Question

The figure shows an initially stationary block of mass m on a floor. A force of...

The figure shows an initially stationary block of mass m on a floor. A force of magnitude 0.500mg is then applied at upward angle θ = 20°. What is the magnitude of the acceleration of the block across the floor if (a) μs = 0.630 and μk = 0.530 and (b) μs = 0.430 and μk = 0.320?

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
The figure shows an initially stationary block of mass m on a floor. A force of...
The figure shows an initially stationary block of mass m on a floor. A force of magnitude 0.500mg is then applied at upward angle θ = 20°. What is the magnitude of the acceleration of the block across the floor if (a) μs = 0.620 and μk = 0.540 and (b) μs = 0.440 and μk = 0.310
Figure shows a block of mass m resting on a 20∘ ∘ slope. The block has...
Figure shows a block of mass m resting on a 20∘ ∘ slope. The block has coefficients of friction μs μ s = 0.82 and μk μ k = 0.54 with the surface. It is connected via a massless string over a massless, frictionless pulley to a hanging block of mass 2.0 kg k g . (Figure 1) PART A) What is the minimum mass m m that will stick and not slip? part b) If this minimum mass is...
In the figure, a force P→ acts on a block weighing 47.0 N. The block is...
In the figure, a force P→ acts on a block weighing 47.0 N. The block is initially at rest on a plane inclined at angle θ = 17.0° to the horizontal. The positive direction of the x axis is up the plane. The coefficients of friction between block and plane are μs = 0.520 and μk = 0.350. In unit-vector notation, what is the frictional force on the block from the plane when P→ is (a) (-5.40 N) î ,...
A large crate with mass m rests on a horizontal floor. The static and kinetic coefficients...
A large crate with mass m rests on a horizontal floor. The static and kinetic coefficients of friction between the crate and the floor are μs and μk, respectively. A woman pushes downward on the crate at an angle θ below the horizontal with a force F⃗ . What is the magnitude of the force vector F⃗  required to keep the crate moving at constant velocity? If μs is greater than some critical value, the woman cannot start the crate moving...
A cord is used to vertically lower an initially stationary block of mass M = 20...
A cord is used to vertically lower an initially stationary block of mass M = 20 kg at a constant downward acceleration of g/8. When the block has fallen a distance d = 3.5 m A. find the work done by the cord's force on the block. B. Find the kinetic energy of the block C. Find the speed of the block
Figure shows two industrial spies sliding an initially stationary 225 kg floor safe a displacement d...
Figure shows two industrial spies sliding an initially stationary 225 kg floor safe a displacement d of magnitude 9.5 m. The push F1 of spy 001 is 12 N at an angle of 40 degrees downward from the horizontal, the pull F2 of the spy 002 is 10 N at 50 degrees above the horizontal. The magnitudes and directions of these forces do not change as the safe moves, and the floor and safe make frictionless contact. (a) What is...
The three diagrams below show a block of mass m being pulled or pushed at constant...
The three diagrams below show a block of mass m being pulled or pushed at constant acceleration along a table with a force F. The coefficient of kinetic friction is μk. What is the magnitude of the friction force in each case? Give your answer in terms of the pushing force F, m, μk, and the angle θ. case (i)     fk =    case (ii)     fk = case (iii)     fk =
20.0-kg block initially sits at rest on a rough horizontal floor. One end of a string...
20.0-kg block initially sits at rest on a rough horizontal floor. One end of a string is attached to the block. You pull on the other end of the string with a force of 40.0 N so that the string makes an angle of 30.0° with the horizontal. After pulling the block 3.00 m across the floor, it is traveling with a speed of 1.25 m/s. What is the magnitude of the force of kinetic friction exerted on the block...
A block of mass m = 14.5 kg rests on an inclined plane with a coefficient...
A block of mass m = 14.5 kg rests on an inclined plane with a coefficient of static friction of μs = 0.16 between the block and the plane. The inclined plane is L = 6.1 m long and it has a height of h = 3.8 m at its tallest point. A.What angle, θ in degrees, does the plane make with respect to the horizontal? B.What is the magnitude of the normal force, FN in newtons, that acts on...
As shown in Figure 1, a block (mass: 2.4 kg) is initially at rest near the...
As shown in Figure 1, a block (mass: 2.4 kg) is initially at rest near the top of an inclined plane, oriented at a 25° angle above the horizontal. The coefficients of static and kinetic friction along the incline are 0.2 and 0.1, respectively. (a) Just after the block is released from rest, draw a free-body diagram for it. (Assume that the block is moving after being released from rest.) (b) Determine the magnitude of the normal force acting on...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT