Question

Consider a geothermal unit that controls a house temperature by using underground as a heat source...

Consider a geothermal unit that controls a house temperature by using underground as a heat source or a heat sink. The unit includes which of the following? (5 points)

A.

A heat pump

B.

Both A and B

C.

None of the above

D.

A heat engine

Homework Answers

Answer #1

Option (A) is correct

Explanation:

This unit known as geothermal heat pump that uses underground as a heat source or a heat sink. Key components of this unit includes ground loop (network of pipe buried near shallow ground), a heat pump and air delivery system. A fluid circulates through ground loop to absorb or relenquish heat within ground. in winter heat pump removes heat from fluid and transfer it to the building. This process is reversed in the summer. Hence option A is correct.

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
A heat pump using refrigerant-134a heats a house by using underground water at 8°C as the...
A heat pump using refrigerant-134a heats a house by using underground water at 8°C as the heat source. The house is losing heat at a rate of 64000 kJ/h. The refrigerant enters the compressor at 240 kPa and 0°C and leaves at 1.4 MPa and 80°C. The refrigerant exits the condenser at 34°C. a.)Determine the power input to the heat pump. kW b.)Determine the rate of heat absorption from the water. kW c.)Determine the increase in electric power input if...
A house with 200-m2 floor space is heated with geothermal water flowing through pipes laid in...
A house with 200-m2 floor space is heated with geothermal water flowing through pipes laid in the ground under the floor. The walls of the house are 4 m high, and there are 8 single-paned windows in the house that are 1.2 m wide and 1.8 m high. The house has R-4 insulation (where R= 1/U is the overall unit thermal resistance(the R-value) and U is the overall heat transfer coefficient) in the walls and R-5 on the ceiling. The...
a A heat pump is used to maintain the inside temperature of a house at 20◦C...
a A heat pump is used to maintain the inside temperature of a house at 20◦C when the outside temper-ature is 30◦C. What is the minimum amount of work necessary to transfer 100 J of heat to the inside of the house? b The heat of combustion of gasoline is approximately 47.0 kJ/mol. If a gasoline engine operates between 1500 K and 750 K, what is the maximum height that 5.0 moles of gasoline can lift a 400 kg aircraft?
Increasing the temperature of the heat addition (T subscript H) in any heat engine cycle, with...
Increasing the temperature of the heat addition (T subscript H) in any heat engine cycle, with keeping all other parameters unchanged: A. None of the answers. B. Decreases the heat added at high temperature. C. Increases the thermal efficiency of the cycle. D. Decreases the thermal efficiency of the cycle. 1 points    QUESTION 2 The maximum thermal efficiency of the Rankine cycle power plant is achieved when: A. it works on Carnot heat engine cycle. B. the pump work...
3. Consider the reaction N2 (g) + O2 (g) ---------> 2 NO (g) + heat The...
3. Consider the reaction N2 (g) + O2 (g) ---------> 2 NO (g) + heat The product is favored a. When the reaction temperature is increased. b. When the volume of the reaction container is reduced. c. When He (g) is added to the reaction. d. When the reaction temperature is lowered. 4. When the temperature of an equilibrium system for the following reaction is increased, CO (g) + H2O (g) --------> CO2 (g) + H2 (g) the reaction shifts...
1. Circlethecorrect(mostappropriate)statement: a) A well-insulated house stores a lot of heat b) The walls of a...
1. Circlethecorrect(mostappropriate)statement: a) A well-insulated house stores a lot of heat b) The walls of a well-insulated house approximate adiabatic boundary c) The walls of a well-insulated house approximate diathermal boundary d) All of these sentences are correct e) None of these sentences is correct 2. Consider three systems at 37oC: a 1.0L sample of H2O, 100 L of Ne gas at 1.00bar pressure, and a small crystal of NaCl. a) What is the thermal equilibrium status in terms of...
Let us consider a parallel resonance circuit. The parallel resonance circuit consist of a current source....
Let us consider a parallel resonance circuit. The parallel resonance circuit consist of a current source. a resistor, a capacitor, and an inductor connected in parallel. The common quantity between the voltage and current, is: A) The voltage is common B) The current is common C) Both the voltage and the current are common D) Neither the voltage nor the current are common. E) None of the above statements is correct Let us consider a series RC circuit. A series...
Q4 (20 marks). Consider a heat engine which does 500 MJ of work over a 3...
Q4 . Consider a heat engine which does 500 MJ of work over a 3 hour period and operates between a hot reservoir of Th = 1250 C and a cold reservoir of Tc = 30.0 C. The engine is ideal and therefore running at its maximum efficiency. a) [4 marks] Show that the efficiency is 80.0%? b) [6 marks] How much heat: a. Comes from the hot reservoir? b. Is added to the cold reservoir? c) [5 marks] What...
A simple (non-cyclic) heat engine. Consider a cylinder containing an ideal gas under a piston, as...
A simple (non-cyclic) heat engine. Consider a cylinder containing an ideal gas under a piston, as shown in Figure below. After a weight m1 is removed from the piston, the gas expands, lifts the remaining weight m2, and the piston eventually settles at a new position h2. A. Assuming that the above process is carried out in a room whose temperature is maintained constant so that the initial and the final temperature of the gas is exactly the same, what...
Consider a power plant operating on a Rankine cycle using steam as the working fluid. The...
Consider a power plant operating on a Rankine cycle using steam as the working fluid. The boiler pressure is 2.8 MPa and the steam leaving the boiler is superheated to a temperature 110 0C above its saturation temperature. The condenser temperature is 49 0C. Condenser discharges saturates liquid. The efficiency of the turbine is 0.90 and of the pump 0.8 as compared to reversible and adiabatic machines operating at the same pressure ranges. a) Sketch the cycle on a T-S...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT