Question

A gas mixture at 15.0 °C and 105.0 kPa is fed to a mixing unit. The...

A gas mixture at 15.0 °C and 105.0 kPa is fed to a mixing unit. The gas mixture contains 1.20 mol % CO2 and the balance N2. Pure CO2 gas is also fed to the mixing unit as a separate stream with a flow rate of 0.1200 m3 /min at 7.00 °C and 131.0 kPa. The output stream leaving the mixing unit has 4.45 mol % CO2. Calculate the volumetric flow rate of the gas mixture entering the mixing unit (ft3 /min). The process is at steady state. Assume ideal gas behaviour. (Hint: You need to make mole balance(s) to solve this problem.)

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
In an absorption tower (or absorber), a gas is contacted with a liquid such that one...
In an absorption tower (or absorber), a gas is contacted with a liquid such that one or more components in the gas is transferred in the liquid. A stripping tower (stripper) also involves a gas contacting a liquid but components are transferred from the liquid into the gas. A process consisting of an absorber and a stripper is used to separate the components of a gas containing 35.0 mole% CO2 and the balance CH4. This gas is fed to the...
Three thousand cubic meters per day of a gas mixture containing methane and n-butane at 21°C...
Three thousand cubic meters per day of a gas mixture containing methane and n-butane at 21°C enters an absorption tower. The partial pressures at these conditions are 103 kPa for methane and 586 kPa for n-butane. In the absorber, 80% of the butane is removed and the remaining gas leaves the tower at 38°C and a total pressure ot 550 kPa. What is the volumetric flow rate of gas at the exit? How many moles per day of butane are...
A stream of pure propane (C3H8) and a stream of pure butane (C4H10) are both fed...
A stream of pure propane (C3H8) and a stream of pure butane (C4H10) are both fed to a continuous combustion chamber, where they are burned with pure oxygen. Gas analysis indicates that the product gas from the combustion chamber contains 47.4 mole% H2O. The combustion gases are then fed to a condenser, where all of the water vapour is removed (as condensate) to give a gas stream containing 69.4 mole% CO2 and the balance is O2. basis of 100 mol/min...
Benzaldehyde is produced from toluene in the catalytic reaction C6H5CH3 + O2 ? C6H5CHO + H2O...
Benzaldehyde is produced from toluene in the catalytic reaction C6H5CH3 + O2 ? C6H5CHO + H2O Dry air and toluene vapor are mixed and fed to the reactor at 350.0°F and 1 atm. Air is supplied in 100.0% excess. Of the toluene fed to the reactor, 13.0% reacts to form benzaldehyde and 0.100% reacts with oxygen to form CO2 and H2O. The product gases leave the reactor at 379°F and 1 atm. Water is circulated through a jacket surrounding the...
8.27 A fuel gas containing 95.0 mole% methane and the balance ethane is burned completely with...
8.27 A fuel gas containing 95.0 mole% methane and the balance ethane is burned completely with 15.0% excess air. The stack gas leaves the furnace at 800.0°C and is cooled to 450.0°C in a waste-heat boiler, a heat exchanger in which heat lost by cooling gases is used to produce steam from liquid water for heating, power generation, or process applications. A. Take as a basis 100.0 mol of the fuel gas fed to the furnace. Calculate the amounts of...
Ethanol is produced commercially by hydration of ethylene and during this process a side reaction converts...
Ethanol is produced commercially by hydration of ethylene and during this process a side reaction converts some the ethanol to diethyl ether (DEE). In one process, a fresh feed containing ethylene, non-condensable inerts, and water are mixed with a recycle stream. The combined stream is fed to the reactor and it contains 182 mol/min of ethylene. While the fresh feed contains 9 moles of ethylene per mole of inerts, after mixing with recycle stream, the mole ratio of inerts to...
Q1) Natural gas liquids (NGL) are recovered from wet natural gas by cooling, which results in...
Q1) Natural gas liquids (NGL) are recovered from wet natural gas by cooling, which results in condensation of the higher molecular weight components. A raw natural gas has 92% methane, 4% ethane, 3% propane, 1% helium. NGL recovery condenses 89.4% of the propane and 5% of the ethane. What fraction of the natural gas (by mole) is recovered as NGL? Q2) To ensure a slow rate of drying and thereby prevent cracking of a dried product, an inlet relative humidity...
mixture of 35 mole% pentane (C5H12) and 65 mole% butane (C4H10) is burned with 30% excess...
mixture of 35 mole% pentane (C5H12) and 65 mole% butane (C4H10) is burned with 30% excess air in the furnace of a boiler. Fractional conversions of 0.95 for the pentane and 0.90 for the butane are reported. The mole ratio of CO/CO2, in the combustion gases is found to be 0.05. (a) List the major components that will be present in the product gas stream from the process. [5%] (b) Draw and label fully a PFD for this process. [10%]...
1) A nozzle is a device for increasing the velocity of a steadily flowing stream of...
1) A nozzle is a device for increasing the velocity of a steadily flowing stream of fluid. At the inlet to a certain nozzle the enthalpy of the fluid is 3025 kJ/kg and the velocity is 60 m/s. At the exit from the nozzle the enthalpy is 2790 kJ/kg. The nozzle is horizontal and there is negligible heat loss from it. (i) Find the velocity at the nozzle exit. (ii) If the inlet area is 0.1 m2 and specific volume...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT