Question

A city's water supply is contaminated with a toxin at a concentration of 0.63 mg/L. fortunately,...

A city's water supply is contaminated with a toxin at a concentration of 0.63 mg/L. fortunately, this toxin decomposes to a safe mixture of product by first order kinetics with a rate constant of 0.27days^-1. how long will it take for the half life of the toxin to decompose. please show work

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
Toluene has contaminated a city's drinking water supply. An activated carbon system will be designed to...
Toluene has contaminated a city's drinking water supply. An activated carbon system will be designed to remove toluene to below regulatory levels. If equilibrium is achieved between activated carbon and aqueous-phases and the concentration of toluene in the aqueous-phase is 0.010 mg/L, what will be the concentration of toluene sorbed to the activated carbon? The Freundlich parameters for toluene and the particular type of activated carbon are: K= 159 mg/g (L/mg)^1/n = 0.54. Express your answer in units of mg...
Water flows at 20 cm3/sec through a long straight tube that has an inner diameter of...
Water flows at 20 cm3/sec through a long straight tube that has an inner diameter of 1 cm. As the water flows, a toxin leaches from the tube into the water. At the inner surface of the tube, the toxin attains its saturation concentration, Csat = 2 mM. Fortunately, upon entering the water the toxin also irreversibly degrades into a non-toxic compound; this degradation follows first-order kinetics. Toxin Diffusivity D = 10-5 cm2/sec Toxin mass transfer coefficient k = 1.38...
A contaminant degrades at a rate o f0.0035 min-1. The initial concentration is 1.5 mg/L. The...
A contaminant degrades at a rate o f0.0035 min-1. The initial concentration is 1.5 mg/L. The regulatory limit is 1ppb. a. Find the half-life of the contaminant. b. Find the concentration of the contaminant one hour after the reaction started. c. How long will it take until the contaminant reaches the regulatory limit?
The integrated rate law allows chemists to predict the reactant concentration after a certain amount of...
The integrated rate law allows chemists to predict the reactant concentration after a certain amount of time, or the time it would take for a certain concentration to be reached. The integrated rate law for a first-order reaction is: [A]=[A]0e−kt Now say we are particularly interested in the time it would take for the concentration to become one-half of its initial value. Then we could substitute [A]02 for [A] and rearrange the equation to: t1/2=0.693k This equation calculates the time...
6. (1) A water treatment plant applies chlorine for disinfection so that 10 mg/L chlorine is...
6. (1) A water treatment plant applies chlorine for disinfection so that 10 mg/L chlorine is achieved immediately after mixing. The volume of water treated each day is 25,000,000 gal. What is the mass of chlorine needed by this plant every day? (2) The disinfection takes place in a contact tank which is a CSTR at steady state. Chlorine concentration in the contact tank is constant at 3 mg/L. Effluent of this contact tank will enter drinking water distribution systems...
"For the reaction 2 N2O5 --> 4 NO2 + O2 the rate constant is 6.82 x...
"For the reaction 2 N2O5 --> 4 NO2 + O2 the rate constant is 6.82 x 10^-3 s^-1 at 70 degrees Celsius. The reaction is first order overall. If you start with 0.350 mol of dinitrogen pentoxide in a 2.0 L volume, how many miles will remain after 10 minutes? How long will it take for you to have 0.125 moles of reactant left? What is the half-life of dinitrogen pentoxide?" *Please show all work. * if it's out of...
1) Use Henry's law to determine the molar solubility of helium at a pressure of 1.9...
1) Use Henry's law to determine the molar solubility of helium at a pressure of 1.9 atm and 25 ∘C. Henry’s law constant for helium gas in water at 25 ∘C is 3.70⋅10−4M/atm. 2) A 2.800×10−2M solution of NaCl in water is at 20.0∘C. The sample was created by dissolving a sample of NaCl in water and then bringing the volume up to 1.000 L. It was determined that the volume of water needed to do this was 999.2 mL...
1) Describe an example of each of the following that may be found of your kitchen:...
1) Describe an example of each of the following that may be found of your kitchen: Explain how your choice falls into this category, and if there is a chemical name or symbol for it, provide that as well. Provide a photo of your example with your ID card in it. a) a compound b) a heterogeneous mixture c) an element (symbol) Moving to the Caves… Lechuguilla Caves specifically. Check out this picture of crystals of gypsum left behind in...
Please show me how to apply CVP analysis for this case study. FLY ASH BRICK PROJECT:...
Please show me how to apply CVP analysis for this case study. FLY ASH BRICK PROJECT: FEASIBILITY STUDY USING CVP ANALYSIS S. K. Mitra and Shubhra Hajela wrote this case solely to provide material for class discussion. The authors do not intend to illustrate either effective or ineffective handling of a managerial situation. The authors may have disguised certain names and other identifying information to protect confidentiality. This publication may not be transmitted, photocopied, digitized or otherwise reproduced in any...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT