Question

A Soil sample was collected and results were as follow: 0-10 ft Medium Sand with a...

A Soil sample was collected and results were as follow: 0-10 ft Medium Sand with a density of 110pcf, from 10-32 ft medium sand with a density of 124pcf, from 32-50 ft stiff clay with a density of 100pcf, from 50-60 Balsat rock, water was encounter at 10ft. Calculate the total pressure, water pressure and effective pressure for the following heights  

What is the Total Pressure @ 10 ft/

What id the water Pressure at 9 ft?

What is the effective pressure @ 50ft?

What is the water pressure at 32 ft?

What is the effective pressure @25 ft?

What is the Total Pressure @ 50ft?

What is the water pressure @ 50ft?

What is the Effective pressure @ 49ft?

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
The soil profile at the bottom of a 10-ft deep lake consists of 3 feet of...
The soil profile at the bottom of a 10-ft deep lake consists of 3 feet of high plasticity clay (γsat= 118 pcf) above 12 feet of silty sand (γsat= 124 pcf). Below the silty sand is a 20-ft-thick layer of poorly graded sand(γsat= 123 pcf). During a drought, the lake depth reduces to only 5 feet. Calculate the change in total stress, effective stress, and pore water pressure at the center of the SP layer due to drought conditions.
What is the density of soil that contains 30% silt, 30% clay, 30%sand and 10% water...
What is the density of soil that contains 30% silt, 30% clay, 30%sand and 10% water by mass?
b) A sample of moist soil has a mass of 18.18kg and occupies a total volume...
b) A sample of moist soil has a mass of 18.18kg and occupies a total volume of 0.009 m3. When dried in an oven, the dry mass is 16.13kg. The specific gravity of the soil solids is 2.70. (Acceleration of gravity, g = 9.81 m/sec2.) Determine: Wet density Dry unit weight Void ratio Water content Degree of saturation c) A 4.5 m deep deposit of silty sand lies above a 6 m deep deposit of gravel. The gravel is underlain...
Consider a 20 foot thick saturated clay that has a sand layer above it and an...
Consider a 20 foot thick saturated clay that has a sand layer above it and an impermeable rock layer below it. The clay layer has an initial effective stress at its midpoint of 3145 lbs/ft2.    Due to the presence of a large water tank on the surface, the stress is increased by 710 lbs/ft2 at the midpoint of the clay layer. How much total settlement from primary consolidation is expected? Provide your answer in inches. Soil properties: Compression index = .324,...
1) A Standard Penetration Test (SPT was performed at a depth of 10 ft in sand...
1) A Standard Penetration Test (SPT was performed at a depth of 10 ft in sand of unit weight 125 lb/ft3. The N-value was found to be 30. Determine the corrected N-value. CN = 0.77 x log10 (20/po) A. 32 B. 34 C. 37 D. 40 2) A standard penetration test was conducted in the field. The boring logger recorded following three readings for 6 inch interval of penetration: 1/2/3. What is N-value? A. 3 B. 5 C. 2 D....
For the 10 soil or rock conditions indicated below to select the most likely tunneling method....
For the 10 soil or rock conditions indicated below to select the most likely tunneling method. More one answer may apply but select what you consider is the best answer. Explain your answer in one or two sentences. Do not consider the need for construction shafts in general and launch or retrieval shafts. Unless otherwise indicated soil or rock described is for the entire tunnel alignment and profile. Your answer will be one or more of the following: 1. Cut-and...
A 10 ft wall retains soil with a horizontal surface that has 115 pcf unit weight,...
A 10 ft wall retains soil with a horizontal surface that has 115 pcf unit weight, a friction angle of 26 degrees, and an effective cohesion c’= 50 psf. The water table is at 5ft depth. Assuming Rankine active lateral earth pressures and hydrostatic conditions, what is the total horizontal thrust that the wall feels
Q1. Complete the following table, provided for a sandy soil (Gs =2.65). Accordingly, find the dry...
Q1. Complete the following table, provided for a sandy soil (Gs =2.65). Accordingly, find the dry unit weigh of this soil. Mass (t) Vol. (m3) Air 13.46 Water 13.25 Solids 50.00 Total Q2. A soil specimen has a moisture content of 21%, a void ratio of 0.6, and a specific gravity of 2.7. Determine the bulk unit weight of this soil. Q3. If we are dealing with a very soft clay soil in the site, which field test equipment will...
1. The following resting data were collected from three different sports teams (hockey, rugby and football)....
1. The following resting data were collected from three different sports teams (hockey, rugby and football). Ignoring the sport played, run a Kolmogorov–Smirnov test on the age variable. What is the correct expression for the result? ID Sport Age (y) Body mass (kg) Stature (m) Resting heart rate (bpm) Resting systolic blood pressure (mmHg) Resting diastolic blood pressure (mmHg) Resting mean arterial pressure (mmHg) 1 Hockey 18 79 1.83 65 121 79 93 2 Hockey 20 79.9 1.78 50 127...
16. The following resting data were collected from three different sports teams (hockey, rugby and football)....
16. The following resting data were collected from three different sports teams (hockey, rugby and football). Ignoring the sport played, run a Kolmogorov–Smirnov test on the age variable. What is the correct expression for the result? ID Sport Age (y) Body mass (kg) Stature (m) Resting heart rate (bpm) Resting systolic blood pressure (mmHg) Resting diastolic blood pressure (mmHg) Resting mean arterial pressure (mmHg) 1 Hockey 18 79 1.83 65 121 79 93 2 Hockey 20 79.9 1.78 50 127...