Question

The graph in (Figure 1) shows the current through a 2.0 ΩΩ resistor as a function...

The graph in (Figure 1) shows the current through a 2.0 ΩΩ resistor as a function of time.

Figure

1 of 1The plot shows the current as a function of time. Time is measured from 0 to 10 seconds on the x axis. Current is measured from 0 to 2.5 amperes on the y axis. First the current stays at 0 amperes from the origin until 2 seconds. Then it jumps to 2.5 amperes and remains at this value until 5 seconds. Then it drops to 1.25 amperes and stays at this value until 10 seconds.

Part A

How much charge flowed through the resistor during the 10 ss interval shown?

Express your answer in coulombs to two significant figures.

Part B

What was the total energy dissipated by the resistor during this time?

Express your answer in joules to two significant figures.

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
You may want to review (Pages 772 - 773) . Figure1 of 1The figure shows a...
You may want to review (Pages 772 - 773) . Figure1 of 1The figure shows a circuit consisting of 12-Volt battery and resistors R 1 and R 2. The battery is connected in parallel with a series combination of two resistors. The figure shows a circuit consisting of 12-Volt battery and resistors R 1 and R 2. The battery is connected in parallel with a series combination of two resistors. Part A How much power is dissipated by the R1=20Ω...
Figure1 of 1The figure shows a circuit consisting of three parallel branches. 24-volt battery is the...
Figure1 of 1The figure shows a circuit consisting of three parallel branches. 24-volt battery is the first branch. The second branch is a series combination of 5-ohm resistor and 10-ohm resistor. The third branch is a series combination of a 6-ohm resistor and 4-ohm resistor. The figure shows a circuit consisting of three parallel branches. 24-volt battery is the first branch. The second branch is a series combination of 5-ohm resistor and 10-ohm resistor. The third branch is a series...
Light of 650 nm wavelength illuminates a single slit of width 0.20 mm. (Figure 1) shows...
Light of 650 nm wavelength illuminates a single slit of width 0.20 mm. (Figure 1) shows the intensity pattern seen on a screen behind the slit. You may want to review (Pages 941 - 943) . Figure1 of 1The graph shows intensity as a function of distance. Distance is measured from 0 to 3 centimeters on the x-axis. No values or units are given for the intensity on the y-axis. A large central peak is positioned at 1.5 centimeters with...
1- What is the current in amperes if 1300 Na+Na+ ions flow across a cell membrane...
1- What is the current in amperes if 1300 Na+Na+ ions flow across a cell membrane in 3.2 μsμs ? The charge on the sodium is the same as on an electron, but positive. Express your answer to two significant figures and include the appropriate units. 2- What voltage will produce 0.45 AA of current through a 4800-ΩΩ resistor? Express your answer to two significant figures and include the appropriate units. 3- An electric device draws 4.60 AA at 240...
In (Figure 1), the total resistance is 15.0 kΩ , and the battery's emf is 31.0...
In (Figure 1), the total resistance is 15.0 kΩ , and the battery's emf is 31.0 V . The time constant is measured to be 26.0 μs . Part A Calculate the total capacitance of the circuit. Express your answer with the appropriate units. C = SubmitRequest Answer Part B Calculate the time it takes for the voltage across the resistor to reach 15.0 V after the switch is closed. Express your answer to three significant figures and include the...
2. Figure 1 on the following page shows an LRC circuit with the resistor of 10...
2. Figure 1 on the following page shows an LRC circuit with the resistor of 10 Ω, the capacitor of 330 μF, and the inductor of 8.2 mH. ( a) Calculate the resonance frequency in radian/s for the LRC circuit. (b) If the angular frequency of the applied AC source is 628 radian/s, calculate The impedance of the resistor = The impedance of the capacitor = The impedance of the inductor = (c) If the current is measured as I(t)...
The figure below shows a capacitor, with capacitance C = 5.72 µF, and a resistor, with...
The figure below shows a capacitor, with capacitance C = 5.72 µF, and a resistor, with resistance R = 6.98 MΩ, connected in series to a battery, with e m f = 27.5 V. The circuit has a switch, which is initially open. The circuit is a rectangular loop. The bottom side of the loop has a battery labeled emf, oriented with the positive terminal to the right of the negative terminal. The right side has a resistor R. The...
An LR circuit is hooked up to a battery as shown in the figure, with the...
An LR circuit is hooked up to a battery as shown in the figure, with the switch initially open. The resistance in the circuit is R=120 Ω, the inductance is L=4.90 H, and the battery maintains a voltage of E=37.0 V. At time t=0 the switch is closed. (A)What is the current through the circuit after the switch has been closed for t=5.31E-2 s? (B)What is the voltage across the inductor after the switch has been closed for t= 5.31E-2...
Constants In (Figure 1), a beam of protons moves through a uniform magnetic field with magnitude...
Constants In (Figure 1), a beam of protons moves through a uniform magnetic field with magnitude 2.0 T , directed along the positive z axis. The protons have a velocity of magnitude 3.0×105 m/s in the x-z plane at an angle of 30 ∘ to the positive z axis. Find the force on a proton. The charge of the proton is q=+1.6×10−19C. SOLUTION SET UP We use the right-hand rule to find the direction of the force. The force acts...
1. What is the resistance of a NichromeTM wire at 0.0 ∘C∘C if its resistance is...
1. What is the resistance of a NichromeTM wire at 0.0 ∘C∘C if its resistance is 106.9 ΩΩ at 12.5 ∘C∘C? The temperature coefficient of resistivity for NichromeTM is 4.00×10−4 (∘C)−1(∘C)−1 . Enter your answer with four significant figures. 2. A heart defibrillator is used to enable the heart to start beating if it has stopped. This is done by passing a large current of 12 AA through the body at 30 VV for a very short time, usually about...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT