Question

The speed and pressure of water flowing through a series of pipes is measured. At one...

The speed and pressure of water flowing through a series of pipes is measured. At one location, the speed is measured to be 2.00 m/s and the pressure is measured to be 150 kPa. At a second location, the speed is measured to be 1.50 m/s and the pressure is measured to be 200 kPa. What is the change of height between the two locations, in meters?

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
A horizontal pipe contains water at a pressure of 100 kPa flowing with a speed of...
A horizontal pipe contains water at a pressure of 100 kPa flowing with a speed of 2.0 m/s . The pipe narrows to one-half its original diameter. The speed of the water is 8 m/s what is the pressure of the water?
Water flows through two horizontal pipes that are connected one after another but located at different...
Water flows through two horizontal pipes that are connected one after another but located at different heights. There are pressure gauges on each of the pipes. The speed of the water through the lower pipe is 5.0 m/s. The two pipes have different diameters. The lower pipe has a diameter of 6 cm and the higher one 4 cm. Assume no viscous losses. a. Draw a diagram of the situation and calculate the speed in the upper pipe. b. What...
The pressure of water flowing through a 6.3×10?2 ?m -radius pipe at a speed of 1.1...
The pressure of water flowing through a 6.3×10?2 ?m -radius pipe at a speed of 1.1 m/s is 2.2 ×105 N/m2. (a) What is the flow rate of water? (b) What is the pressure in the water after it goes up a 4.6 ?m -high hill and flows in a 5.0×10?2 ?m-radius pipe?
The pressure of water flowing through a 5.9×10^-2 m-radius pipe at a speed of 1.2 m/s...
The pressure of water flowing through a 5.9×10^-2 m-radius pipe at a speed of 1.2 m/s is 2.2×10^5 N/m^2. a) What is the flow rate of the water? b) What is the pressure in the water after it goes up a 5.8 m-high hill and flows in a 4.2×10^-2 m-radius pipe?
Water flowing at 40 L/s through a 9 cm diameter pipe transitions to a 3 cm...
Water flowing at 40 L/s through a 9 cm diameter pipe transitions to a 3 cm diameter pipe. What is the water pressure difference between the pipes? By what factor does the speed of the water increase moving from the larger to smaller pipe?
#23)     Water flowing at 40 L/s through a 9 cm diameter pipe transitions to a 3...
#23)     Water flowing at 40 L/s through a 9 cm diameter pipe transitions to a 3 cm diameter pipe. What is the water pressure difference between the pipes? By what factor does the speed of the water increase moving from the larger to smaller pipe?
Consider the water flowing through the pipes in Earle Hall. The bulk motion of the energy...
Consider the water flowing through the pipes in Earle Hall. The bulk motion of the energy is a representation of its: kinetic energy potential energy internal energy work If the water is a different temperature than its surroundings (the pipes, air, etc), then the energy balance on the water will include a term accounting for the transfer of ____________. Fill in the blank. kinetic energy potential energy internal energy heat If the water is drawn through a pipe on the...
Water is flowing through a tube. The water speed is 6.30 m/s at point 1. Point...
Water is flowing through a tube. The water speed is 6.30 m/s at point 1. Point 2 is 7.1 m higher than point 1. The diameter of the pipe is 0.40 m at point 1 and 0.20 m at point 2. What is the pressure difference P1-P2 between points 1 and 2? (ρ(H2O)=1000 kg/m3)
A house with 200-m2 floor space is heated with geothermal water flowing through pipes laid in...
A house with 200-m2 floor space is heated with geothermal water flowing through pipes laid in the ground under the floor. The walls of the house are 4 m high, and there are 8 single-paned windows in the house that are 1.2 m wide and 1.8 m high. The house has R-4 insulation (where R= 1/U is the overall unit thermal resistance(the R-value) and U is the overall heat transfer coefficient) in the walls and R-5 on the ceiling. The...
Q9: The pressure of water flowing through a 6.2×10−2-m-radius pipe at a speed of 1.5 m/s...
Q9: The pressure of water flowing through a 6.2×10−2-m-radius pipe at a speed of 1.5 m/s is 2.2×105N/m2. Part A: What is the flow rate of the water? Express your answer with the appropriate units. Part B: What is the pressure in the water after it goes up a 6.0-m-high hill and flows in a 4.6×10−2-m-radius pipe? Express your answer with the appropriate units.
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT