Question
(a) Find the total force on the bottom of a cylindrical gasoline storage tank 18.0 m...
(a) Find the total force on the bottom of a cylindrical gasoline storage tank 18.0 m high with radius 25.0 m. (b) Find the total force on the side of the tank. Show working equation with answer for both (a) and (b). Both (a) and (b) must be in Newtons.
Homework Answers
Answer #1
Not the answer you're looking for?
Similar Questions
A cylindrical oil storage tank is 50 meters tall and has a diameter of 40 meters...
A cylindrical oil storage tank is 50 meters
tall and has a diameter of 40 meters is sitting on a concrete
pad..
Do NOT change system of units!
a) What is the pressure inside the tank at 10 meters above the
concrete pad?
b) What is the total force acting on the bottom of the tank?
c) What is the total force acting on the side of the tank?
Keep your answer in decimal form and to 1 decimal place....
A cylindrical underground storage tank with a diameter of 21 ft and a height of 25...
A cylindrical underground storage tank with a diameter of 21 ft
and a height of 25 ft is filled with gasoline. Assuming the density
of gasoline is 675 kg/m3, answer the following questions. Determine
the mass of the gas in the tank in both lbm and kg
Q.1: The dimension of a cylindrical storage tank is given as 12 m height and 6...
Q.1: The
dimension of
a cylindrical
storage tank is given as
12 m height and 6 m diameter. It is filled by light diesel
of
density of the oil is
o.98 g
/cm3.
Calculate:[12
Marks]
(i)
the
pressure exerted by the oil at the base of the tank if tank is
filled up to
10m
(ii)total
pressure by the oil at the base of the tank.
(iii)
the
force exerted by the oil at the base of the
tank....
A large cylindrical tank containing water to a level of 5.00 m above the bottom of...
A large cylindrical tank containing water to a level of 5.00 m
above the bottom of the tank is elevated such that the bottom of
the tank is 5.00 m off the ground. A hose with a length of 3.00 m
and a radius of 1.50 cm is attached to the bottom of the tank and
allowed to hang vertically down. Water begins to drain out from the
end of the hose. The density of water is 1000 kg/m3.
(a)...
You are assigned the design of a cylindrical, pressurized water tank for a future colony on...
You are assigned the design of a cylindrical, pressurized water
tank for a future colony on Mars, where the acceleration due to
gravity is 3.71 meters per second per second. The pressure at the
surface of the water will be 140 kPa , and the depth of the water
will be 13.6 m . The pressure of the air in the building outside
the tank will be 85.0 kPa . Find the net downward force on the
tank's flat bottom,...
An isopentane storage tank has a cylindrical geometry with 2 m in diameter and 4 m...
An isopentane storage tank has a cylindrical geometry with 2 m
in diameter and 4 m in height. The tank is initially found with a
liquid level of 0.5 m above the base of the tank. This tank is
removed 100 L / s of isopentane as a discharge that is sent to a
later process. At a given moment, a recharge of 300 L / s of
isopentane is initiated to the tank to recover the level of the...
A gas station stores its gasoline in a tank under the ground. The tank is a...
A gas station stores its gasoline in a tank under the ground.
The tank is a cylinder lying horizontally on its side. (In other
words, the tank is not standing vertically on one of its flat
ends.) If the radius of the cylinder is 1.5 meters, its length is 3
meters, and its top is 3 meters under the ground, find the total
amount of work needed to pump the gasoline out of the tank. (The
density of gasoline is...
On January 15, 1919 a cylindrical tank of molasses ruptured, and poured out over the streets...
On January 15, 1919 a cylindrical tank of molasses ruptured, and
poured out over the streets of Boston. In some places,
the stream was 9 m deep; pedestrians and horses were killed, and
buildings were knocked down. (This is true!)
Suppose a cylindrical tank (height 21.8 m, diameter 6.38 m) was
full of molasses(specific gravity 6.36). Find the
magnitude of the total force exerted by the molasses on the bottom
of the tank before it broke.
How do I find the gravitation force, or weight, of a 1-inch thick cylindrical steel tank...
How do I find the gravitation force, or weight, of a 1-inch
thick cylindrical steel tank that's submerged underwater given the
weight density of steel to be 500 lb/ft^3? The radius is 5 ft and
the length is 15 ft.
A storage tank, open at the top, has a diameter 2.3 m and a height 1.8...
A storage tank, open at the top, has a diameter 2.3 m and a
height 1.8 m . During a storm, the tank catches rain at the rate of
16.9 cm3/s. Simultaneously, water leaks out from the
bottom of the tank through a hole that has a cross-sectional area
A = 0.051 cm2.
During a long rain storm, what is the maximum depth of water in
the tank?
Give your answer in units of m.
PLEASE SHOW ALL STEPS
ADVERTISEMENT
Need Online Homework Help?
Get Answers For Free
Most questions answered within 1 hours.
ADVERTISEMENT
Active Questions
asked 1 minute ago
asked 14 minutes ago
asked 16 minutes ago
asked 21 minutes ago
asked 25 minutes ago
asked 34 minutes ago
asked 40 minutes ago
asked 45 minutes ago
asked 46 minutes ago
asked 53 minutes ago
asked 1 hour ago
asked 1 hour ago