Question

An ideal gas is enclosed in a cylinder with a movable piston on top of it. The piston has a mass of 8,000 g and an area of 5.00 cm2 and is free to slide up and down, keeping the pressure of the gas constant. (a) How much work is done on the gas as the temperature of 0.155 mol of the gas is raised from 25.0°C to 280°C?

Answer #1

The answer for above problem is explained below.

An ideal gas is enclosed in a cylinder with a movable piston on
top of it. The piston has a mass of 8,000 g and an area of 5.00
cm2 and is free to slide up and down, keeping the
pressure of the gas constant.
(a) How much work is done on the gas as the temperature of 0.155
mol of the gas is raised from 30.0°C to 330°C?
_______ J

A 6.0-cm-diameter cylinder of nitrogen gas has a 4.0-cm-thick
movable copper piston. The cylinder is oriented vertically, as
shown in the figure, and the air above the piston is evacuated.
When the gas temperature is 15 ∘C , the piston floats 20cm above
the bottom of the cylinder.
A. What is the gas pressure?
B. How many gas molecules are in the cylinder?
C. Then 1.5 JJ of heat energy are transferred to the
gas. What is the new equilibrium temperature...

A cylinder with a moveable piston on top, free to move up and
down, contains one mole of an ideal gas initially at a temperature
of Ti = 3.8°C. The cylinder is heated at a constant pressure of
1.00 atm, and it expands to seven times its original volume. (a)
Calculate the new temperature Tf of the gas (in K). (No Response) K
(b) Calculate the work done (in kJ) on the gas during the
expansion.

A vessel with a movable piston contains 1.90 mol of an ideal gas
with initial pressure
Pi = 2.03 ✕ 105 Pa,
initial volume
Vi = 1.00 ✕ 10−2
m3,
and initial temperature
Ti = 128 K.
(a) What is the work done on the gas during a constant-pressure
compression, after which the final volume of the gas is 2.50
L?
J
(b) What is the work done on the gas during an isothermal
compression, after which the final pressure...

A certain amount of chlorine gas was placed inside a cylinder
with a movable piston at one end. The initial volume was 3.00 L and
the initial pressure of chlorine was 1.64 atm . The piston was
pushed down to change the volume to 1.00 L. Calculate the final
pressure of the gas if the temperature and number of moles of
chlorine remain constant.
Enter a numerical answer only, in terms of
atm.
Please show all work

A cylinder of monatomic ideal gas is sealed in a cylinder by a
piston. Initially, the gas occupies a volume of 3.00 L and the
pressure is initially 105 kPa. The cylinder is placed in an oven
that maintains the temperature at a constant value. 65.0 J of work
is then done on the piston, compressing the gas (in other words,
the gas does −65.0 J of work). The work is done very slowly so that
the gas maintains a...

One mole of an ideal gas is contained in a cylinder with a
movable piston. The temperature is constant at 76°C. Weights are
removed suddenly from the piston to give the following sequence of
three pressures.
a. P1 = 5.10 atm (initial state)
b. P2 = 2.23 atm
c. P3 = 1.00 atm (final state)
What is the total work (in joules) in going from the initial to
the final state by way of the preceding two steps?
_________J (need...

A cylinder sealed with a piston contains an ideal gas. Heat is
added to the gas while the piston remains locked in place until the
absolute temperature of the gas doubles.
1. The pressure of the gas a. doubles b. stays the same c. drops
in half
2. The work done by the surroundings on the gas is a. positive
b. negative c. zero
3. The thermal energy of the gas a. doubles b. stays the same c.
drops in...

A vertical, insulated cylinder contains an ideal gas. The top of
the cylinder is closed off by a piston of mass m that is free to
move up and down with no appreciable friction. The piston is a
height h above the bottom of the cylinder when supported only by
the gas. Sand is now poured onto the piston very slowly until the
weight of the sand is equal to the weight of the piston.
(a) Find an analytic expression...

A sample of neon gas at 20 °C is confined to a cylinder with a
movable piston. The gas is then heated until its pressure is
doubled. What is the final temperature of the gas?

ADVERTISEMENT

Get Answers For Free

Most questions answered within 1 hours.

ADVERTISEMENT

asked 2 minutes ago

asked 3 minutes ago

asked 24 minutes ago

asked 37 minutes ago

asked 37 minutes ago

asked 41 minutes ago

asked 45 minutes ago

asked 1 hour ago

asked 1 hour ago

asked 1 hour ago

asked 2 hours ago

asked 2 hours ago