Question

From the following suspended solids laboratory data, the percent volatile suspended solids is: Laboratory Data: Initial...

From the following suspended solids laboratory data, the percent volatile suspended solids is: Laboratory Data: Initial weight of ignited crucible = 56 g, Volume of sample filtered = 40 mL ,Weight of crucible and sample after drying (103◦C) = 56.289 g, Weight of crucible and sample after ignition (550◦C) = 56.172 g

Homework Answers

Answer #1

Volatile suspended solids percentage.

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
Data taken on solids contents of a water sample are given below. All sample were 500...
Data taken on solids contents of a water sample are given below. All sample were 500 mL aliquots Residue in evaporating disk after 4 h at 105 °C = 50 mg Residue in evaporating disk after 4h at 550 °C = 30 mg Residue on filter after drying at 105 °C = 10 mg Net ash content (tare subtracted) after drying residue at 550 °C = 5 mg Determine the concentrations of total solids, total volatile solids, volatile dissolved solids...
Introduction to environmental (4-1, DC 332) Glutamic acid (C5H9O4N) is used as one of the reagents...
Introduction to environmental (4-1, DC 332) Glutamic acid (C5H9O4N) is used as one of the reagents for a standard to check the BOD test. Determine the theoretical oxygen demand of 150 mg/L of glutamic acid. Assume the following reactions apply: C5H9O4N + 4.5O2 →5CO2 + 3H2O + NH3 NH3 + 2O2 → NO3- + H+ + H2O (4-3, DC 332) If the BOD5 of a waste is 220 mg/L and the ultimate BOD is 320 mg/L, what is the rate...
7. The following data is obtained from soil laboratory. Calculate three (3) soil parameters related to...
7. The following data is obtained from soil laboratory. Calculate three (3) soil parameters related to peat soil analysis. Mass of empty crucible=23.45 g; Mass of crucible + peat=34.36 g; Mass of crucible+ peat (oven dried at 105˚C) =25.87 g; Mass of crucible + peat (fired in muffle furnace at 450˚C)=25.26 g 1) Moisture content 2) Ash Content 3) Organic content
Calculate the weight percent of ascorbic acid in a tablet of Vitamin C from the following...
Calculate the weight percent of ascorbic acid in a tablet of Vitamin C from the following data: A 100 mg sample of a crushed Vitamin C tablet was dissolved in 40 mL of H2SO4 and 20 mL of water. Two grams of KI and 20. mL of 0.0138 M KIO3 solution was added, and the mixture titrated to a starch endpoint. The titration required 9.0 mL of 0.0750 M thiosulfate solution. Weight =
Pre-Laboratory Assignment for Equivalent Weight of a Metal 1) You are asked to make 133 mL...
Pre-Laboratory Assignment for Equivalent Weight of a Metal 1) You are asked to make 133 mL of 1.294 M HCl starting with 6.0 M HCl. a) The volume of 6.0 M HCl needed is (to 0.1 mL) ______________ mL 2) You standardize the "1.294 M" HCl by pipetting a known amount of it into a flask and titrating to the phenolphthalein endpoint with an NaOH solution of known concentration Experimental Data: Volume of "1.294 M" HCl used 4.32 mL Concentration...
The following data were obtained from Bart: 24-hour Urine Sample Total volume                             &nbs
The following data were obtained from Bart: 24-hour Urine Sample Total volume                                    1440 mL Sodium concentration                      120 mEq/L Potassium concentration                  100 mEq/L Creatinine concentration                  200 mg/100 mL GFR 200 mL/min Urea concentration                           2050 mg/100 mL Plasma Sample taken at the mid-point during the Urine collection Sodium concentration                      140 mEq/L Potassium concentration                  5 mEq/L Creatinine concentration                  1 mg/100 mL Urea concentration                           25 mg/100 mL What fraction of Bart's filtered urea was filtered according to the above data? a) 0.2 b) 1.0...
The following data represent the weight of a child riding a bike and the rolling distance...
The following data represent the weight of a child riding a bike and the rolling distance achieved after going down a hill without pedaling. Weight (lbs.) Rolling Distance (m.) 59 26 83 43 97 49 56 20 103 65 87 44 88 48 91 42 52 39 63 33 71 39 100 49 89 55 103 53 99 42 74 33 75 30 89 30 102 40 103 33 99 33 102 35 86 37 85 37 Can it be...
Given the following data: Initial sample mass = 0.528 kg, Surface dry mass = 0.517 kg....
Given the following data: Initial sample mass = 0.528 kg, Surface dry mass = 0.517 kg. Oven dry mass = 0.48 kg What is the dry mass of the fine aggregates if the total sample weight is 40 kg? a. 35.364 kg b. 37.136 kg c. 36.364 kg d. 30.264 kg
From the following data, determine the molar mass of a gaseous sample. Volume: 350 mL           Pressure:...
From the following data, determine the molar mass of a gaseous sample. Volume: 350 mL           Pressure: 756.8 Torr              t: 23.5 °C      w = 30 grams
Calculate the specific heat of a metal from the following experimental data. 75.0 ml cold water...
Calculate the specific heat of a metal from the following experimental data. 75.0 ml cold water is taken in a calorimeter. The initial temp of the water in the calorimeter is 21.2 degrees C. To the calorimeter containing cold water 29.458 g metal at 98.9 degrees C is added. The final temperature of the contents of the calorimeter is measured to be 29.5 degreesC. (Given: density of water= 1.00 g/ml, specific heat of water= 4.184 J. G. -1 degrees C...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT