Question

Magnesium chloride, MgCl2, is supplied as a 50-mL vials with a concentration of 20% (w/v). Calculate...

Magnesium chloride, MgCl2, is supplied as a 50-mL vials with a concentration of 20% (w/v). Calculate the total number of millimoles of magnesium chloride in one vial. Round the final answer to the hundredths place. 1 Calculate the total number of mEq of magnesium chloride in one vial. Round the final answer to the hundredths place. 2 Calculate the total number of milli-osmols of magnesium chloride in one vial. Round the final answer to the hundredths place.

1-

2-

3-

Homework Answers

Answer #1

Given, MgCl2, is supplied as a 50-mL vials, concentration of 20% (w/v)

20% means 20 g per 100 mL

So, 50 mL contains 10 g

1) Number of millimoles calculation

Molecular weight of MgCl2 is 95.211 g/mol

Number of moles = 10/95.211= 0.105029

Number of miliimoles = 105.03 mmol

2) Number of mEquivalents

mEq = mmol x valency

Here, valency of Mg is 2

mEq = 2 x 105.03 = 210.06 mEq

3) Number of milliosmols

Milliosmols = Total number of dissoiciable particle x millimoles

mOsmols = 3 x 105.03 = 315.09 mOsmol

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
Calculate the molarity of a solution of magnesium chloride with a concentration of 44.7 mg/mL.    ...
Calculate the molarity of a solution of magnesium chloride with a concentration of 44.7 mg/mL.     a.    0.939 M     b.    0.469 M     c.    0.235 M     d.    2.13 M     e.    0.748 M I know the answer is b, but please show me the work and label the units so I can understand :)
1. If 480 mL of a 30% w/v solution were diluted to 2.5 liters, what would...
1. If 480 mL of a 30% w/v solution were diluted to 2.5 liters, what would be the percentage strength (w/v)? Express units only as %. (Round to tenths) 2. If 3 tablepoonsful of povidone iodine solution (6.0 % w/v) were diluted to 1.50 pint with purified water, what would be the ratio strength (w/v, which is what the units are for this problem) of the dilution [expressed as 1:____ rounded to the nearest whole number and without putting the...
pipette 50 ml of the approximately 0.004 M potassium permanganate solution to a 250 ml conical...
pipette 50 ml of the approximately 0.004 M potassium permanganate solution to a 250 ml conical flask. Note that this time the permanganate is added to the contents of the flask by pipette rather than from the burette - the principle being that it is present in excess so that the pink colour shou ld remain strongly after the nitrite addition . Using a measuring cylinder , add 25 ml of 2 M sulphuric acid. Pipette 25 ml of the...
Q. When a pink aqueous solution of potassium permanganate, faintly acidified with dilute sulfuric acid was...
Q. When a pink aqueous solution of potassium permanganate, faintly acidified with dilute sulfuric acid was treated with 10% aq. hydrogen peroxide, the reaction took place with the evolution of gas bubbles, and the pink solution was turned colorless. Further chemical analysis revealed that the evolved gas was oxygen, and the resulting solution contains potassium sulfate and manganese (II) sulfate; water was also formed during the same reaction. Please answer the followings: 1) Write down the balanced chemical equation for...
Note: In this chapter and in all succeeding work throughout the course, unless instructed otherwise, calculate...
Note: In this chapter and in all succeeding work throughout the course, unless instructed otherwise, calculate hourly rates and overtime rates as follows: 1. Carry the hourly rate and the overtime rate to 3 decimal places and then round off to 2 decimal places (round the hourly rate to 2 decimal places before multiplying by one and one-half to determine the over-time rate). 2. If the third decimal place is 5 or more, round to the next higher cent. 3....
1) Describe an example of each of the following that may be found of your kitchen:...
1) Describe an example of each of the following that may be found of your kitchen: Explain how your choice falls into this category, and if there is a chemical name or symbol for it, provide that as well. Provide a photo of your example with your ID card in it. a) a compound b) a heterogeneous mixture c) an element (symbol) Moving to the Caves… Lechuguilla Caves specifically. Check out this picture of crystals of gypsum left behind in...
Below is the background info for the lab assignment. The 4 blank boxes are the questions...
Below is the background info for the lab assignment. The 4 blank boxes are the questions I would like answers too. The end point for the fine titration was 35.90 mL in the burette when the solution turned bright green again. And the coarse titration I got 35.36mL as the end point. 35.9 mL is exact in case you need that info. Thanks! Background In this lab, we will determine the amount of alcohol (ethanol), C2H5OH, in a commercial vodka...
do all five questions Question 1 20 pts Ignoring the effects of air resistance, if a...
do all five questions Question 1 20 pts Ignoring the effects of air resistance, if a ball falls freely toward the ground, its total mechanical energy Group of answer choices increases remains the same not enough information decreases Flag this Question Question 2 20 pts A child jumps off a wall from an initial height of 16.4 m and lands on a trampoline. Before the child springs back up into the air the trampoline compresses 1.8 meters. The spring constant...
Chemical Reactions Types and Their Equations Making Heat with Chemical Reactions Have you ever wondered how...
Chemical Reactions Types and Their Equations Making Heat with Chemical Reactions Have you ever wondered how an instant heat pack works? A disposable heat pack works by a chemical reaction that combines iron in the package with oxygen from the air when the outer packaging is removed producing iron oxide. You have probably seen the product of this reaction in what is commonly called rust. The reaction releases heat, which allows the pack to reach a sufficient temperature that is...
I have provided the information for the lab below. I want to see the chemical reactions...
I have provided the information for the lab below. I want to see the chemical reactions that take place during each step of the experiment. So in the procedures when a chemical was added i would like to see what the products and byproducts that were formed. I also want to see one over all reaction for this experiment to just get an overview of what exactly is happening during the experiment. Thank you:) Part B: Synthesis of [Co(NH3)5Cl]Cl2 Objective:...