Question
A hypodermic needle is 2.96 cm in length and 0.38 mm in diameter. What pressure difference...
A hypodermic needle is 2.96 cm in length and 0.38 mm in diameter. What pressure difference between the input and output of the needle is required so that the flow rate of water through it will be 1 g/s? (Use 1.0 ✕ 10−3 Pa · s as the viscosity of water.)
Homework Answers
Answer #1
Not the answer you're looking for?
Similar Questions
A hypodermic needle is 3.14 cm in length and 0.35 mm in diameter. What pressure difference...
A hypodermic needle is 3.14 cm in length and 0.35 mm in
diameter. What pressure difference between the input and output of
the needle is required so that the flow rate of water through it
will be 1 g/s? (Use 1.0 10-3 Pa · s as the viscosity of water.)
__ Pa
The tube shown has a length of 2.00 m and a diameter of 1.00 mm. Water...
The tube shown has a length of 2.00 m and a diameter of 1.00 mm.
Water at 40° C is flowing through the tube.
For water at 40° C:
A) What pressure difference is required to give the water a flow
speed of 4.0 m/s? (Give your answer in units of Pa.)
B) What force applied to the end of the tube will produce this
pressure? (Give your answer in units of N.)
C) What is the volume flow rate...
A 3 cm long needle is used to inject a 0.3 L of a solution located...
A 3 cm long needle is used to inject a 0.3 L of a solution
located 70 cm above a patient over a time of 25 minutes. Assume
that the viscosity of this solution is 1.1 mPa⋅s and its density is
970kg/m3.
a) If the vein`s pressure is assumed to be at atmospheric
pressure, what will be the difference in the input and output
pressures across the needle in mmHg?
b) What is the flow rate of the solution in...
Saline solution is delivered into the vein of a patient through a needle. The saline solution...
Saline solution is delivered into the vein of a patient through
a needle. The saline solution has a viscosity of 0.00037 Pa.s, a
density of 1,060 kg/m3, and is delivered through a 7.0-cm long
needle with an internal diameter of 0.24 mm directly into the
patient’s vein in which the blood pressure is 130 mmHg (1
mmHg=133.4 Pa). The saline solution must be delivered at a flow
rate of 0.04×10-6 m3/s. How high must the saline solution be
suspended in...
A drug delivery catheter consists of a cylindrical needle whose wall contains very small pores allowing...
A drug delivery catheter consists of a cylindrical needle whose
wall contains very small pores allowing the drug solution to leave
the needle into the surrounding tissue. The hydraulic conductance
of the needle wall is 10−5 cm2 s g−1. The needle has a length of 2
cm and the diameter of the needle is 200 μm. The sharp end of the
needle is closed off so that any flow of drug solution into the
needle must flow out through the...
A needle of inner diameter 0.50mm is used to draw blood from a patient’s arm for...
A needle of inner diameter 0.50mm is used to draw blood from a
patient’s arm for a medical test. The average blood pressure in the
patient’s arm is 85mmHg, and the viscosity of the blood is
3.5×10−4Pa⋅s. The length of the needle is 6.0cm, and the blood
needs to be drawn at a constant flow rate of 0.10cm3/s. What
pressure must be applied to the plunger?
A fluid with SG:0,888 and viscosity:0,8 Pa s flows in horizontal pipe of diameter:5 cm and...
A fluid with SG:0,888 and viscosity:0,8 Pa s
flows in horizontal pipe of diameter:5 cm and length:40 m.The
measured velocity profile is of parabolic shape.The amount of
pressure difference between inlet and exist of the pipe is 648,76
kPa.Determine Reynolds number of flow if the pipe is inclined at an
angle 30 degree with horizontal and flow is upward with the same
pressure difference is
applied
5 mL syringe has an inner diameter of 10 mm, a needle inner diameter of 0.25...
5 mL syringe has an inner diameter of 10 mm, a needle inner
diameter of 0.25 mm, and a plunger pad diameter of 1.5 cm. A doctor
uses the syringe to inject medicine into a patient whose blood
pressure is 140/100 (assuming ideal fluid).
a) What’s the minimum force that the doctor needs to apply to
the syringe?
b) The syringe is emptied in 3s, what was flow speed?
To deliver an intravenous solution at 0.20 L/hr to a patient through a needle, a pressure...
To deliver an intravenous solution at 0.20 L/hr to a patient
through a needle, a pressure difference between the pressure where
the solution enters the needle and the patient’s blood pressure is
needed. If the needle has a radius of 1.5 x 10-4 m and is 0.025 m
long, assuming a viscosity of 1.0 x 10-3 (N/m2) s for the solution,
what must be the difference between solution pressure and the
pressure in the vein of the patient? (A) 3.1...
-A Carnot engine operates between a 1500 C reservoir and a -20 C reservoir. What is...
-A Carnot engine operates between a 1500 C reservoir and a
-20 C reservoir. What is the efficiency of the engine?
Optional Answers:
83%
- a-A fluid with viscosity 1.2 Pa s moves through a
200-m-long pipe with a 20 cm diameter. What is the resistance to
laminar flow, R, in the pipe?
Optional Answers:
1. 6.1x10^6 Pa s/m^3 2. 3.8x10^5 Pa s/m^3 3. 3.8x10^-3 Pa s/m^3
4. 6.1x10^-2 Pa s/m^3
b- A fluid with viscosity 1.2 Pa s moves...
ADVERTISEMENT
Need Online Homework Help?
Get Answers For Free
Most questions answered within 1 hours.
ADVERTISEMENT
Active Questions
asked 7 minutes ago
asked 20 minutes ago
asked 22 minutes ago
asked 26 minutes ago
asked 31 minutes ago
asked 40 minutes ago
asked 46 minutes ago
asked 51 minutes ago
asked 52 minutes ago
asked 58 minutes ago
asked 1 hour ago
asked 1 hour ago