Question

A technician tested the protein concentration of a tube to be 5 mg/mL. This tube was...

A technician tested the protein concentration of a tube to be 5 mg/mL. This tube was the third tube of a two-fold serial dilution. What was the concentration of the original tube?

Homework Answers

Answer #1

the concentration of protein is halved in the successive test tubes, so, the concentration should be double the amount in the previous test tubes so as to satisfy the 2 fold serial dilutions.

Hope you'll understand the concept. Please like. Thankyou

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
If you performed a five-fold serial dilution, what is the concentration of the third tube? Assume...
If you performed a five-fold serial dilution, what is the concentration of the third tube? Assume the first tube has 2 g/mL concentration.
You start with a solution that is 60 mg/ml of protein and perform a series of...
You start with a solution that is 60 mg/ml of protein and perform a series of serial dilutions on it. Please fill in the table below with the appropriate concentrations at each dilution. Concentration (mg/ml) Absorbance 1 60 .750 2 .340 3 .180 4 .08 5 .02 You have a mystery solution that has an absorbance of .250. Using the table, give an approximation or a range of concentrations that could be that or those of the mystery solution. Justify...
You isolate a subcellular fraction and find the protein concentration to be 40 mg/mL. a) Show...
You isolate a subcellular fraction and find the protein concentration to be 40 mg/mL. a) Show all calculations and explain how you would prepare 50 µL of a 4 mg/mL final concentration after dilution in 2X sample buffer. (Final concentration after mixing with 2X sample should be 4 mg/mL). b) You are asked to load 20 µg total proteins into a well in the polyacrylamide gel. How many microlitres of the sample prepared above should you load onto the gel?
You are given a culture of bacterial cells of unknown concentration. You are asked to determine...
You are given a culture of bacterial cells of unknown concentration. You are asked to determine the concentration (cells/mL). You make three serial dilutions of 100-fold and a final 10-fold dilution of the sample. After plating 1 mL of this culture dilution on a growth plate, you generate 42 bacterial colonies (each colony represents a single bacterial cell that was on the plate). What was the concentration of the original bacterial cell culture?
You have 5 ml of 3 mg/ml protein soluti on. (This solution is valuable so you...
You have 5 ml of 3 mg/ml protein soluti on. (This solution is valuable so you don’t want to waste it.) How w ould you make up at least 100 μ l of 0.1 mg/ml using a convenient dilution ( i.e . how much buffer and how much protein solution do you need to add, and is it possible to pipet the amount you need accurately )? Please explain and provide the correct answer.
I need to calculate the number of mg/ml that existed in the cuvette for all of...
I need to calculate the number of mg/ml that existed in the cuvette for all of these samples. Note that there were two dilution steps for most of these. For samples, 2, 3, 4, and 11, the protein was diluted with water when preparing 1 ml test tube samples. then for all six samples, the protein was again diluted when mixing with Biuret reagent. Calculate the overall dilutions for all 6 samples. Please show the calculation too, I can't figure...
You will prepare a serial dilution with 6 tubes. Into tube 1 you add 0.9 ml...
You will prepare a serial dilution with 6 tubes. Into tube 1 you add 0.9 ml NaCl and you add 0.5 ml NaCl into tubes 2-6. Next you add 0.1 ml of serum to tube 1 and mix and transfer 0.5 ml to tube 2. Continue making serial dilutions through tube 6 (discarding 0.5 ml from tube 6). Finally, you add 0.5 ml of sheep RBCs to EACH tube (1-6) What is the final dilution in each tube after the...
The concentration of an undiluted sample is 26.4 mg/ml. To calculate that answer, the concentration of...
The concentration of an undiluted sample is 26.4 mg/ml. To calculate that answer, the concentration of the diluted sample was multiplied by the dilution factor. Knowing that the dilution factor is 2, work backwards to determine the concentration of the DILUTED sample. A. 13.2 mg/ml B. 132.0 mg/ml C. 1.32 mg/ml D. 26.4 mg/ml What is the unit used to describe cell solutions measured in a spectrophotometer? Cells/milliliter Grams (g) Optical density (OD) Meters (m) Spectroscopy is based on the...
Illustrate how you would make four serial 3-fold dilution such that each tube has a volume...
Illustrate how you would make four serial 3-fold dilution such that each tube has a volume of 12mL. There shouldbe at least 6 mL in each tube following the preparation of all diluions because that is a minimal requirement for this particular experimental setup?
1)You are given a protein solution with a concentration of 0.15 mg/ml. We need 10 µg...
1)You are given a protein solution with a concentration of 0.15 mg/ml. We need 10 µg for an experiment. What volume of the protein solution do we need? My answer: Convert 0.15 mg/ml to μg/ μl and you will get 150 μg/ μl. C = M/V rearrange for Volume V= M/C , V= (10 μg)/(150 μg/ μl) = 0.06667 μg/ μl 2) Suppose we want to prepare a solution containing 100 µg of the protein at a concentration of 1...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT