Question

A high grade fuel oil containing only C and H is burnt in a furnace that...

A high grade fuel oil containing only C and H is burnt in a furnace that is well designed and well operated, giving a combustion gas, the Orsat analysis of which shows 12.4 % CO2, 3.7 % O2 and 83.9 % N2 and inerts. The air is substantially dry. Calculate a) % excess air b) C to H in the fuel

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
Fuel oil which consists of hydrocarbon, CxHy is burnt in a combustion chamber at 25 °C....
Fuel oil which consists of hydrocarbon, CxHy is burnt in a combustion chamber at 25 °C. Standard heat of combustion is -43,515 J/g with CO2 (g) and H2O (l) as products. The temperature of the fuel and air entering the combustion chamber is 25 °C. and the air is assumed dry. The flue gases leave at 300 °C and their average composition is 11.2 % CO2, 0.4 % CO, 6.2 % O2 and 82.2 % N2 based on dry basis....
The combustion products from an industrial furnace using a hydrocarbon fuel and dry air enters the...
The combustion products from an industrial furnace using a hydrocarbon fuel and dry air enters the stack at normal barometric pressure and 375oF and have the following Orsatanalysis: 12.2% CO2, 3.1% O2, 1.2% CO, and82.5% N2. Determine the following: a.The percent excess air. b.The volume of the gases entering the stack expressed as cubic feet per pound of carbon burnt in the furnace. c.The atomic ratio of hydrogen to carbon in the fuel.
Chemical Engineering Question A hydrocarbon gas is burned in a combustion furnace. the composition of the...
Chemical Engineering Question A hydrocarbon gas is burned in a combustion furnace. the composition of the stack gases exiting the firebox is 1.6 mol% CO, 9.6 mol% CO2, 4.9 mol% O2, and 83.9 mol% N2 on a dry basis. a) determine what is the fuel entering the combustion reactor? What is the amount of the fuel input?
A fuel oil containing 70 % carbon by weight and the rest combustible hydrogen and moisture...
A fuel oil containing 70 % carbon by weight and the rest combustible hydrogen and moisture is burned with excess air. The flue gas analyzed 9 % CO2, 2 % CO, 3 % O2, and 86 % N2. Determine the following: The percentage of excess air. (15.1%) The ratio of carbon to combustible hydrogen in the fuel on a weight basis (3.35) The ratio of the carbon to total hydrogen in the fuel on a weight basis (3.19) The percentages...
A fuel gas containing 74.0% methane, 12.0% ethane, and 14.0% propane by volume flows to a...
A fuel gas containing 74.0% methane, 12.0% ethane, and 14.0% propane by volume flows to a furnace at a rate of 1450 m3/h at 15.0°C and 180.0 kPa (gauge), where it is burned with 16.0% excess air. Calculate the required flow rate of air in SCMH (standard cubic meters per hour). You may take the composition of air to be 21.0 mol% O2 and the balance N2.
24. The composition by mass of a fuel oil is 0.857 carbon, 0.142 hydrogen and 0.001...
24. The composition by mass of a fuel oil is 0.857 carbon, 0.142 hydrogen and 0.001 incombustibles. Find the stoichiometric air/fuel ratio. If the dry exhaust gas analysis is found to be CO2 0.1229, N2 0.8395 and O2 0.0376 by volume, determine the actual air/ fuel ratio used. ANSWER (14.68; 17.82 by carbon balance)
A fuel gas containing 75.0 mole% methane and the balance ethane is burned completely with 35.0%...
A fuel gas containing 75.0 mole% methane and the balance ethane is burned completely with 35.0% excess air. The stack gas leaves the furnace at 800.0°C and is cooled to 350.0°C in a waste-heat boiler, a heat exchanger in which heat lost by cooling gases is used to produce steam from liquid water for heating, power generation, or process applications. Take as a basis 100.0 mol of the fuel gas fed to the furnace. The amounts of each of the...
A natural gas mixture of methane (CH4) and ethane (C2H6) are used for the fuel source...
A natural gas mixture of methane (CH4) and ethane (C2H6) are used for the fuel source for generation of steam in a refinery plant.In this process,The gas stream mixture 1000kg/min having 70wt% CH4 and 30wt% C2H6 is burned with 100% excess air.Gas analysis shows that the CH4 and 85% C2H6 are completely burned into carbon dioxide , while 10% C2H6 is partially burned into carbon monoxide and the remaining C2H6 is unreacted. Assume the air stream feed to the furnace...
1. A combustion chamber is fed with 50 kmol/h of butane and 2000 kmol/h of air....
1. A combustion chamber is fed with 50 kmol/h of butane and 2000 kmol/h of air. Calculate the % excess air used and composition of the gases leaving combustion reactor, assuming complete combustion of butane. 2. In manufacture of chlorine, feed containing hydrochloric acid gas and air are fed to the reactor. The product gases leaving the reactor are found to contain 13.2% HCl, 6.3% 02, 42.9% N2, 30% Cl2 and 7.6% H2O (by weight). Calculate: i) The percent excess...
Coal containing 40% C, 30% H and 30% ash at 1000 kg / h flow is...
Coal containing 40% C, 30% H and 30% ash at 1000 kg / h flow is burned with dry air fed at 6 kmol / second. Chimney from the oven In addition to gas, there is a solid waste, 95% of this waste is all of the ash in coal, back the rest is unburned carbon. While all the hydrogen in the fuel is oxidized to water; carbon burns so that the selectivity of carbon dioxide in carbon monoxide is...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT