Question

Which types of circuits are harder to power, those having low electrical resistance or those having...

Which types of circuits are harder to power, those having low electrical resistance or those having high electrical resistance?

Which circuit has more electrical resistance, series or parallel? Explain your answer using observations/data from the activity.

Under which conditions will a battery run down faster, when connected to a high-resistance circuit or when connected to a low-resistance circuit?

Which battery would last longer, one connected to a three-bulb series circuit or one connected to a three-bulb parallel circuit? (Assume the batteries are identical and the bulbs are identical.)

Science   Advanced-Physics   
0 0
Add a commentTranscribed image text
Next >

Homework Answers

Answer #1

0 0
Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Log In

Sign Up

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
Series/Parallel Circuits: When unequal resistors are connected in series across an ideal battery, the same power...
Series/Parallel Circuits: When unequal resistors are connected in series across an ideal battery, the same power is dissipated in each one. the potential difference across each is the same. the equivalent resistance of the circuit is equal to the average of all the resistances. the current flowing in each is the same. the equivalent resistance of the circuit is less than that of the smallest resistor.
please answer the following 1)A circuit has a total unknown resistance Req. This unknown resistance is...
please answer the following 1)A circuit has a total unknown resistance Req. This unknown resistance is connected to a 15.1 V battery. Once connected this unknown resistance sees 77.7 C of charge pass through it every 37.0 seconds. What is the value for the unknown resistance Req? A. 80.5 Ω B. 110.0 Ω C. 7.2 Ω D. 31.7 Ω E. 0.2 Ω 2)You have a large supply of identical bulbs and a battery. You start with one lightbulb connected to...
I just did a lab and I can't figure out why the voltage behaves this way....
I just did a lab and I can't figure out why the voltage behaves this way. Circuit one: A 1.5 volt battery and a voltmeter V= 1.319V Circuit two: Same as circuit one but there is a bulb parallel with the voltmeter and the voltage drops to 1.156V. Shouldn't the voltage be the same because they are in parallel and how can you use theory or otherwise to explain this? Is it due to resistance decreasing because the bulb abd...
Please answer.. Overview: When a wire is attached to the positive terminal of a power source,...
Please answer.. Overview: When a wire is attached to the positive terminal of a power source, such as a battery, and to the negative terminal of the battery a potential difference is set across that wire and a current is generated through that wire. Depending on how much resistance there is in the wire will affect the amount of current through that wire. Adding more resistance will further affect the amount of current.  In this experiment you will measure both the...
3) In a lab in electrical circuits, your laboratory colleague challenges you by asking you to...
3) In a lab in electrical circuits, your laboratory colleague challenges you by asking you to connect a circuit with the total resistance (replacement resistance) 1 000 ?. One requirement is that you use at least three resistors, each of which is of different size, and that both serial and parallel connection must occur. Describe which resistors you used as well as clearly how to connect these. I'm new to physics, so please explain thoroughly, thank you!
1.Four wires come from a node. Three of those wires have current entering the node. What...
1.Four wires come from a node. Three of those wires have current entering the node. What can you say about the fourth wire? 2.You see a drawing of a circuit with multiple paths. How does the voltage difference around a longer path compare to the voltage difference around a shorter path? 3.Describe the behavior of an empty capacitor when an initial voltage is applied? 4.Draw a circuit that has one battery, one resistor, one capacitor, and one inductor. Make sure...
1. You direct microwaves at a 2 slit filter (Separation between slits is d). What would...
1. You direct microwaves at a 2 slit filter (Separation between slits is d). What would you expect to see if you place a detector right between the two slits at a distance l away on the outgoing side (l >> d)? a minimum signal, as the center is blocked by the filter a minimum, because of destructive interference a maximum because of constructive interference it depends on the spacing of the slits if it is a maximum or minimum...
PLEASE DRAW THE CIRCUIT DIAGRAMS OF EACH DEFINITIONS AND GIVE ITS APPLICATIONS. PLEASE GIVE THE FULL...
PLEASE DRAW THE CIRCUIT DIAGRAMS OF EACH DEFINITIONS AND GIVE ITS APPLICATIONS. PLEASE GIVE THE FULL DETAILS OF THE STEPS ON EACH QUESTIONS SO I COULD FOLLOW UP YOUR WHOLE EXPLANATIONS. PLEASE WRITE THE STEPS ON SOLVING THIS EXAMPLE EX) STEP 1, STEP 2, ETC HANDWRITING IS OKAY AS LONG AS IT IS READABLE. IF YOU HAVE USED THE EQUATIONS OR CONCEPTS, PLEASE STATE IT CLEARLY WHICH ONE YOU HAVE YOU USED SO I COULD FULLY UNDERSTAND THE DETAILS OF...
#1. Which of the following scenarios would be best described as having a true experimental research...
#1. Which of the following scenarios would be best described as having a true experimental research design? A Research Question: Do a smaller proportion of graduates attend graduation when it is held on a Sunday compared to Saturday? Design: Randomly select 40 graduates the year it is held on a Saturday and record how many attend graduation. Do the same thing on a year the ceremony is held on a Sunday. B Research Question: Is a new vaccination effective at...
Exploring Innovation in Action Power to the People – Lifeline Energy Trevor Baylis was quite a...
Exploring Innovation in Action Power to the People – Lifeline Energy Trevor Baylis was quite a swimmer in his youth, representing Britain at the age of 15. So it wasn’t entirely surprising that he ended up working for a swimming pool firm in Surrey before setting up his own company. He continued his swimming passion – working as a part-time TV stuntman doing underwater feats – but also followed an interest in inventing things. One of the projects he began...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT