Question

Calculation the maximum stress induced in a cast iron pipe of external diameter 40 mm internal...

Calculation the maximum stress induced in a cast iron pipe of external diameter 40 mm internal diameter 20 mm and length 4 m when the pipe is supported at is ends, carries a point load of 80 N at is center

Homework Answers

Answer #1

ANSWER :

THE ANSWER IS SHOWN IN BELOW HAND WRITTEN NOTES:

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
A 250 mm diameter of cast iron pipe flows 39.3 L/s of SAE 10 oil along...
A 250 mm diameter of cast iron pipe flows 39.3 L/s of SAE 10 oil along 500 m length. Given: dynamic viscosity, μ and density, ρ of SAE 10 oil are 1.04 x 10-1 Ns/m2 and 917 kg/m3 respectively. By assuming the flow is laminar, determine energy head and pressure loss due to pipe friction using Hagen-Poiseuille equation and friction factor, f.
Water flow horizontally for 4 m through a 65mm diameter cast iron pipe at an average...
Water flow horizontally for 4 m through a 65mm diameter cast iron pipe at an average velocity of 2 ms-1before an 90 degree elbow changes the direction of the flow downwards for a further 9 m. A ball valve is fitted at the end of the 9 m length of pipe. Determine the pressure at the pipe inlet if the ball valve is fully opend.(density of water = 998 kgm-3 , u=8.9*10^-4 Pas) I just calculated the friction losses before...
10. A cast iron wheel of mean diameter 3 metre has six arms of elliptical section....
10. A cast iron wheel of mean diameter 3 metre has six arms of elliptical section. The energy to be stored in it is 560 kN-m when rotating at 120 r.p.m. The speed of the mean diameter is 18 m/s. Calculate the following: (a)Assuming that the whole energy is stored in the rim, find the cross-section, if the width is 300 mm. (b)Find the cross-section of the arms near the boss on the assumption that their resistance to bending is...
A helical compression spring is made from music wire that is 1.04 mm in diameter and...
A helical compression spring is made from music wire that is 1.04 mm in diameter and has an outer coil diameter of 13.74 mm with a free length of 50.8 mm and 10 total coils with plain ends. What is the solid length Ls? What is the spring rate k in N/m ? If the spring rate is 1000 N/m what is the maximum shear stress, tau , in the wire when the spring is compressed 25.4 mm from its...
*** Please answer ALL three questions including question 1, question 2 that also comes with part...
*** Please answer ALL three questions including question 1, question 2 that also comes with part A and B, and finally question 3. *** 1) A car rides on four wheels that are connected to the body of the car by spring assemblies that let the wheels move up and down over bumps and dips in the road. When an 80 kg person sits on the left front fender of a small car, this corner of the car dips by...
A grey body is one whose absorptivity 1. does not vary with temperature and wavelength of...
A grey body is one whose absorptivity 1. does not vary with temperature and wavelength of the incident ray 2. is equal to its emissivity 3. varies with temperature 4. varies with wavelength of the incident ray A liquid is in equilibrium with its vapor at its boiling point. On an average, the molecules in the liquid and gaseous phases have equal 1. potential energy. 2. kinetic energy. 3.temperature. 4. intermolecular forces of attraction. A liquid of density 1000 kg/m3...
Two boxes are stacked, with box B placed on top of box A. If box A...
Two boxes are stacked, with box B placed on top of box A. If box A is pushed such that both boxes move with a decreasing speed, is there any friction on either box? (a) Kinetic friction on box A and no friction on box B (b) Kinetic friction on box A and static friction on box B (c) Kinetic friction on box A and kinetic friction on box B (d) Static friction on box A and kinetic friction on...
What tools could AA leaders have used to increase their awareness of internal and external issues?...
What tools could AA leaders have used to increase their awareness of internal and external issues? ???ALASKA AIRLINES: NAVIGATING CHANGE In the autumn of 2007, Alaska Airlines executives adjourned at the end of a long and stressful day in the midst of a multi-day strategic planning session. Most headed outside to relax, unwind and enjoy a bonfire on the shore of Semiahmoo Spit, outside the meeting venue in Blaine, a seaport town in northwest Washington state. Meanwhile, several members of...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT