Question

Methane is burned with 25% excess air in a continuous adiabatic reactor. The methane enters the...

Methane is burned with 25% excess air in a continuous adiabatic reactor. The methane enters the reactor at 25°C and 1.10 atm at a rate of 550 L/s, and the entering air is at 150°C and 1.1 atm. Combustion in the reactor is complete, and the reactor effluent gas emerges at 1.05 atm.

(a) Calculate the temperature and the degrees of superheat of the reactor effluent. (Consider water to be the only condensable species in the effluent.)

(b) Suppose only 15% excess air is supplied. Without doing any additional calculations, state how the temperature and degrees of superheat of the reactor effluent would be affected [increase, decrease, remain the same, cannot tell without more information] and explain your reasoning. What risk is involved in lowering the percent excess air?

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
Carbon monoxide is burned with excess air at 1 atm in an adiabatic reactor. The reactants...
Carbon monoxide is burned with excess air at 1 atm in an adiabatic reactor. The reactants are fed at 25C and the final temperature (i.e., the adiabatic flame temperature) is 1500C. (a) Calculate the percentage excess air fed to the reactor. USE THE HEAT OF REACTION METHOD (THIS ANSWER SHOULD BE 99.1% excess O2) (b) If the percentage excess air were increased, how would the adiabatic flame temperature change and why would it change in this manner?
Methanol vapor is burned with excess air in a catalytic combustion chamber. Liquid methanol initially at...
Methanol vapor is burned with excess air in a catalytic combustion chamber. Liquid methanol initially at 25 ◦C is vaporized at 1.1 atm and heated to 100 ◦C; the vapor is mixed with air that has been preheated to 1100 ◦C, and the combined stream is fed to the reactor at 100 ◦C and 1 atm. The reactor effluent emerges at 300 ◦Cand 1atm. Analysis of the product gas yields a dry-basis composition of 4.8% CO2, 14.3% O2, and 80.9%...
Propane gas is burned using air; both are at 25°C and 1 atm. 150% excess air...
Propane gas is burned using air; both are at 25°C and 1 atm. 150% excess air (ie 250% of the theoretical air) is used. The products of the combustion are carbon dioxide(gas) and vapor water along with the excess oxygen. Predict the adiabatic flame temperature, in degrees K, in the steady-flow combustion chamber. Use the thermodynamic data from your textbook, Appendix E for all the required data.
Propane gas is burned using air; both are at 25°C and 1 atm. 150% excess air...
Propane gas is burned using air; both are at 25°C and 1 atm. 150% excess air (ie 250% of the theoretical air) is used. The products of the combustion are carbon dioxide(gas) and vapor water along with the excess oxygen. Predict the adiabatic flame temperature, in degrees K, in the steady-flow combustion chamber. Use the thermodynamic data from your textbook, Appendix E for all the required data Textbook: Introductory Chemical Engineering Thermodynamics (Ed. 2) by Elliott, J. Richard, Lira, Carl...
Methane gas (CH4) at 25 °C is burned steadily with dry air, which enters a combustion...
Methane gas (CH4) at 25 °C is burned steadily with dry air, which enters a combustion chamber of a natural gas boiler in a small power plant at 17 °C. The volumetric analysis of the flue gas on a dry basis is 5.2% carbon dioxide, 0.33% carbon monoxide, 11.24% diatomic oxygen, and 83.23% diatomic nitrogen. The flue gas leaves at 700 K. a) Sketch a fully labelled schematic diagram of the system. b) Write a balanced chemical equation for the...
Propane (C3H8) is burned with excess air, both supplied at 25C. Assume that air is 21%...
Propane (C3H8) is burned with excess air, both supplied at 25C. Assume that air is 21% oxygen, balance nitrogen. Part 1 : If 1.0 mol of propane is burned with x mols of air, how many mols of oxygen appear in the combustion products? A. 3.0 + 0.21x B. 4.0 + 0.79x C. 0.79x D. 0.21x – 5.0 . Part 2 : The standard heat of combustion for propane A. depends on the state of the water in the products...
The two competing reactions for the combustion of methane in a combustor are: CH4 + 2O2...
The two competing reactions for the combustion of methane in a combustor are: CH4 + 2O2 ? CO2 + 2H2O and CH4 + 3/2 O2 ? CO + 2H2O The feed to the combustor contains 7.8 mol% CH4, 19.4% O2, and 72.8% N2 and the gas leaving the reactor contains 8 mol CO2/mol CO. Using a basis of 100 mol/h of feed to the reactor. 1) If 100 mol/h of CH4 is fed to the combustor, i). what is the...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT