Question
A heat pump maintains a heated space at 22°C on a day when the outdoor air...
A heat pump maintains a heated space at 22°C on a day when the outdoor air temperature is 0 °C The heating requirement of the heat pump is 100,000 KJ/h, ad the power consumed by the pump is 5 KW. Calculate the heat extracted by the pump from the outside air in KJ/h. and determine the coefficient of performance of the heat pump.Calculate the maximum coefficient of performance for the heat pump.Does the heat pump above violates the 2nd law of Thermodynamics?
Homework Answers
Answer #1
Not the answer you're looking for?
Similar Questions
A house is heated and maintained at 25oC by a heat pump. If the air is...
A house is heated and maintained at 25oC by a heat
pump. If the air is extracted from outside atmosphere at
10oC, the maximum possible COP is most likely:
a.) 8.51
b.) 19.87
c.) 4.58
d.) 11.92
Thermodynamics
A heat pump is used in place of a furnace for heating a house. In winter,...
A
heat pump is used in place of a furnace for heating a house. In
winter, when outside air temperature is 15F, the heat loss from the
house is 100,000 btu/h. The inside is maintained at 70F.
Find the Carnot COP, the minimum electric power required to
operate the heat pump in kW, and the actual electric power to
operate the heat pump with a COP of 3.
An ideal heat pump is used to heat a room that is at 300 K. The...
An ideal heat pump is used to heat a room that is at 300 K. The
outdoor temperature is 263 K. Recall that for a heat pump, ????????
= ?? ??−?? .
a. If the ? = 300 J, calculate the heat pumped into the room. (2
pts) ?? =______________ J
b. Calculate the heat extracted from the outside air. (1 pts) ??
= _____________J
c. Calculate the entropy change in the outside air. (2 pts)
Δ???? = ____________ J/K...
A heat pump will be used to heat a building where the average outside temperature is...
A heat pump will be used to heat a building where the average
outside temperature is -1 degrees. There is a constant 80000 kJ / h
heat loss from the building and it is desired that the building
interior temperature is 20 degrees. The minimum power requirement
of the heat pump operating according to the Reverse
Carnot cycle is 10 kilowatts. According to this;
a) Find the heating effect coefficient of the
heat pump.
b) Since the unit...
A heat pump is used to keep a house warm at 22∘C. How much work is...
A heat pump is used to keep a house warm at 22∘C.
How much work is required of the pump to deliver 3000 J of heat
into the house if the outdoor temperature is 0∘C. Assume a COP of
3.0
How much work is required of the pump to deliver 3000 J of heat
into the house if the outdoor temperature is -15∘C? Assume a COP of
3.0
How much work is required of the pump to deliver 3000 J...
A heat pump that supplies energy to a house at a rate of 8000 kJ/h for...
A heat pump that supplies energy to a house at a rate of 8000
kJ/h for each kW of electric power it draws. a. Determine the COP.
(Points 7) b. Determine the rate of energy absorption from the
outdoor air (MJ/h). (Points 8)
Note: could you plz explain little about it rather than just
solving it
A geothermal heat pump is used in winter for space heating by getting heat from the...
A
geothermal heat pump is used in winter for space heating by getting
heat from the ground at 15 °C. The working fluid in the heat pump
is R134a. The compressor inlet is at 400 kPa and the compressor
exit is at 2 MPa and 60 C. The mass flow rate of the refrigerant is
0.1 kg / s and the temperature difference in the air flow in the
condenser section is 12 C. The refrigerant is subcooled to 15...
1) A nozzle is a device for increasing the velocity of a steadily flowing stream of...
1) A nozzle is a device for increasing the velocity of a
steadily flowing stream of fluid. At the inlet to a certain nozzle
the enthalpy of the fluid is 3025 kJ/kg and the velocity is 60 m/s.
At the exit from the nozzle the enthalpy is 2790 kJ/kg. The nozzle
is horizontal and there is negligible heat loss from
it.
(i) Find the velocity at the nozzle exit.
(ii) If the inlet area is 0.1 m2 and specific volume...
1) 20 kg/min water at 20º C is mixed adiabatically with 40 kg/min water at 80...
1) 20 kg/min water at 20º C is mixed adiabatically with 40
kg/min water at 80 ºC. What is the outlet water temperature?
Select one:
a. 80 °C
b. 60 °C
c. 50 °C
d. 70 °C
2)
Steam at 0.8 MPa and 500 ºC is throttled over a well insulated
valve to 0.6 MPa, what is the outlet temperature
Select one:
a. 450 ºC
b. 500 ºC
c. DOF>0
d. 400 ºC
3)
Humid air at 70 C and...
ADVERTISEMENT
Need Online Homework Help?
Get Answers For Free
Most questions answered within 1 hours.
ADVERTISEMENT
Active Questions
asked 18 minutes ago
asked 27 minutes ago
asked 33 minutes ago
asked 46 minutes ago
asked 47 minutes ago
asked 49 minutes ago
asked 1 hour ago
asked 1 hour ago
asked 1 hour ago
asked 1 hour ago
asked 1 hour ago
asked 1 hour ago