Question

A gas mixture which consists of ethylene (1)/propylene (2) with propylene mole fraction 0.65 has been...

A gas mixture which consists of ethylene (1)/propylene (2) with propylene mole fraction 0.65 has been stored in a closed vessel system at temperature of 320 oF and pressure 3 MPa. Using generalized correlation for the fugacity coefficient, calculate the followings:

a) Determine the fugacity coefficient for propylene in the gas mixture.

b) Estimate fugacity (bar) for ethylene in the gas mixture.

Homework Answers

Answer #1

The notation used ij , when its i=j it denotes pure species, and when I not equal to j it denotes mixed species.

omega used here is an acentric factor

The value of the acentric factor, critical temperature and pressure can be found on internet or any standard book

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
A single-stage liquid/vapor separation for the unknown molecule (1) and molecule (2) mixture with mole fraction...
A single-stage liquid/vapor separation for the unknown molecule (1) and molecule (2) mixture with mole fraction z1=0.75 is operated at T=100°C and P=40 kPa. Determine the partial pressure of molecule (1) in the separator. The feeding rate of the mixture is 1mole/s and the molar fraction (V) of the vapor formed is 0.5. Saturated pressure of the molecule (1) is 50.00 kPa and that of the molecule (2) is 20 kPa at the separator temperature. Assume Raoult’s law applies. (8...
1.1A gas mixture consists of 8 mol of H2 and 2 mol of N2. Determine the...
1.1A gas mixture consists of 8 mol of H2 and 2 mol of N2. Determine the mass of each gas and the apparent gas constant of the mixture. (8) 1.2Determine the binary diffusion coefficient (DAB) of O2 in N2 at (a) 200 K and 1 atm, (b) 400 K and 0.8 atm, and (c) 600 K and 3 atm. The binary diffusion coefficient of O2 in N2 at T1 = 273 K and P1 = 1 atm is 1.8 x...
Chemical Vapor Deposition (CVD) of a Silicon Thin Film onto a Wafer: Solid, nonporous silicon thin...
Chemical Vapor Deposition (CVD) of a Silicon Thin Film onto a Wafer: Solid, nonporous silicon thin films can be laid down onto wafer surfaces by the following chemical vapor deposition ( CVD) process: SiH 4 (g) ? Si (s) + 2 H 2 (g) . It is desired to deposit a very thin film of Si on a wafer surface. Usually, CVD processes are carried out at very low system pressure and high temperature using a reactor like the one...