Question
What is the force you need to apply on a syringe piston in order to inject...
- What is the force you need to apply on a syringe piston in order to inject a 1 mm radius air bubble in an IV line 1 m below the level of water. The area of the plunger is 1 cm2.
Homework Answers
Answer #1
Not the answer you're looking for?
Similar Questions
A veterinarian uses a hypodermic syringe like the one shown in the figure to inject a...
A veterinarian uses a hypodermic syringe like the one shown in
the figure to inject a horse with a medical solution with a density
that is the same as water. The barrel of the syringe has a
cross-sectional area of 2.53 10-5
m2 and before she exerts any force on the plunger, the
pressure everywhere in the syringe is 1.00 atm. When she exerts a
force with a magnitude of 2.55 N on the plunger, the medical
solution squirts horizontally from...
Intravenous injections are commonly performed with a hypodermic needle and syringe. Assume that the dimensions of...
Intravenous injections are commonly performed with a hypodermic
needle and syringe. Assume that the
dimensions of the needle are length = L = 1 cm, radius of
the needle = 3.3x10‐4 m, radius of
the syringe = 5x10‐3 m and that the drug solution has the
properties of water.
a) Assume that 1 mL of a drug solution must be injected over a 3
sec period. Will the flow through the needle be laminar or
turbulent?
b) Derive a general...
A) A 1500-kg car is lifted to a height h by a hydraulic lift containing an...
A) A 1500-kg car is lifted to a height h by a hydraulic lift
containing an incompressible fluid. A force of F_1 applied on a
piston of area A_1 results in a larger force of F_2 on the plunger
of larger area A_2. Suppose the piston has a radius of 0.0120 m and
the plunger’s radius is 0.150 m. Calculate the height to which the
car is lifted if the work done by the plunger is 200 J. (Assume
that...
(a) (2 marks) A 2000-kg car is lifted to a height h by a hydraulic lift...
(a) A 2000-kg car is
lifted to a height h by a hydraulic lift containing an
incompressible fluid. A force of F1 applied on a
piston of area A1 results in a larger force of
F2 on the plunger of larger area
A2 . Suppose the piston has a radius of 0.0120 m
and the plunger’s radius is 0.750 m.
Calculate the height to which the car is lifted if the work done
by the plunger is 200 J. (Assume...
The plunger on a loaded syringe is plunged at 20 cm/sec. Assume the water is inviscid,...
The plunger on a loaded syringe is plunged at 20 cm/sec.
Assume the water is inviscid, and ignore air resistance. (Answer
a-i)
Take force of gravity = 10 m/(s^2)
Cross sectional Area of main body 2cm, Corss sectional area of
tip/nozzle is 2mm
With 5 mL of water in the syringe.
a) What is the velocity of the water as it exits the
syringe?
b) If aimed vertically, how high will the water go?
c) If the syringe is tipped...
In a water pistol, a piston drives water through a larger tube of area A1 into...
In a water pistol, a piston drives water through a larger tube
of area A1 into a smaller tube of area A2 as shown in the figure
below. The radius of the large tube is 1.50 cm and that of the
small tube is 1.10 mm. The smaller tube is 3.00 cm above the larger
tube.
(a) If the pistol is fired horizontally at a height of 1.10 m,
determine the time interval required for water to travel from the...
In a water pistol, a piston drives water through a larger tube of area A1 into...
In a water pistol, a piston drives water through a larger tube
of area A1 into a smaller tube of area
A2 as shown in the figure below. The radius of
the large tube is 1.20 cm and that of the small tube is 1.50 mm.
The smaller tube is 3.00 cm above the larger tube.
(a) If the pistol is fired horizontally at a height of 1.10 m,
determine the time interval required for water to travel from the...
A surgeon inserted a needle in the patient’s vein. The needle was connected to a top-open...
A surgeon inserted a needle in the
patient’s vein. The needle was connected to a top-open plastic bag
filled with therapeutic fluid and lifted to a height h.
the pressure gauge inside the vein was 5980 Pa. The therapeutic
fluid density was adjusted to be the same as that of blood (see the
lecture notes or textbook for the value).
(d) At the next stage of the treatment procedure, the
surgeon used a syringe to administer a drug fluid into...
A surgeon inserted a needle in the patient’s vein. The needle was connected to a top-open...
A surgeon inserted a needle in the patient’s vein. The needle
was connected to a top-open plastic bag filled with therapeutic
fluid and lifted to a height h. Find h, which is just sufficient
for the fluid to enter the vein, if the pressure gauge inside the
vein was 5980 Pa. The therapeutic fluid density was adjusted to be
the same as that of blood (see the lecture notes or textbook for
the value).
(d) At the next stage of...
(c) (4 marks) A surgeon inserted a needle in the patient’s vein. The needle was connected...
(c) A surgeon inserted a needle in the patient’s vein.
The needle was connected to a top-open plastic bag filled with
therapeutic fluid and lifted to a height h. Find h, which is just
sufficient for the fluid to enter the vein, if the pressure gauge
inside the vein was 5980 Pa. The therapeutic fluid density was
adjusted to be the same as that of blood (see the lecture notes or
textbook for the value).
(d) At the next stage...
ADVERTISEMENT
Need Online Homework Help?
Get Answers For Free
Most questions answered within 1 hours.
ADVERTISEMENT
Active Questions
asked 6 minutes ago
asked 8 minutes ago
asked 11 minutes ago
asked 32 minutes ago
asked 36 minutes ago
asked 43 minutes ago
asked 57 minutes ago
asked 1 hour ago
asked 1 hour ago
asked 1 hour ago
asked 1 hour ago
asked 1 hour ago