Question

if a student left the lid off the calorimeter after adding the warm metal, would the...

if a student left the lid off the calorimeter after adding the warm metal, would the calculated value of SH for the unknown be higher, lower, or the same as it would be if the lid was on the calorimeter? Explain your answer.

Homework Answers

Answer #1

The calculated value without lid would have lower value...

This happens because without lid whatever the water vapour generated during combustion will escape into the atmosphere hence no condensation takes place therefore no latent heat of condensation.Thats why some amount of energy will be skipped from the calorimeter whereas when the lid is there the water vapour liberated lie within the calorimeter and furthur undergoes condensation liberating some amount of energy in the form of latent heat of condensation which is added to the total amount of heat energy liberated by the warm metal..

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
While transfering the piece of unknown metal to the calorimeter, the student drops the metal into...
While transfering the piece of unknown metal to the calorimeter, the student drops the metal into the calorimeter roughly, and some water splashes out of the calorimeter. why must this be avoided? Be specific- how would the loss of water from the calorimeter affect the calculated value of specific heat of the metal?
1. While performing the formula of hydrate laboratory experiment, the lid accidently slips over the crucible...
1. While performing the formula of hydrate laboratory experiment, the lid accidently slips over the crucible to completely seal the crucible. a. What effect this change will cause on your calculated experimental results? Explain. b. Would your calculated percent water of hydration be high, low or unaffected? Explain your anwer. 2. A student was asked to identify a sample of unknown hydrate. Student was provided with the following experimental data. [ 3.51g sample of the hydrate when heated loses water...
A student was given only one graduated cylinder to use for this experiment. After using it...
A student was given only one graduated cylinder to use for this experiment. After using it to measure 50.0 mL of the assigned acid, the student failed to rinse or dry the cylinder before measuring out the 50.5 mL of the base. would the calculated change in Heat Neutralization be higher, lower, or the same as the literature for change in heat neutralization. Briefly explain this difference as a result of using only one graduated cylinder for the experiment.
Chemistry 1215, Experiment #11; Determination of the Atomic Weight of an Unknown Metal, Pre-lab Name ____________________________________...
Chemistry 1215, Experiment #11; Determination of the Atomic Weight of an Unknown Metal, Pre-lab Name ____________________________________ 1. Based on equation 2 in the introduction, to what group in the periodic table does the unknown metal probably belong? Explain your rationale. 2. Explain why it is necessary to consider water vapor pressure in calculating the atomic mass of the unknown metal. Would the calculated atomic mass be larger or smaller than the true value if water vapor pressure is ignored? 3....
A student collected the following data to determine the specific heat of a metal sample.  50.0 g...
A student collected the following data to determine the specific heat of a metal sample.  50.0 g of metal were transferred from boiling water into a calorimeter containing 100 g of H2O at 22.3oC.  The temperature of the water rose to 23.5oC.  Calculate the specific heat of the metal. Enter your answer with 3 significant figures. Based on the calculated specific heat, what is the most likely identity of the metal in the previous problem? Give your answer as the elemental symbol (e.g....
5. Compare the definition of a weak acid to the definition of a strong acid to...
5. Compare the definition of a weak acid to the definition of a strong acid to explain why the reaction of acetic acid(HC2H3O2) (a weak acid)) with NaoH(a strong base) is less exothermic than the reaction between HCl(a strong acid) and NaoH. 6. A student carries out a calorimetry experiment using HCI and NaoH. What effect will each of the following have on the calculated enthalpy of the reaction relative to the actual enthalpy of reaction? (larger, smaller or no...
Imagine you had prepared a 0.1 M sodium sulfate solution. Would you expect it to have...
Imagine you had prepared a 0.1 M sodium sulfate solution. Would you expect it to have a conductivity value that was the same, higher than or lower than the 0.1 M sodium chloride solution? Explain your answer.
(Evaluating the Equilibrium Constant for the Reaction of Iron(III)Ion with Thiocyanate Ion) 1. When measuring the...
(Evaluating the Equilibrium Constant for the Reaction of Iron(III)Ion with Thiocyanate Ion) 1. When measuring the volumes of Fe(NO3)3 and NaSCN solutions in this experiment, the student mistakenly used a graduated cylinder instead of volumtetric pipets, After collecting all of the data, the student realized he'd used the wrong piece of equipment, but he didn't redo the experiment. Also, he later realized that he had consistenly misread the graduated cylinder and had thus transferred volumes that were actually 5% lower...
Discussion. Explain whether each of the errors below would cause your calculated Ksp value to be...
Discussion. Explain whether each of the errors below would cause your calculated Ksp value to be higher or lower than the tabulated value. Assume you are using method 1 to calculate Ksp. It is also possible that the error would have no effect on the measured Ksp value (so it really wouldn’t be an error). (1 point each) 1. The calcium hydroxide solution was prepared at the last minute. Adequate time was not given for equilibrium to be reached between...
8. a) Let’s say one galaxy is 4 Mpc away from us and another is 16...
8. a) Let’s say one galaxy is 4 Mpc away from us and another is 16 Mpc away. If the nearer one moves 1 Mpc, how far will the more distant galaxy move in the same amount of time? b) How far away will each of the galaxies in part A be after that amount of time has passed? 9. How would a higher value for the Hubble constant affect the calculation of the age of the universe? A lower...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT