Question

1. Calculate the input difference in potential (eNI − eINV) for an op amp amplifier with...

1. Calculate the input difference in potential (eNI − eINV) for an op amp amplifier with an output voltage of 10 V and an open loop gain of

a. 2000

b. 30,000

2. Locate specifications for the LM741 and the LF411 (National Semiconductor). For each determine the worst case a. input impedance.

b. open loop gain

c. gain bandwidth.

3. Assuming β = 0.05, and AOL = 2000, calculate the closed loop gain using the approximation.

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
1. Design an inverting amplifier with gain of ×10, and input impedance of 100Ω. 2. Design...
1. Design an inverting amplifier with gain of ×10, and input impedance of 100Ω. 2. Design a non-inverting amplifier with a gain of ×10. Design the amplifier so that the output current from the op-amp at maximum output voltage +15V is no larger than 15 mA. 3. Design a current summing amplifier that finds the algebraic sum of two input voltages: VOUT = - (V1 + V2) . Design the amplifier so that output current from the op-amp at maximum...
Estimate the magnitude of the loop gain of the circuit .The op-amp has the following parameters:...
Estimate the magnitude of the loop gain of the circuit .The op-amp has the following parameters: differential input resistance, rd = 1 M?, output resistance, ro = 100 ?, open-loop gain, Aol = 105. Assume R1 = 24.01 k? and R2 = 5.89 k?
1. For an inverting amplifier with a voltage gain of -10 and an input resistance of...
1. For an inverting amplifier with a voltage gain of -10 and an input resistance of 1 kilohm, calculate the value of the feedback resistor (Rf) in kilohms. 2. For a non-inverting amplifier with a voltage gain of 11, what is the ratio of R2 to R1? 3. Which pin of the 741 op-amp should be connected to the positive supply voltage (e.g. +15V)? 4. For an inverting amplifier with a voltage gain of -20 and an input resistance of...
Using a 741 op-amp for every stage, design this circuit: The input stage has a voltage...
Using a 741 op-amp for every stage, design this circuit: The input stage has a voltage gain of 10 and input impedance of 50 K?. The low pass filter stage has a Sallen-Key (VCVS) third order butterworth response and a cutoff frequency of 5KHz. The output buffer stage has a voltage gain of 10.
Primary way to control open loop gain? Using input resistors Positive feedback Apply negative feedback Ground...
Primary way to control open loop gain? Using input resistors Positive feedback Apply negative feedback Ground one input One type of internal op amp failure Constant high input Constant low output Either a or b None of the above A summing amplifier Algebracally adds the diffrence between two inputs Algebraically adds two inputs Algebraically adds any bumber of inputs None of the above With negative feedback Input voltage easily deive an op amp into no linear operation Gain is nearly...
Consider an op-amp connected in an inverting configuration to realize a closed-loop gain of -100 V/V...
Consider an op-amp connected in an inverting configuration to realize a closed-loop gain of -100 V/V utilizing resistors of 1k and 100 k. A load resistance RLis connected from the output to ground, and a low-frequency sine-wave signal of peak amplitude Vpeakis applied to the input. Let the op amp be ideal except that its output voltage saturates at 10 Vand its output current is limited to the range of 20 mA. 1) For RL = 1k, what is the...
In a two-story voltage amplifier circuit, there is PNP on the first floor and NPN on...
In a two-story voltage amplifier circuit, there is PNP on the first floor and NPN on the second floor. A total of 10 resistors and a total of 5 capacitors were used in the circuit, 5 resistors per floor. Re resistance of PNP transistor is 63.31 Ω and re resistance of NPN transistor is 15.25 Ω. The input impedance of the first floor is 212.36 Ω and the input impedance of the second floor is 9.1 K Ω. There is...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT