JustAAA
Home
Questions
Share
Post a Question (with Answer)
Coins
Ask a Question
Log In
Sign Up
Home
/
Civil-Engineering Questions
Search
Civil-Engineering Questions
The ellipsoid is a: (a) Gravimetric model of Earth (b) Mathematical model of Earth (c) Projection...
Imagine now that an electrofishing team had arrived just after the first pass and both teams...
Shaer forces are acting in parallel to stirrups; How stirrups resist these parallel forces?
a)Discuss Darcy Weisbach equation for loss of head due to friction in a pipe line b)Discuss...
285 kg of wet sand with a water content of 18% was taken and dried in...
what's the difference between USGS regression method and results from stream stats? why they are different?...
Can “the Poisson Ratio” be “0.55” for a material? a) If the answer is “YES”, explain...
71. On a low-voltage luminaire rated 30 volts or less, the output circuit of the power...
A 500mm width square tied column with reinforcement on four faceshas a gross steel ratio is...
A company produces a certain product and has the capacity to produce 100 units per month...
A vertical summit parabolic curve has vertical offset of 0.375 m. from the curve to the...
What is the difference between shear and moment?
What is ‘Glulam’ and are the laminations normally vertical or horizontal?
What action can be implemented to reduce excessive coagulant doses for low-turbidity waters? (A) add alkalinity...
Write a report that shows how you assemble sUAS (small Unmanned Aircraft System) and flight controllers....
Purpose: To have you draft a professional resume. Outcome: Demonstrate job search readiness by preparing an...
If the surface grade is lowered, what is the results in the subsurface stresses?
minor losses for a contraction of a 6 in pipe flowing into a connecting 4 in...
You are an analyst for an environmental protection agency. A company has applied for a permit...
The 12.3km Atta Mills road connecting Old Barrier to Kokrobite operates with a capacity of 2200...
Given fy = 60000 psi f'c = 5000 psi in a singly reinforced concrete beam. a)...
Plastic analysis is defined as the analysis in which the criterion for the design of structures...
( thermal desalination ) list the reasons why if we increas the number of effect in...
You borrowed an X amount of money from a local bank to be repaid over Nmonths...
A simply supported beam, 3m long, 50mm wide by 100mm deep, carries a uniformly distributed of...
Solve for the RESULTANT of the following concurrent forces. Round off your answer to two (2)...
the Plasticity topic Discuss the basic concept of failure theories, yield criteria, the application of those...
A circular aluminum [a = 23.0 × 10−6 /°C] ring is to be mounted on a...
Q/ 1000 Liter of UST containing carbon tetrachloride, which has a water solubility of 911 mg...
In a reversible process the rate of heat transfer to the system by increase unit temperature...
Define the 3 sources of error in an observation. Provide an example of each not found...
1. Future traffic estimates are never used in MUTCD Signal warrant analyses. 2. The three primary...
A glass container with pervious bottom containing fine sand in loose state (void ratio = 0.8)...
Using the AlSC Simplified method of part 6 of the Manual for a 10-ft (W10x15) is...
the laboratory test data for a standard compaction test are given in the table below. draw...
(10 pts) A 10 m3 rigid storage tank contains oxygen gas (R = 0.2598 kJ/kg.K, cp...
Three 11 mm diameter steel bolts in triangular formation were used by Mr. Lou to attach...
a. Equipment play important role in construction project. Appraise five equipment uses for compaction in civil...
Explain shortly the purposes for the need of using special concretes instead of convetional concrete.
A pipe of (130 liters/sec) was supplied from a canal and (100 liters/sec) were delivered to...
What are the advantages and disadvantages of high strength concrete? (30%)
1-What fluid properties tend to affect surface tension among fluids and why? 2. Interestingly, soap solution...
The environmentalist has to evaluate the solids content of the industrially processed water to determine the...
Design a T Beam for s floor system. Thickness of slab is 75 mm and width...
Problem 1: A round bar with a diameter of 32 mm, and 4012 mm in length...
A (65 KN) wheel load is placed on a Portland cement concrete slab that is (0.240...
An article in the ASCE Journal of Energy Engineering (1999, Vol. 125, pp. 59–75) describes a...
