Question

Estimate the magnitude of the loop gain of the circuit .The op-amp has the following parameters:...

Estimate the magnitude of the loop gain of the circuit .The op-amp has the following parameters: differential input resistance, rd = 1 M?, output resistance, ro = 100 ?, open-loop gain, Aol = 105. Assume R1 = 24.01 k? and R2 = 5.89 k?

Engineering   Electrical-Engineering   
0 0
Add a commentTranscribed image text
Next >

Homework Answers

Answer #1

so final answer magnitude of loop gain=83.723

0 0
Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Log In

Sign Up

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
1. Calculate the input difference in potential (eNI − eINV) for an op amp amplifier with...
1. Calculate the input difference in potential (eNI − eINV) for an op amp amplifier with an output voltage of 10 V and an open loop gain of a. 2000 b. 30,000 2. Locate specifications for the LM741 and the LF411 (National Semiconductor). For each determine the worst case a. input impedance. b. open loop gain c. gain bandwidth. 3. Assuming β = 0.05, and AOL = 2000, calculate the closed loop gain using the approximation.
Consider an op-amp connected in an inverting configuration to realize a closed-loop gain of -100 V/V...
Consider an op-amp connected in an inverting configuration to realize a closed-loop gain of -100 V/V utilizing resistors of 1k and 100 k. A load resistance RLis connected from the output to ground, and a low-frequency sine-wave signal of peak amplitude Vpeakis applied to the input. Let the op amp be ideal except that its output voltage saturates at 10 Vand its output current is limited to the range of 20 mA. 1) For RL = 1k, what is the...
4. Using an op amp, design a circuit to produce an output voltage related to two...
4. Using an op amp, design a circuit to produce an output voltage related to two input voltages by the equation ?? = 1 2 ?2 − ?? (Use the feedback resistance R2 = 10kΩ). Devise a procedure to verify your design.
Using a 741 op-amp for every stage, design this circuit: The input stage has a voltage...
Using a 741 op-amp for every stage, design this circuit: The input stage has a voltage gain of 10 and input impedance of 50 K?. The low pass filter stage has a Sallen-Key (VCVS) third order butterworth response and a cutoff frequency of 5KHz. The output buffer stage has a voltage gain of 10.
Use an ideal op amp to design a differentiator circuit having a time constant of 10-5s...
Use an ideal op amp to design a differentiator circuit having a time constant of 10-5s using a 1-nF capacitor. Sketch the magnitude and phase response of the circuit, indicating the frequency at which the magnitude response equals 0 dB. A series input resistor is added to limit the gain magnitude at high frequencies to 100 V/V. Sketch the magnitude and phase responses of this modified circuit on the same axes as the ideal differentiator. How does the phase response...
Design an inverting amplifier to meet the following requirements. You will need an op amp circuit...
Design an inverting amplifier to meet the following requirements. You will need an op amp circuit plus a BJT push pull output circuit to get the power required. ein = +4 dBu at audio frequencies 40 W to a 5 Ω load input impedance 4.9 k Ω TA = 40° C and Tj max = 140° C power supplies: ±18Vdc and ±28Vdc, each at 6 Adc Show all work. Please help thank you!
Consider the following series circuit with a 105 volt battery and three resistors; R1=4 ohm, R2=5...
Consider the following series circuit with a 105 volt battery and three resistors; R1=4 ohm, R2=5 ohm, and R3=6 ohm a) Will the current in this circuit flow clockwise or counterclockwise? Explain your reasoning in three lines or less. b) What is the equivalent resistance of the three resistors above wired in series, in ohms? c) Draw the equivalent simple circuit. d) Find the current in the equivalent simple circuit, in amps. e) What is the current in the original...
ch 6 1: It is generally a good idea to gain an understanding of the "size"...
ch 6 1: It is generally a good idea to gain an understanding of the "size" of units. Consider the objects and calculate the kinetic energy of each one. A ladybug weighing 37.3 mg flies by your head at 3.83 km/h . ×10 J A 7.15 kg bowling ball slides (not rolls) down an alley at 17.5 km/h . J A car weighing 1260 kg moves at a speed of 49.5 km/h. 5: The graph shows the ?-directed force ??...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT