Question

why are the zero force members used in the truss system ?

why are the zero force members used in the truss system ?

Science   Physics   
0 0
Add a commentTranscribed image text
Next >

Homework Answers

Answer #1

0 0
Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Log In

Sign Up

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
Truss Analysis 1.      Select a material and a cross section for the members. 2.      Choose four...
Truss Analysis 1.      Select a material and a cross section for the members. 2.      Choose four arbitrarily placed points. Connect them as two triangles. No members can be vertical or horizontal and none can be aligned. 3.      Draw the truss and label the measured lengths. 4.      Select two support points and two load points. 5.      Load the truss vertically with a load at each load point. 6.      Calculate the reactions and the forces within the members. 7.      Calculate the change...
I have a General Question for Statics (Structural Analysis). For Truss questions (method of joints and...
I have a General Question for Statics (Structural Analysis). For Truss questions (method of joints and zero-force members), how do you know when you need to find the moment at the pin joint? The book say's, when each joint has at least three unknown forces. Is this true? Really confused on how to know when you need to find the moment or not.
Using the method of joints, determine the force in each member of the truss shown. State...
Using the method of joints, determine the force in each member of the truss shown. State whether each member is in tension or compression.
Consider the truss shown in (Figure 1). Suppose that FFF = 7 kNkN . Figure 1...
Consider the truss shown in (Figure 1). Suppose that FFF = 7 kNkN . Figure 1 of 1The figure shows a truss consisting of 21 members joined by 12 pins. The pins at A, B, C, D, E, F and G are located on the same horizontal line at a distance of 2 meters from each other from left to right in this order. The pin at A is fixed on a horizontal surface and the pin at G is...
Why is that the diagonal cross bracing in the truss cannot support compression forces? I see...
Why is that the diagonal cross bracing in the truss cannot support compression forces? I see problems like these in books. Thanks
Why are children used as a labor force?
Why are children used as a labor force?
In an interference force fit in a basic hole system, the allowance is: (a) zero (b)negative...
In an interference force fit in a basic hole system, the allowance is: (a) zero (b)negative (c)positive (d)greater than the tolerance of either the hole of the shaft (e)equal to the nominal or basic dimension
A system of particles is known to have a total KE of zero. What can you...
A system of particles is known to have a total KE of zero. What can you say about the total momentum of the system? a) momentum of the system is positive b) momentum of the system is negative      c) momentum of the system is zero d) you cannot say anything A system of particles is known to have a total momentum of zero. What can you say about the total KE of the system? a) is it is necessarily zero...
What two DNA repair systems are used by the immune system, and why?
What two DNA repair systems are used by the immune system, and why?
) Give two reasons why a three-phase system is normally used for the transmission and distribution...
) Give two reasons why a three-phase system is normally used for the transmission and distribution of electrical energy when an AC system is used
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT