Question

you pour too much 0.1 m NH3/H20 solution into test tube #1 & #2, leaving only...

you pour too much 0.1 m NH3/H20 solution into test tube #1 & #2, leaving only 1 mg of the solution in test tube #3. you add phenolphtalein indicator solution as directed.

Science   Chemistry   
0 0
Add a commentTranscribed image text
Next >

Homework Answers

Answer #1

0 0
Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Log In

Sign Up

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
Assume that you have a solution of 0.1 M glucose 6-phosphate. To this solution, you add...
Assume that you have a solution of 0.1 M glucose 6-phosphate. To this solution, you add the enzyme phosphoglucomutase, which catalyzes the following reaction: Glucose 6-phosphate ? glucose 1-phosphate The ?G
Aspirin Determination using Back Titration Began with 0.1 M HCl solution and 0.1 M NaOH solution....
Aspirin Determination using Back Titration Began with 0.1 M HCl solution and 0.1 M NaOH solution. 1:2 aspirin to NaOH mole ratio, therefore, mol HCl (back titration) = excess mol NaOH AND total mol NaOH used - excess mol NaOH=required mol NaOH AND required mol NaOH (1 mol aspirin / 2 mol NaOH) = mol aspirin. Each step builds off the last 1) Determination of HCl Concentration. This was the first titration. Concentrated HCl was diluted to .1M before titrating....
What is the mole fraction of NH3 in a 10.0 m aqueous solution of NH3? (1)...
What is the mole fraction of NH3 in a 10.0 m aqueous solution of NH3? (1) 0.02          (2) 0.15             (3) 0.18             (4) 0.82              (5) 0.85
1) We start with 1.00 mL of normal saline in each one of five test tubes,...
1) We start with 1.00 mL of normal saline in each one of five test tubes, labeled as 1, 2, ..., 5... 2. We start with 1.00 mL of normal saline in each one of five test tubes, labeled as 1, 2, ..., 5. We add 250 µL of 312.5 mg/mL tetracycline into test tube 1, mix the content well, then remove 250 µL of the solution from test tube 1 to test tube 2, and repeat the procedure until...
1. How much glucose is needed to make 0.2 liter of a 0.1 molar solution? MW...
1. How much glucose is needed to make 0.2 liter of a 0.1 molar solution? MW of glucose is 180 g/mol A. 0.1 g of glucose B. 0.1 mol of glucose C. 100 mM of glucose D. 1000 mg of glucose 2. What is the tonicity of a solution containing 75 mM glucose and 50 mM CaCl2? A. 225 mOsm B. Hypertonic; cells will shrink C. Hypotonic; cells will swell D. Isotonic; cells will not change 3. What is the...
1. Imagine you have a saturated solution of Ca(OH)2, at equilibrium, that has some undissolved Ca(OH)2...
1. Imagine you have a saturated solution of Ca(OH)2, at equilibrium, that has some undissolved Ca(OH)2 solid on the bottom of the test tube. If you add an additional scope of Ca(OH)2 to this solution will the concentration of [OH-] in the solution increase, decrease, of be unchanged? (Briefly explain and assume we let the solution reach equilibrium again) 2. Imagine you have a saturated solution of Ca(OH)2, at equilibrium, that has some undissolved Ca(OH)2 solid on the bottom of...
If you were preparing a series of two 10% dilutions of pretend 1M HCl. You would...
If you were preparing a series of two 10% dilutions of pretend 1M HCl. You would have 3 test tubes labeled, 1, 2 and 3. Test tube 1 would be filled with 10 mL of the 1 M HCL. Always Add Acid to Water. This rule must be followed in order to prevent splattering of the acid. Use the formula to determine how much water should be added to test tube #2 to prepare a 10% dilution. The final desired...
Experiment 1: Observe the Reactions Between Halide and Calcium Ions Take four test tubes from the...
Experiment 1: Observe the Reactions Between Halide and Calcium Ions Take four test tubes from the Containers shelf and place them on the workbench. Fill each test tube with a different halide solution from the Materials shelf, as directed below. You may want to label the test tubes by double-clicking on each test tube and renaming it. Test Tube # Halide Solution 1 10.5 mL 0.1 M sodium chloride 2 10.5 mL 0.1 M sodium fluoride 3 10.5 mL 0.1...
Chemical Equilibrium: Le Chatelier’s Principle. 1. Add 0.5 mL of 0.1 M FeCl3(aq) to 0.5 mL...
Chemical Equilibrium: Le Chatelier’s Principle. 1. Add 0.5 mL of 0.1 M FeCl3(aq) to 0.5 mL of 0.1 M KSCN(aq), and then add 15 mL of distilled water. To a 2-mL portion of this mixture, add 1 mL of 0.1 M KSCN(aq). Observe any difference in the color from the original solution and explain your observations. Because you are combining equal volumes of equal concentrations, and because they combine in a 1 to 6 mole ratio, Fe3+(aq) should be in...
Calculate the Kf for the following reaction. 1) Ag+ (20 mL of aqueous 0.02 M solution...
Calculate the Kf for the following reaction. 1) Ag+ (20 mL of aqueous 0.02 M solution as the nitrate salt). 2) Na2CO3 (1 mL of aqueous 1 M solution). Once the precipitate is formed, add NH3 (1 mL of aqueous 3 M solution) to form the complex ion Ag(NH3)2 +
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT