Question

In the design of a lithium battery pack for electric vehicles, 20 lithium cells are connected...

In the design of a lithium battery pack for electric vehicles, 20 lithium cells are connected in parallel to form a string, and 100 of these strings are connected in series. If each cell voltage is 3.5V and its energy 16 Wh, a) Calculate the output voltage (V) and energy (KWh) of the battery pack. b) If you integrate this battery on a vehicle that consumes 160Wh/mile, what will be the range of vehicles for each charge?

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
a 20 ohm resistor is connected to a battery of 12 v which is connected to...
a 20 ohm resistor is connected to a battery of 12 v which is connected to 0.1 f capacitor with a series 1 circuit - what time is necessary to charge the capacitor completely -what is energy in capacitor when it is charged -what is charged stored in fully charged capacitor - what is voltage in resistor when completely charged
Two parallel plates of 120 cm2 are connected to a battery that provides them with a...
Two parallel plates of 120 cm2 are connected to a battery that provides them with a voltage of 12 volts. The plates are separated by a 1.0 mm thick layer of air. If the space between the plates is filled with oil, with a dielectric constant it is 4 and a dielectric strength of 12x106 v / m; and then the battery stays connected: a) How much is the capacitance? b) How much is the voltage across the capacitor? Explain...
Two parallel-plate capacitors C1 and C2 are connected in series to a battery. Both capacitors have...
Two parallel-plate capacitors C1 and C2 are connected in series to a battery. Both capacitors have the same plate area of 3.40 cm2 and plate separation of 2.65 mm. However, the first capacitor C1 is filled with air, while the second capacitor C2 is filled with a dielectric that has a dielectric constant of 3.40. The total charge on the series arrangement is 13.8 pC. (a) What is the battery voltage? V (b) What is the potential difference across each...
16.3 Capacitance 57.     MC A capacitor is first connected to a 6.0-V battery and then disconnected and...
16.3 Capacitance 57.     MC A capacitor is first connected to a 6.0-V battery and then disconnected and connected to a 12.0-V battery. How does its capacitance change: (a) It increases, (b) it decreases, or (c) it stays the same?   58.     MC A capacitor is first connected to a 6.0-V battery and then disconnected and connected to a 12.0-V battery. How does the charge on one of its plates change: (a) It increases, (b) it decreases, or (c) it stays the same?   59.     MC...
Chapter 18, Problem 1 A 47- resistor and a 29- resistor are connected in series across...
Chapter 18, Problem 1 A 47- resistor and a 29- resistor are connected in series across a 24-V battery. What is the voltage across (a) the 47- resistor and (b) the 29- resistor? Chapter 18, Problem 2 The current in a 63- resistor is 0.077 A. This resistor is in series with a 42- resistor, and the series combination is connected across a battery. What is the battery voltage? Chapter 18, Problem 3 What resistance must be placed in parallel...
1. What is the capacity of the accumulator? * 2. In order to increase the capacity...
1. What is the capacity of the accumulator? * 2. In order to increase the capacity of our accumulator, each series cell has 3 additional cells wired in parallel to it; this results in our accumulator containing 576 cells wired in a 144S4P configuration.Each cell has a capacity of 2.5Ah. 3. How much energy (kilowatt.hours) does our accumulator have? * At competition, the energy usage of our electric vehicle is measured to calculate its efficiency over a 22km race. 4....