Question

The A-36 steel pipe in (Figure 1) has a 6061-T6 aluminum core. It is subjected to...

The A-36 steel pipe in (Figure 1) has a 6061-T6 aluminum core. It is subjected to a tensile force of 200 kN k N . The pipe has an outer diameter of 96 mm m m and an inner diameter of 86 mm m m . For A-36 steel, Est=200GPa E s t = 200 G P a , and for 6061-T6 aluminum, Eal=68.9GPa E a l = 68.9 G P a . A)Determine the average normal stress in the aluminum due to this loading. B)Determine the average normal stress in the steel due to this loading.https://session.masteringengineering.com/problemAsset/2350006/7/H10-433.png

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
A simply supported polymer thin-walled vessel is subjected to the internal pressure P, as shown in...
A simply supported polymer thin-walled vessel is subjected to the internal pressure P, as shown in Figure 3. The tank is 6 m long, 2 m in outer diameter. The wall thickness of the tank is 20 mm. The tank and its contents have a weight distribution of q = 400 kN/m. If the pressure P = 200 kPa and the allowable stress of the polymer is allow = 30 MPa, determine the factor of safety against yielding according to...
Learning Goal: To use the principle of superposition to determine the total deflection in a cylindrical...
Learning Goal: To use the principle of superposition to determine the total deflection in a cylindrical rod due to a static loading. A steel rod (E=200 GPa) is subjected to the load shown, where P = 2950 kN . A gap a = 1.70 mm exists before the load is applied. The elongated rod contacts the top surface at C'. Assume the mass of the rod is negligible. The values for the figure below are d = 0.500 m ,...
Due to the operational conditions and temperature gradient, a 70 mm diameter, 1.55 m long steel...
Due to the operational conditions and temperature gradient, a 70 mm diameter, 1.55 m long steel rod within a machine assembly is subjected to a combination of tensile loading of 150 N and thermal loading which imposes a longitudinal force of 230 N. The total loading results in an even distribution of forces on the body of the rod causing it to change its dimensions by increasing 0.5 mm in length at both ends and decreasing by 0.0125 mm at...
1. An oven chimney is made of brick with a heat transmission coefficient 1.1 W/mK 10...
1. An oven chimney is made of brick with a heat transmission coefficient 1.1 W/mK 10 cm thick. Since the shaft exterior radiation beam coefficient is 0.8 and the flue gas temperature is 350°C, the external ambient temperature is 25°C and the outer ambient heat transport coefficient is 20 W/m2K; a) Calculate the shaft exterior temperature. b) In order to reduce the risk of burn injury that may occur in the body, the shaft is asked to be below 55°Cve...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT