Question
Two Balls and a Thin Rod Two balls of mass 3.29 kg are attached to the...
Two Balls and a Thin Rod
Two balls of mass 3.29 kg are attached to the ends of a
thin rod of negligible mass and length 72 cm. The rod is
free to rotate without friction about a horizontal axis through its
center. A putty wad of mass 127 g drops onto one of the
balls, with a speed 2.5 m/s, and sticks to it.
What is the angular speed of the system just after the putty wad
hits?
1.31×10-1 rad/s
| ¡Correcto! Su recibo es 160-8476 |
Intentos Anteriores |
What is the ratio of the kinetic energy of the entire system after the collision to that of the putty wad before the collision (in percent)?
| 1.88 is incorrect |
| Incorrecto. | Tries 18/40 | Intentos Anteriores |
Homework Answers
Answer #1
Not the answer you're looking for?
Similar Questions
Two Balls and a Thin Rod Two balls of mass 2.43 kg are attached to the...
Two Balls and a Thin Rod
Two balls of mass 2.43 kg are attached to the ends of a
thin rod of negligible mass and length 60 cm. The rod is
free to rotate without friction about a horizontal axis through its
center. A putty wad of mass 126 gdrops onto one of the
balls, with a speed 2.6 m/s, and sticks to it.
What is the angular speed of the system just after the putty wad
hits?
What is...
Two 2.4 kg balls are attached to the ends of a thin rod of negligible mass,...
Two 2.4 kg balls are attached to the ends of a thin rod of
negligible mass, 54 cm in length. The rod is free to rotate in a
vertical plane about a horizontal axis through its center. With the
rod initially horizontal as shown, a 0.33 kg wad of wet putty drops
onto one of the balls with a speed of 3.7 m/sec and sticks to
it.
1)What is the ratio of
the magnitude of angular momentum of the entire...
Two 3.20 kg balls are attached to the ends of a thin rod of length 75.0...
Two 3.20 kg balls are attached to the ends of a thin rod of
length 75.0 cm and negligible mass. The rod is free to rotate in a
vertical plane without friction about a horizontal axis through its
center. With the rod initially horizontal (the figure), a 65.0 g
wad of wet putty drops onto one of the balls, hitting it with a
speed of 3.68 m/s and then sticking to it. (a)
What is the angular speed of the...
Collision Between Ball and Stick On a frictionless table, a 0.62 kg glob of clay strikes...
Collision Between Ball and Stick
On a frictionless table, a 0.62 kg glob of clay strikes
a uniform 1.12 kg bar perpendicularly at a point 0.21
m from the center of the bar and sticks to it. If the bar
is 1.34 m long and the clay is moving at 7.50
m/s before striking the bar, what is the final
speed of the center of mass?
2.67 m/s
¡Correcto!
Su recibo es 160-2745
Intentos Anteriores
At what angular speed does...
A uniform thin rod of length 0.56 m and mass 3.2 kg can rotate in a...
A uniform thin rod of length 0.56 m and mass 3.2 kg can rotate
in a horizontal plane about a vertical axis through its center. The
rod is at rest when a 3.5 g bullet traveling in the rotation plane
is fired into one end of the rod. As viewed from above, the
bullet's path makes angle θ = 60° with the rod. If the
bullet lodges in the rod and the angular velocity of the rod is
12.0 rad/s...
8%) Problem 15: A rod of mass M = 3.5 kg and length L can rotate...
8%)
Problem 15: A rod of mass M =
3.5 kg and length L can rotate about a hinge at its left
end and is initially at rest. A putty ball of mass m = 55
g, moving with speed v = 6.68 m/s, strikes the rod at
angle θ = 59° from the normal at a distance D =
2/3 L, where L = 1.25 m, from the point of
rotation and sticks to the rod after the collision....
A uniform thin rod of length 0.45 m and mass 6.5 kg can rotate in a...
A uniform thin rod of length 0.45 m and mass 6.5 kg can rotate
in a horizontal plane about a vertical axis through its center. The
rod is a rest when a 3.0-g bullet traveling in the horizontal plane
of the rod is fired into one end of the rod. As viewed from above,
the direction of the bullet velocity makes an angle of 60° with the
rod (see the figure). If the bullet lodges in the rod and the...
The assembly shown in the figure below consists of a thin rod of length ℓ =...
The assembly shown in the figure below consists of a thin rod of
length
ℓ = 23.2 cm
and mass
m = 1.20 kg
with a solid sphere of diameter
d = 10.0 cm
and mass
M = 2.00 kg
attached to its top. The assembly is free to pivot about a
frictionless axle through the bottom of the rod. The assembly is
initially vertical and at rest when it starts to rotate
clockwise.
A thin rod of length ℓ...
A cylindrical rod of length 2.0 m, radius 0.5 m, and mass 1.5 kg has two...
A cylindrical rod of length 2.0 m, radius 0.5 m, and mass 1.5 kg
has two spheres attached on its ends. The centers of the spheres
are 1.0 m from the center of the rod. The mass of each sphere is
0.66 kg. The rod is capable of rotating about an axis passing
through its center and perpendicular to the plane of the page, but
the set up is stationary to begin with. A small mass of value 0.19
kgmoving...
two putty balls, one of mass M and the other of mass 2M, collide and stick...
two putty balls, one of mass M and the other of mass 2M, collide
and stick together. just before the collision, the ball with mass
2m is moving at an angle theta, with respect to the +y direction
with speed V, and ball with mass M is moving in the +x direction
with speed 2V. (derive and expression using the coordinate system
provided, in terms of system parameters, for the KE of the combined
object after collision.?)
ADVERTISEMENT
Need Online Homework Help?
Get Answers For Free
Most questions answered within 1 hours.
ADVERTISEMENT
Active Questions
asked 5 minutes ago
asked 15 minutes ago
asked 27 minutes ago
asked 40 minutes ago
asked 41 minutes ago
asked 45 minutes ago
asked 46 minutes ago
asked 48 minutes ago
asked 1 hour ago
asked 1 hour ago
asked 1 hour ago
asked 1 hour ago