Question

a cylindrical pressure vessel with an outside diameter of 1000 mm is constructed be spirally wrapping...

a cylindrical pressure vessel with an outside diameter of 1000 mm is constructed be spirally wrapping a 15 mm thick steel plate and butt-welding the mating edges of the plate, the butt-welded seams form an angle of 30 with a transverse plane through the cylinder as shows . if the allowable normal stress perpendicular to the weld and the allowable shear stress parallel to the weld are 40 MPa and 15 MPa a respectively, determine the permissible internal pressure in the vessel if the factor of safety of 2 is applied

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
A cylindrical pressure vessel has a thickness of 10mm. The diameter of the pressure vessel is...
A cylindrical pressure vessel has a thickness of 10mm. The diameter of the pressure vessel is 450mm and its length is 2m. determine maximum internal pressure that can be applied if the longitudnal stress is limited to 200 MPA and the circumferential stress is limited to 80 MPA. Also find the allowable strain produced as a result of applied pressure if the Poisson ratio 0.3?
WITH COMPLETE SOLUTION A welded steel girder having the cross section of two fabricated 280 mm...
WITH COMPLETE SOLUTION A welded steel girder having the cross section of two fabricated 280 mm x 25 mm flange and a 600 mm x 15 mm web plate. The plates are joined by four fillet welds that run continuously for the length of the 6 m span girder. Each weld has an allowable load of 330 kN/m. 1.Determine the maximum allowable shear force V for the girder in kN. 2. Calculate the maximum bending stress of the girder if...
A cylindrical steel pressure vessel 30 cm in diameter and 1.5 cm thick contains a small...
A cylindrical steel pressure vessel 30 cm in diameter and 1.5 cm thick contains a small surface crack, oriented normally in the direction of the hoop stress. (a) Confirm that there is a leak condition before rupture, since the container experiences a cyclic gas pressure between 40 and 50 MPa and the fracture resistance of the material is 180 MPa√m. (b) At the point where the crack broke the wall thickness, calculate the rate of advance of the fatigue crack....
b. A cylindrical pressure vessel that is used for chemical processing is routinely pressurized to 26...
b. A cylindrical pressure vessel that is used for chemical processing is routinely pressurized to 26 MN m-2 . The vessel has a mean diameter of 1.6 m and a wall thickness of 0.095 m, and is constructed from welded plates of material with a UTS of 565 MN m-2 and a yield strength of 460 MN m-2 i.Calculate the maximum stress at full pressure that could drive the growth of a crack. ii.State, with justification, whether or not the...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT