Question

ethernet

ethernet

Homework Answers

Answer #2

Ethernet is a way of connecting computers together in a local area network or LAN. It has been the most widely used method of linking computers together in LANs since the 1990s. The basic idea of its design is that multiple computers have access to it and can send data at any time. This is comparatively easy to engineer.

A system for connecting a number of computer systems to form a local area network, with protocols to control the passing of information and to avoid simultaneous transmission by two or more systems.

Image : Commercial ethernet connector

source : internet

answered by: anonymous
Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
Convert the hexadecimal Ethernet MAC address, 1a:0:2f:47:b1:2, into a 48 bits binary format. Given an Ethernet...
Convert the hexadecimal Ethernet MAC address, 1a:0:2f:47:b1:2, into a 48 bits binary format. Given an Ethernet address, how do you know it is a unicast, multicast, or broadcast address?
1) Assume you have one end of an Ethernet cable in your hands and that connector...
1) Assume you have one end of an Ethernet cable in your hands and that connector is a straight pass through. What type of cable (straight pass through or crossover) do you have in your hands? Explain your answer. 2) If you have a standard Ethernet cable in your hands, what is the quickest way to determine the type of cable (straight pass through or crossover)?
Compute the percentage of overhead for CRC (i.e. FCS) error data in a minimum sized Ethernet...
Compute the percentage of overhead for CRC (i.e. FCS) error data in a minimum sized Ethernet frame?
What are the major benefits in adopting Power over Ethernet (PoE) for distributed extra-low-voltage equipment?11111111111111111111111111111
What are the major benefits in adopting Power over Ethernet (PoE) for distributed extra-low-voltage equipment?11111111111111111111111111111
12.Consider a 10Mbps Ethernet network consisting of 20 nodes interconnected by a bus topology with a...
12.Consider a 10Mbps Ethernet network consisting of 20 nodes interconnected by a bus topology with a single bridge placed in the approximate centre of the network resulting in an equal number of nodes on each side of the bridge. a) Briefly explain why collisions can/cannot occur. b) If two pairs of nodes attempted to communicate at the same time, discuss the throughput they can achieve.
Comupter Networks Question 1) a: Why is sub network access protocol (SNAP) header required in Ethernet...
Comupter Networks Question 1) a: Why is sub network access protocol (SNAP) header required in Ethernet frame , Explain ? b: Describe connection orieted and connectionless services. Explain any two connectionless and connection oriented protocols? NOTE : explain the following in details, thank You.
1. Explain why, on a typical Ethernet, if the original IPv6 host address was obtained via...
1. Explain why, on a typical Ethernet, if the original IPv6 host address was obtained via SLAAC then the LAN multicast group corresponding to the host’s solicited-node multicast addresses is likely to be small, in many cases consisting of one host only. (Packet delivery to small LAN multicast groups can be much more efficient than delivery to large multicast groups.) 2. What steps might a DHCPv6 server take to ensure that, for the IPv6 addresses it hands out, the LAN...
If you wish to run Ethernet over fiber using 1000BASE-SX signaling over 500 meters, what options(list...
If you wish to run Ethernet over fiber using 1000BASE-SX signaling over 500 meters, what options(list all the pairs of signaling standard and fiber standards) do you have? Which should you choose? Justify your answer. If you wish to connect two switches with fiber at a speed of 30 G b p s, what options do you have? Which would you choose? Justify your answer.
Hepras, Inc., has two product lines: routers and ethernet switches. During the current month, the two...
Hepras, Inc., has two product lines: routers and ethernet switches. During the current month, the two product lines reported the following results.    Routers Switches Sales $ 590,000 $ 830000 Variable costs (as a percentage of sales) 40 % 45 % Traceable fixed costs $ 250,000 $ 125,000    In addition, fixed costs common to both product lines amounted to $219,000. Prepare an income statement showing percentages as well as dollar amounts. Conclude your statement with income from operations for...
Hepras, Inc., has two product lines: routers and ethernet switches. During the current month, the two...
Hepras, Inc., has two product lines: routers and ethernet switches. During the current month, the two product lines reported the following results. Routers SwitchesSales$630,000 $780,000 Variable costs (as a percentage of sales) 40% 45%Traceable fixed costs$250,000 $125,000 In addition, fixed costs common to both product lines amounted to $216,000. Prepare an income statement showing percentages as well as dollar amounts. Conclude your statement with income from operations for the business and with the responsibility margin for each product line. (Round...