Question

explain what happens by adding buffles to shell and tube ? anything increased ? velocity ?

explain what happens

by adding buffles to shell and tube ? anything increased ? velocity ?

Homework Answers

Answer #1

Baffles :-

Baffles are used to increas fluid velocity by diverting flow across the tube bundle to obtain higher heat transfer co-efficinet.

- Baffles support the tubes thus reducing chance of damage due to vibration.

- There are number of different baffle types, which support tube and promote flow across tubes.

Single segmental ( Most common )

Double segmental (used to obtain lower shell velocity and promote flow across the tubes)

Baffles are held in positioned by means of baffle spacers.

- closer baffles spacing givers greater transfer co-efficient by inducing higher turbulance.

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
When initial velocity is increased, what happens early in the flight of a golf ball? A)...
When initial velocity is increased, what happens early in the flight of a golf ball? A) There is a greater upwards acceleration and less slowing down of the ball B) There is a greater downwards acceleration and less slowing down of the ball C) There is a greater upwards acceleration and more slowing down of the ball D) There is a greater downwards acceleration and more slowing down of the ball
What happens with the fundamental frequency of an open tube when the tube is gradually submerged...
What happens with the fundamental frequency of an open tube when the tube is gradually submerged in water?
Water at a flow rate of 60 kg/s enters the shell-side of a baffled shell-and-tube heat...
Water at a flow rate of 60 kg/s enters the shell-side of a baffled shell-and-tube heat exchanger at 35 °C and leaves at 25 °C. The heat will be transferred to 150 kg/s of raw water coming from a supply at 15 °C. You are requested to design the heat exchanger for this purpose. A single shell and single tube pass is preferable. The tube diameter is ¾ in. (19 mm outer diameter with 16 mm inner diameter) and tubes...
A shell and-tube heat exchanger is required for the following service: Hot stream Cold Stream Aromatic...
A shell and-tube heat exchanger is required for the following service: Hot stream Cold Stream Aromatic Stream Cooling Water inlet Temperature (oC) 85 20 outlet Temperature (oC) 40 35 Mass Flowrate x heat Capacity (kW/oC) 85.2 Hot Stream cold stream (Cooling water) Heat Capacity (J/kg K) 2840 4193 Density (kg/m3) 750 999 Viscosity (cP) 0.34 1.016 Thermal conductivity (W/m.K) 0.19 0.594 Fouling Factor (m2.oC/W 0.00018 0.000176 ? The cooling water is allocated to the tube-side of the exchanger. ? It...
describes what happens to the resistance of the light bulb as the voltage is increased. Explain...
describes what happens to the resistance of the light bulb as the voltage is increased. Explain please as to why the resistance changes. Does it follow Ohm's Law? Describe how the resistance of the zener diode changes as the voltage increases. Why are zener diodes not ohmic devices?
A 2.50-kg fireworks shell is fired straight up from a mortar and reaches a height of...
A 2.50-kg fireworks shell is fired straight up from a mortar and reaches a height of 110 m. (a) Neglecting air resistance (a poor assumption, but we will make it for this example), calculate the shell’s velocity when it leaves the mortar. (b) The mortar itself is a tube 0.450 m long. Calculate the average acceleration of the shell in the tube as it goes from zero to the velocity found in (a). (c) What is the average force on...
1. When radiation travels through the window of the GM tube, what happens so that the...
1. When radiation travels through the window of the GM tube, what happens so that the tube sends a signal that it has detected a particle? 2. Can the GM counter distinguish between one or more particles when they are present in the tube at the same time?
Consider a binomial experiment. If the number of trials is increased, what happens to the expected...
Consider a binomial experiment. If the number of trials is increased, what happens to the expected value? To the standard deviation? Explain. Please give a good and brief explanation (please use a new example that is not on chegg already)
Consider a binomial experiment. If the number of trials is increased, what happens to the expected...
Consider a binomial experiment. If the number of trials is increased, what happens to the expected value? To the standard deviation? Explain. WRITE IN TEXT NOT IMAGE TEXT SINCE I CANT READ SOME OF THE HANDWRITING IN IMAGE TEXT
For a reaction, what generally happens if the temperature is increased, with respect to k?
For a reaction, what generally happens if the temperature is increased, with respect to k?