Question
Q.1: The dimension of a cylindrical storage tank is given as 12 m height and 6...
Q.1: The dimension of a cylindrical storage tank is given as 12 m height and 6 m diameter. It is filled by light diesel of density of the oil is o.98 g /cm3. Calculate:[12 Marks]
(i) the pressure exerted by the oil at the base of the tank if tank is filled up to 10m
(ii)total pressure by the oil at the base of the tank.
(iii) the force exerted by the oil at the base of the tank.
(iv)by using the answer of part (i) calculate the volume and mass of the oil in the tank.
Homework Answers
Answer #1
Not the answer you're looking for?
Similar Questions
A cylindrical underground storage tank with a diameter of 21 ft and a height of 25...
A cylindrical underground storage tank with a diameter of 21 ft
and a height of 25 ft is filled with gasoline. Assuming the density
of gasoline is 675 kg/m3, answer the following questions. Determine
the mass of the gas in the tank in both lbm and kg
A cylindrical tank is full of oil, and has a height of 30 m and a...
A
cylindrical tank is full of oil, and has a height of 30 m and a
diameter of 80 m. If the oil has a density of 52 lb / ft ^ 3, a-
what is the volume of the tank (expressed in [m ^ 3])? b- What is
the total mass of the oil (expressed in [kg]) contained in the
tank?
An isopentane storage tank has a cylindrical geometry with 2 m in diameter and 4 m...
An isopentane storage tank has a cylindrical geometry with 2 m
in diameter and 4 m in height. The tank is initially found with a
liquid level of 0.5 m above the base of the tank. This tank is
removed 100 L / s of isopentane as a discharge that is sent to a
later process. At a given moment, a recharge of 300 L / s of
isopentane is initiated to the tank to recover the level of the...
A storage tank has a Diameter of 6 m and a height of 3 m. The...
A storage tank has a Diameter of 6 m and a height of 3 m. The
output volumetric flow from this tank is given by fout(t)=2h(t)
where h(t) is the height of the liquid in the tank. At a particular
time the tank is at steady state with an input flow of 275 L/min
.
1) develope the mathematical model describing this
process.Define all variables and give initial conditions where
appropriate. Clearly state all assumptions that you used to
develope...
A storage tank, open at the top, has a diameter 2.3 m and a height 1.8...
A storage tank, open at the top, has a diameter 2.3 m and a
height 1.8 m . During a storm, the tank catches rain at the rate of
16.9 cm3/s. Simultaneously, water leaks out from the
bottom of the tank through a hole that has a cross-sectional area
A = 0.051 cm2.
During a long rain storm, what is the maximum depth of water in
the tank?
Give your answer in units of m.
PLEASE SHOW ALL STEPS
(a) A large, open at the top, upright cylindrical tank contains fuel oil with a density...
(a) A large, open at the top, upright cylindrical tank contains
fuel oil with a density of 0.890 ✕ 103 kg/m3.
If the air pressure is 101.3 kPa, determine the absolute pressure
(in Pa) in the fluid at a depth of 22.5 m. ____ pa
(b)Determine the force (in N) exerted by only the fluid on the
window of an instrument probe at this depth if the window is
circular and has a diameter of 3.70 cm.
N
A conical tank of diameter 6 m and height 10 m is filled with water. Compute...
A conical tank of diameter 6 m and height 10 m is filled with
water. Compute for the work needed to pump all the water 2 m above
the tank. The water has a density of 1000 kg per cubic meter.
Q 1(d) Refer to Fig. 3. Water flows out of a cylindrical tank, 0.8m in diameter,...
Q 1(d) Refer to Fig. 3. Water flows out of a cylindrical tank,
0.8m in diameter, through a 30mm diameter pipe. i) If the velocity
in the pipe is 0.6m/s, at what rate does the surface level on the
tank fall? ii) If the tank is 500mm in height, how long will it
take to empty? iii) Calculate the volume of water collected in the
container in t = 4 minutes
A cubical tank has sides of 4.5m which contains three immiscible liquids at same depths. A...
A cubical tank has sides of 4.5m which contains three
immiscible liquids at same depths. A water upto a height of 1.5m
above the base,
An immiscible liquid of specific gravity 0.9 is filled in between
both liquids (mid-portion) upto 1.5m height, the upper remaining
part is filled
with oil of specific gravity 0.79. Calculate
(i) The value of pressures at the top, at the interface points and
at bottom on one side of the tank
(ii) The position of...
silica sand particles of spherical shape have a density of 2650 kg/m^3 and voidage 43 percentage...
silica sand particles of spherical shape have a density of 2650
kg/m^3 and voidage 43 percentage when rest in a packed bed column
of diameter D=10 mm. the total mass of particles is 1 kg.the bed is
to be fludised by a flowing non reacting gas moving upwards through
the bed of solids.
i) what is the bulk density of the solid particle? 4 marks
ii)calculate the static bed height (H) by the solid particles
when rest in the cylindrical...
ADVERTISEMENT
Need Online Homework Help?
Get Answers For Free
Most questions answered within 1 hours.
ADVERTISEMENT
Active Questions
asked 25 minutes ago
asked 36 minutes ago
asked 41 minutes ago
asked 50 minutes ago
asked 54 minutes ago
asked 56 minutes ago
asked 1 hour ago
asked 1 hour ago
asked 1 hour ago
asked 1 hour ago
asked 2 hours ago
asked 2 hours ago