Question

A natural gas mixture of methane (CH4) and ethane (C2H6) are used for the fuel source...

A natural gas mixture of methane (CH4) and ethane (C2H6) are used for the fuel source for generation of steam in a refinery plant.In this process,The gas stream mixture 1000kg/min having 70wt% CH4 and 30wt% C2H6 is burned with 100% excess air.Gas analysis shows that the CH4 and 85% C2H6 are completely burned into carbon dioxide , while 10% C2H6 is partially burned into carbon monoxide and the remaining C2H6 is unreacted. Assume the air stream feed to the furnace is having a composition of 21% mole oxygen and 79% nitrogen.Given the element molecular weight of C=12,H=1,O=16 and N=14.

a) By showing all the schoimetric equations for the fuel combustion, determine the thereotical amount of molar flow rate (kmol/min) of air used in combustion, the wet and dry analysis of stack of gases.

b)Calculate the concentration of CO in ppm based on the dry analysis.

Engineering   Chemical-Engineering   
0 0
Add a commentTranscribed image text
Next >

Homework Answers

Answer #1

0 0
Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Log In

Sign Up

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
A particular natural gas consists, in mole percents, of 83.0% CH4 (methane), 11.2% C2H6 (ethane), and...
A particular natural gas consists, in mole percents, of 83.0% CH4 (methane), 11.2% C2H6 (ethane), and 5.80% C3H8 (propane). A 385-L sample of this gas, measured at 25 ∘C and 729 mmHg , is burned in an excess of oxygen gas. How much heat, in kilojoules, is evolved in this combustion reaction? Express your answer with the appropriate units. The table shown here gives the enthalpy of combustion for three different hydrocarbon fuels to produce liquid water and gaseous carbon...
A 5.00 g mixture of methane (CH4) and ethane (C2H6) is combusted in oxygen gas to...
A 5.00 g mixture of methane (CH4) and ethane (C2H6) is combusted in oxygen gas to produce carbon dioxide and water. If 14.09 g of CO2 is produced, how many grams of methane was in the original 5.00 g mixture ?
a gas conatins 75.0wt% methane, 10.0% ethane, 5.0% ethylene, and the balance water a) calculate the...
a gas conatins 75.0wt% methane, 10.0% ethane, 5.0% ethylene, and the balance water a) calculate the molar composition of this gas on both wet and dry basis and the ratio (mol h2o/mol dry gas) b ) if 100kg/h of this fuel is to be burned with 30% excess air, what is the required air feed rate (kmol/h)? how would the answer change if the combustion were only 75% complete?
Methane gas (CH4) at 25 °C is burned steadily with dry air, which enters a combustion...
Methane gas (CH4) at 25 °C is burned steadily with dry air, which enters a combustion chamber of a natural gas boiler in a small power plant at 17 °C. The volumetric analysis of the flue gas on a dry basis is 5.2% carbon dioxide, 0.33% carbon monoxide, 11.24% diatomic oxygen, and 83.23% diatomic nitrogen. The flue gas leaves at 700 K. a) Sketch a fully labelled schematic diagram of the system. b) Write a balanced chemical equation for the...
A natural gas mixture having a molar analysis 60% CH4, 30% C2H6, 10% N2 is supplied...
A natural gas mixture having a molar analysis 60% CH4, 30% C2H6, 10% N2 is supplied to a furnace like the one shown in Fig. P13.8, where it burns completely with 20% excess air. Determine (a) the balanced reaction equation. (b) the air–fuel ratio, both on a molar and a mass basis
Two kmol of ethane (C2H6) is burned with an unknown amount of air during a combustion...
Two kmol of ethane (C2H6) is burned with an unknown amount of air during a combustion process. An analysis of the combustion products reveals that the combustion is complete, and there are 4 kmol of free O2 in the products. Determine (a) the air–fuel ratio and (b) the percentage of theoretical air used during this process (c) The equivalent ratio
Two kmol of ethane (C2H6) is burned with an unknown amount of air during a combustion...
Two kmol of ethane (C2H6) is burned with an unknown amount of air during a combustion process. An analysis of the combustion products reveals that the combustion is complete, and there are 4 kmol of free O2 in the products. Determine (a) the air–fuel ratio and (b) the percentage of theoretical air used during this process (c) The equivalent ratio
8.27 A fuel gas containing 95.0 mole% methane and the balance ethane is burned completely with...
8.27 A fuel gas containing 95.0 mole% methane and the balance ethane is burned completely with 15.0% excess air. The stack gas leaves the furnace at 800.0°C and is cooled to 450.0°C in a waste-heat boiler, a heat exchanger in which heat lost by cooling gases is used to produce steam from liquid water for heating, power generation, or process applications. A. Take as a basis 100.0 mol of the fuel gas fed to the furnace. Calculate the amounts of...
A closed container has a mixture of methane, CH4, ethane, C2H6, and propane, C3H8. If 26.5...
A closed container has a mixture of methane, CH4, ethane, C2H6, and propane, C3H8. If 26.5 g of methane, 29.5 g of ethane, and 31.0 g of propane are placed in the 8.60 L container at 58.5°C, what is the total pressure in the container? Assume the gases do not react with each other. atm
A closed container has a mixture of methane, CH4, ethane, C2H6, and propane, C3H8. If 17...
A closed container has a mixture of methane, CH4, ethane, C2H6, and propane, C3H8. If 17 g of methane, 21.6 g of ethane, and 30.3 g of propane are placed in the 4.74 L container at 63.7°C, what is the total pressure in the container (in atm)? Assume the gases do not react with each other
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT