Question

EXPERIMENT ENERGY LOSSES IN PIPES AND FITTING , The objectives of this experiment are: 1. to...

EXPERIMENT ENERGY LOSSES IN PIPES AND FITTING ,

The objectives of this experiment are:

1. to determine the loss of head due to friction in incompressible flow in a horizontal pipe,

2. to determine the friction factor of a pipe,

3. to determine the loss of head in sudden expansion and sudden contraction of pipes,

4. to determine the loss coefficients in sudden expansion and sudden contraction pipes, and

5. to compare the losses of energy (head losses) in different configuration of pipes.

QUESTION : IDEAS FOR IMPROVEMENT/SUGGESTIONS FOR THE EXPERIMENT

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
THERMOFLUID LAB EXPERIMENT ENERGY LOSSES IN PIPES & FITTING .The objectives of this experiment are firstly...
THERMOFLUID LAB EXPERIMENT ENERGY LOSSES IN PIPES & FITTING .The objectives of this experiment are firstly , identifying the loss of head due to friction in incompressible flow in a horizontal pipe. Next , to determine the friction factor of a pipe that van be find on the slope. To determine the loss of head in sudden expansion and sudden contraction of pipes . Not to forget , loss coefficient in sudden expansion and sudden contraction pipes. Last but not...
A 250 mm diameter of cast iron pipe flows 39.3 L/s of SAE 10 oil along...
A 250 mm diameter of cast iron pipe flows 39.3 L/s of SAE 10 oil along 500 m length. Given: dynamic viscosity, μ and density, ρ of SAE 10 oil are 1.04 x 10-1 Ns/m2 and 917 kg/m3 respectively. By assuming the flow is laminar, determine energy head and pressure loss due to pipe friction using Hagen-Poiseuille equation and friction factor, f.
For a discharge of 1.5 cfs, determine the head loss in each component and the total...
For a discharge of 1.5 cfs, determine the head loss in each component and the total head loss across an entire series pipe system laid out in a horizontal plane, constructed of welded steel pipe, and consisting of the following components arranged in series: 350 ft of 4-inch diameter pipe, a 90° bend, 4-inch gate valve in the fully open position, an additional 60 ft of 4-inch pipe, sudden expansion to 6-inch diameter, 350 ft of 6-inch pipe, sudden contraction...