9) An existing rural freeway in level terrain is to be analyzed to determine LOS using...
You have been asked to determine the impacts of the Crafty Moon Possum brewery in North...
The average temperatures (°F) for an 8-day period are: 32,35,34,36,48,43,42, and 40. If the area has...
An area of spatial proximity around a point refers to which GIS operation? a. Spatial join...
A half-cylindrical (semi-circle cross section) solid object (specific gravity=1.5) is horizontally submerged along its diameter and...
A 300 mm diameter well was penetrated in an oceanic island. The depth of the fresh...
4. A group of researchers is testing a kerosene heater for NO emissions. The experiments are...
The net stress increase due to a building at the middle of a 6 ft normally...
Total Stress and Effective Stress An embankment is to be constructed rapidly over a soft clay...
If you have 100 acres of farmland that is relatively flat and needed a pipe for...
A column has fixed boundary conditions at the bottom ends for weak-axis buckling and pinned boundary...
How to determine the right structural steel section from the provided information? 1. Moment of inertia...
Determine the temperature and quality (if defined) for water at a pressure of 300kPa and at...
We have some meanings to estimate engineering parameters from SPT. However, we have not learned how...
A simple linear regression model is estimated for shopping-trip generation during a shopping-trip peak hour. The...
question: if you were walking up a hill that was inclined at a 45° angle, what...
Briefly describe the second law of thermodynamics.
Discuss possible implications of the second law of thermodynamics on the goal of energy neutrality during...
Phys 1002ID How many a wamer climate affect the jet streams and its activities?
A piece of equipment costs $35,000 and has a life of 5 years. This equipment is...
Define the three general types of solid brick. List the different grades, types, classes, and applications...
a) A well is pumped at an equilibrium flow of 454 gpm to determine a confined...
2. (a) A braced column which is 300 mm square is restrained such that it has...
Q. a) Explain in detail various financial aspect of procuring construction equipment. b) Discuss Rimpull...
An industrial company has 500 employees in only one shift, they need to design the cafeteria...
Can I find the reaction forces by only analyzing the slope without taking in consideration the...
List the most significant advantages and disadvantages of rc structures.
A 70 m diameter tank will be filled with 9 m of water. The site consists...
An orifice is to be placed in the side of tank at such an elevation that...
In your own words but referencing Saint-Venant’s Principle, describe why we can assume the axial stress...
Please calculate the yearly NPV and IRR. We want positive present value in 3 years. You...
what is estimating spreadsheet?
Please explain this. Civil Engineering: Numerical Methods Explain briefly the reasons of using all 6 of...
‹
1
2
...
40
41
42
43
44
45
46
47
48
›
ADVERTISEMENT
Need Online Homework Help?
Get Answers For Free
Most questions answered within 1 hours.
Ask a Question
ADVERTISEMENT
Active Questions
The adjusted trial balance for Westerberg, Inc. as of 12/31/14 appears below. All of the accounts have...
asked 4 minutes ago
What is an electric current? How does it flow in a wire? How fast do the...
asked 13 minutes ago
1. Consider a system consisting of 4 processes and a single resource type R1 with 25...
asked 15 minutes ago
Derive the carry generation equations for a 6-bit Carry Look Ahead (CLA) adder in terms of...
asked 17 minutes ago
Identify three goods each for which your demand is (A) elastic or (B) inelastic. What accounts...
asked 21 minutes ago
make a programming problem in c++ that can be solve in 5 minutes give the problem...
asked 33 minutes ago
1. The following statement should determine if x is not greater than 20. Explain what is...
asked 39 minutes ago
Compare and contrast substantive law and procedural law. In your explanation, please provide examples of each.
asked 47 minutes ago
Six hollow cylinders having diameters d and heights H are filled with water. The cylinders all...
asked 48 minutes ago
Find the complexity of the algorithm using big O notation for each of the following tasks....
asked 51 minutes ago
Transform the following expressions into prefix and postfix: A + B - C (A + B)...
asked 1 hour ago
x overbarx1 equals= 116116 x overbarx2 equals= 133133 sigmaσ1 equals= 3535 sigmaσ2 equals= 3939 n1 equals=...
asked 1 hour ago