Question

a distribution feeder feeds loads at a given voltage drop the length of the feeder is...

a distribution feeder feeds loads at a given voltage drop the length of the feeder is 15 km with 11 KV at the same voltage drop the voltage of this feeder decrease to 8 KV. what is the new distance for supplying the same power?

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
A power line feeds the customers. The length of the line is 400 m. At every...
A power line feeds the customers. The length of the line is 400 m. At every 10 m, 4 Amper consumed as three-phase current. Also, a three-phase consumer consumes 8 Amper in the middle of the line. Calculate the maximum voltage drop on the line. The feeder voltage is 380 Volt. (q = 3x25 mm2 , electrical conductivity of copper is 56 m/ohm.mm2 )
2. A power line feeds the customers. The length of the line is 400 m. At...
2. A power line feeds the customers. The length of the line is 400 m. At every 10 m, 4 Amper consumed as three-phase current. Also, a three-phase consumer consumes 8 Amper in the middle of the line. Calculate the maximum voltage drop on the line. The feeder voltage is 380 Volt. (q = 3x25 mm2 , electrical conductivity of copper is 56 m/ohm.mm2 )
A power line feeds the customers. The length of the line is 400 m. At every...
A power line feeds the customers. The length of the line is 400 m. At every 10 m, 4 Amper consumed as three-phase current. Also, a three-phase consumer consumes 8 Amper in the middle of the line. Calculate the maximum voltage drop on the line. The feeder voltage is 380 Volt. (q = 3x25 mm2 , electrical conductivity of copper is 56 m/ohm.mm2 )
A 2-wire d.c. distributor AB is fed at both ends at the same voltage of 230...
A 2-wire d.c. distributor AB is fed at both ends at the same voltage of 230 V. The length of the distributor is 500 meters and the loads are tapped off from the end A as shown below: Load: 100 A 60 A 40 A 100 A Distance: 50 m 150 m 250 m 400 m If the maximum voltage drop of 5.5 V is to be allowed, find the X-sectional area of each conductor and point of minimum potential....
Problem 9:   The hydroelectric generators at the Hoover Dam can produce a maximum current of 8.00...
Problem 9:   The hydroelectric generators at the Hoover Dam can produce a maximum current of 8.00 × 103 A at 250 kV. Part (a) What is the maximum power output of the generators, in watts? Pmax=_____ Part (b) The water that powers the generators enters and leaves the system at a low speed (thus we can neglect its change of kinetic energy) and loses 160 m of altitude during the process. What is the water flow required, in cubic meters...
71. On a low-voltage luminaire rated 30 volts or less, the output circuit of the power...
71. On a low-voltage luminaire rated 30 volts or less, the output circuit of the power supply shall be limited to a maximum of _____ amperes. A. 15 B. 20 C. 25 D. 30 72. What is the minimum distance, in inches, a receptacle face must project beyond a metal face plate? A. 0.015 B. 0.020 C. 0.025 D. 0.030 73. "Life safety branch" is a sub system of the emergency power system required in a ______. A. Hazardous area...
A doctor examines a mole with a 20 cm focal length magnifying glass held 15 cm...
A doctor examines a mole with a 20 cm focal length magnifying glass held 15 cm from the mole. (a) Find the image distance. (b) What is its magnification? (c) How big is the image of 8 mm diameter mole? (d) Draw a labelled ray diagram for the questions above (a to c). (e) Find the power of the magnifying glass. (f) Find the index of refraction of the material of the magnifying glass if the wavelength of light in...
29. Where the outside feeder disconnecting means consists of more than one switch or circuit breaker,...
29. Where the outside feeder disconnecting means consists of more than one switch or circuit breaker, determining the rating of the disconnecting means shall be permitted to be done by _____. A. Adding all circuit breakers and dividing by 2 B. Adding connected load and dividing by 1732 C. Combining the ratings of all the switches or circuit breakers D. Calculating the load by taking the first 3,000 VA at 100 percent 30. A 480/240 Volt, Step-down transformer with a...
Question 10 of 20 Which of the following explains why international travelers need to use special...
Question 10 of 20 Which of the following explains why international travelers need to use special adapters when plugging a device designed to operate in the U.S. into a wall outlet in Europe (i.e., Vrms in the U.S. is 120 V, while Vrms in Europe is 240 V)?             The increased voltage causes the device's resistance to increase, and the device won't work.             The increased voltage causes the device's resistance to decrease, and the device will overheat.             The...
A. The human eye 1. Whenever a normal eye forms an image, the image distance will...
A. The human eye 1. Whenever a normal eye forms an image, the image distance will always equal the distance from the cornea and eye lens to the retina (~25 mm), regardless of how far away the object is located. Explain why the image distance cannot change. 2. If the image distance must change, then what intrinsic property of the eye lens must change in order for the eye to focus on objects at different distances? Hint: read the Introduction....