Question

A mixing tank initially contains 3000 pounds of liquid water. The tank is fitted with two...

A mixing tank initially contains 3000 pounds of liquid water. The tank is fitted with two inlet pipes, one with hot water(90 C) delivered at a mass flow rate of 0.8 lb/s and the other with cold water (20C) delivered at a mass flow rate of 1.3 lb/s. Water exits through a single exit pipe at a mass flow rate of 2.6 lb/s.

What is the temperature of the water delivered by the tank assuming that it was initially filled from these two inlets and the tank is well mixed? Neglect heat loss to the surrounding.Does this change over time?

Homework Answers

Answer #1

yes, it changes with time. this is because, rate of exit is more than what is entering into it, therfore the level inside the tank will be decreasing with time. rate of cold water flowing into the tank is more than hot one. average temperature inside the tank is 46.66 degrees and because the water whose temperature is less than average is dominant, the temperature inside the tank will decrease with time.

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
An initially empty, well insulated, rigid tank with a volume of 2 m3 is fitted with...
An initially empty, well insulated, rigid tank with a volume of 2 m3 is fitted with a mixing device. The tank has two inlets and zero outlets. One inlet is water at 1 MPa and 600◦C while the other is saturated liquid water. Both enter the tank slowly. If the amount of work done by the mixing device is 300 kJ, what must the temperature of the saturated liquid water be if the same mass is added through both inlets...
A tank having a volume of 0.85 m^3 initially contains water as a two-phase liquid vapor...
A tank having a volume of 0.85 m^3 initially contains water as a two-phase liquid vapor mixture at 260 C and a quality of 0.7. Saturated water vapor at 260 C is slowly withdrawn through a pressure-regulating valve at the top of the tank as energy is transferred by heat to maintain the pressure constant in the tank. This continues until the tank is filled with saturated vapor at 260 C. Determine the amount of heat transfer in kJ. Neglect...
1. A feedwater heater operating at steady state has two inlets and one exit. At inlet...
1. A feedwater heater operating at steady state has two inlets and one exit. At inlet 1, water vapor enters at p1 = 7 bar, T1 = 200oC with a mass flow rate of 40 kg/s. At inlet 2, liquid water at p2 = 7 bar, T2 = 40oC, density = 992.260 kg/m3 enters through an area A2 = 25 cm2. Liquid water at 7 bar with a density of 902.527 kg/m3 exits at exit 3 with a volumetric flow...
A 110 gallon tank initially contains 5 lbs salt dissolved in 60 gallons of water. Brine...
A 110 gallon tank initially contains 5 lbs salt dissolved in 60 gallons of water. Brine containing 1 lb salt per gallon begins to flow into the tank at the rate of 3 gal/min and the well-mixed solution is drawn off at the rate of 1 gal/min. How much salt is in the tank when it is about to overflow? (Round your answer to the nearest integer.)
A cylindrical tank of cross-sectional area equal to A has one inlet where water is flowing...
A cylindrical tank of cross-sectional area equal to A has one inlet where water is flowing in, and no exits. The mass flow rate going into the tank is represented with. The height ?of the water inside the tank is represented by L, which is increasing with time. a. Use the general conservation of mass equation to show that the following equation is true for this problem (assuming that density varies with time):1??/???+1??/???=?/???. Include all steps. b. For the same...
1. Calculate the thermoeconomic cost of the produced electricity using the internal combustion device described in...
1. Calculate the thermoeconomic cost of the produced electricity using the internal combustion device described in homework 7. with and without the heat exchanger. Use the results you calculated to answer this question. This question is focusing on the thermoeconomic costs. The electricity is produced for 10 hours a day, five days per week during a one year cycle. The following cost information is given for the internal combustion device. The cost of the device is $125,000 and it has...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT