
By means of a plate column, acetone is absorbed from its mixture with air in a...
By means of a plate column, acetone is absorbed from its mixture with air in a non-volatile absorption oil. The entering gas contains 20 mole percent acetone, and the entering oil is acetone-free. Of the acetone in the air, 98.5 percent is to be absorbed, and the concentration of the liquor at the bottom of the tower is to contain 8 mole percent acetone. The equilibrium relationship is ye=1.85xe. Plot the operating line and determine the minimum number of stages....
A distillation column with a total condenser is separating acetone from ethanol. A distillate concentration of...
A distillation column with a total condenser is separating acetone from ethanol. A distillate concentration of xD = 0.90 mole fraction acetone is desired. Since CMO is valid, L/V = constant. If L/V is equal to 0.8. The distillation column has a partial reboiler that acts as an equilibrium contact. If the bottoms composition is xB = 0.13 mole fraction acetone and the boilup ratio V/B= 1.0, find the vapor composition leaving the second stage above the partial reboiler. a)...
A countercurrent absorption column operating at 3 atm and 20 °C is used to scrub acetone...
A countercurrent absorption column operating at 3 atm and 20 °C is used to scrub acetone from air into water. Separation is to be accomplished in 5 equilibrium stages. The total inlet gas flow rate is 100 kmol/h and contains 0.4 mol% acetone. The inlet liquid contains 0.01 mol% acetone. Outlet gas is 0.02 mol% acetone. Assume constant flow rates and note that the Henry’s law constant (H) for acetone in water at 20 °C is 1.186 atm/(mole fraction). Find...
How is acetone recovery determined from acetone concentrations at the top and the bottom of the...
How is acetone recovery determined from acetone concentrations at the top and the bottom of the stripping column?
Consider a mixture of benzene (bp 80) and acetone (bp 56). (a) which compound will emerge...
Consider a mixture of benzene (bp 80) and acetone (bp 56). (a) which compound will emerge first on a non-polar column? on a polar column? (b) which type of column (polar or nonpolar) would gie a better separation or resolution of benzene-acetone mixture? Now cosider a mixture of aetone and butanone (bp 79.5) and compare with the benzene-acetone. (c) will the resolution of the acetone-butanone mixture be better or worse than for the acetone-benzene mixture ont he non-polar column? (d)...
The normal boiling point of acetone is 56.2EC. The ÄHvap of acetone is 32.0 kJ/mol -What...
The normal boiling point of acetone is 56.2EC. The ÄHvap of acetone is 32.0 kJ/mol -What is the vapor pressure of acetone at its normal boiling point? -Is the vapor pressure of acetone at 20.0EC higher or lower than at 56.2EC? -What is the vapor pressure of acetone at 20.0EC ?
You will you use TLC to evaluate if your column chromatography separation was successful. The mobile...
You will you use TLC to evaluate if your column chromatography separation was successful. The mobile phase is 10% acetone in heptane and the stationary phase of your TLC plate is silica. Which compound from your mix would you expect to see traveling further from the baseline of the plate? why?
In a gas absorption tower, acetone is absorbed from its mixture with air using a nonvolatile...
In a gas absorption tower, acetone is absorbed from its mixture with air using a nonvolatile absorption oil. 100 mol/h of gas mixture enter the bottom of the column contains 30 mol% acetone while 261.9 mol/h oil enter the top of the column. The exiting gas stream is to contain 1.3 mol% acetone. a) Determine molar flow rate of the exiting gas and exiting liquid streams. b) Determine number of stages required for the above process.
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT