Question

1000 kg/h of a 50 wt% liquid mixture of ethanol and water at 20 C is...

1000 kg/h of a 50 wt% liquid mixture of ethanol and water at 20 C is fed continuously to a vessel in which the mixture is heated to 85 C. The liquid product is 30 wt% ethanol and the vapor product is 80 wt% ethanol.

a) Complete the material balance for this process.

b) Simplify the general energy balance for this process.

c) Calculate the amount of heat that is required. In your calculations, you may truncate the heat capacities from table B.2 to Cp = a + bT.

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
A liquid mixture contains 50 wt% ethanol (E), '10 wt% of a dissolved solute (S) and...
A liquid mixture contains 50 wt% ethanol (E), '10 wt% of a dissolved solute (S) and the balance is water (W). A stream of this mixture F, is fed to a continuous distillation column operating at a steady state. Two streams emerge from the column as the top product, P and the bottom waste Q, respectively. The column design class for the product streams is to have equal mass flow rate, and for the top product stream, P is to...
A liquid mixture containing 28 mol% ethanol and 72 mol% 1-propanol is placed in an open...
A liquid mixture containing 28 mol% ethanol and 72 mol% 1-propanol is placed in an open vessel and heated slowly. If heat is supplied continuously after the mixture begins to boil, how will the liquid temperature change with time?
A liquid mixture containing 28 mol% ethanol and 72 mol% 1-propanol is placed in an open...
A liquid mixture containing 28 mol% ethanol and 72 mol% 1-propanol is placed in an open vessel and heated slowly. If heat is supplied continuously after the mixture begins to boil, how will the liquid temperature change with time? a Txy diagram was not provided. The answer choices were: Not change, increase, or decrease.
A mixture of 1000 kg/h contains an equal parts by mass of methanol and water is...
A mixture of 1000 kg/h contains an equal parts by mass of methanol and water is distilled. Product streams leave the top and the bottom of the distillation column. The flow rate of the bottom stream is measured at 673kg/h and the overhead stream is analyzed and found to contain 96 wt % methanol. a. construct a flowchart of the process and perform the degree of freedom analysis. [6 marks] b' Determine the mass and mole fractions of methanol and...
An air-water vapor mixture containing 20% ​​humidity at a dry thermometer temperature of 40 ° C...
An air-water vapor mixture containing 20% ​​humidity at a dry thermometer temperature of 40 ° C A tunnel is fed to the dryer by being heated to 70 ° C. Red pepper samples It is dried in adiabatic conditions. Leave the dryer system saturated For the mixing air-water vapor mixture, find the following. a) 10000 m3 of moist air at 40 ° C (air-water vapor mixture) warmth Required heat to increase to 70 ° C b) Air temperature at dryer...
Q2) Consider 100 kmole/h of feed which includes 20 mole % ethanol in water. We wish...
Q2) Consider 100 kmole/h of feed which includes 20 mole % ethanol in water. We wish to concentrate ethanol to 60 % with a bottom product that is no more than 2 % ethanol. The feed is a saturated liquid. The reflux ratio should be 1.5*Rmin (Rmin: Minimum reflux ratio). If the trays have a Murphree efficiency of 75 % based on the vapor, calculate the number of stages and optimal feed stage. The column is run at 1 atm....
Ethanol is produced commercially by hydration of ethylene and during this process a side reaction converts...
Ethanol is produced commercially by hydration of ethylene and during this process a side reaction converts some the ethanol to diethyl ether (DEE). In one process, a fresh feed containing ethylene, non-condensable inerts, and water are mixed with a recycle stream. The combined stream is fed to the reactor and it contains 182 mol/min of ethylene. While the fresh feed contains 9 moles of ethylene per mole of inerts, after mixing with recycle stream, the mole ratio of inerts to...
In an absorption tower (or absorber), a gas is contacted with a liquid such that one...
In an absorption tower (or absorber), a gas is contacted with a liquid such that one or more components in the gas is transferred in the liquid. A stripping tower (stripper) also involves a gas contacting a liquid but components are transferred from the liquid into the gas. A process consisting of an absorber and a stripper is used to separate the components of a gas containing 35.0 mole% CO2 and the balance CH4. This gas is fed to the...
Biodiesel fuel—a sustainable alternative to petroleum diesel as a transportation fuel—is produced via the transesterification of...
Biodiesel fuel—a sustainable alternative to petroleum diesel as a transportation fuel—is produced via the transesterification of triglyceride molecules derived from vegetable oils or animal fats. For every 9 kg of biodiesel produced in this process, 1 kg of glycerol, C2H8O3, is produced as a byproduct. Finding a market for the glycerol is important for biodiesel manufacturing to be economically viable. A process for converting glycerol to the industrially important specialty chemical intermediates acrolein, C2H4O, and hydroxyacetone (acetol), C3H6O2, has been...
1) 20 kg/min water at 20º C is mixed adiabatically with 40 kg/min water at 80...
1) 20 kg/min water at 20º C is mixed adiabatically with 40 kg/min water at 80 ºC. What is the outlet water temperature? Select one: a. 80 °C b. 60 °C c. 50 °C d. 70 °C 2) Steam at 0.8 MPa and 500 ºC is throttled over a well insulated valve to 0.6 MPa, what is the outlet temperature Select one: a. 450 ºC b. 500 ºC c. DOF>0 d. 400 ºC 3) Humid air at 70 C and...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT