Question

Each line of a 3-phase system is suspended by a string of 3 similar insulators. If...

Each line of a 3-phase system is suspended by a string of 3 similar insulators. If the voltage across the
line unit is 17·5 kV, calculate the line to neutral voltage and string efficiency. Assume that shunt capacitance
between each insulator and earthed metalwork of tower to be 1/10th of the capacitance of the
insulator.

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
A 3 phase system, 33 kv with the conductor suspended by insulating string three insulators. The...
A 3 phase system, 33 kv with the conductor suspended by insulating string three insulators. The capacitance of each insulator disc is ten times the capacitance to ground. calculate: a) the voltage across each insulator b) string efficiency
Problem 2. A three phase transformer rated at 5 MVA, 115/13.2 kV has a per phase...
Problem 2. A three phase transformer rated at 5 MVA, 115/13.2 kV has a per phase series impedance of 0.007 + j0.075 per unit (shunt parameters are ignored). The low voltage side is connected to a short distribution line which modeled by a series per phase impedance of 0.02 +j0.1 per unit on the base of 10 MVA. The line supplies a balanced three phase constant impedance load at 4 MVA, 13.2 kV with power factor of 0.85 lagging •...
A 3-phase, Y-connected 4-wire system with grounded neutral carrying 60 A at 60 Hz per phase...
A 3-phase, Y-connected 4-wire system with grounded neutral carrying 60 A at 60 Hz per phase when balanced has 3rd harmonic current. The harmonic current is measured at 3 A/phase. a. For this system to remain without voltage distortion, what must be the current that the neutral carries to ground? (Easy answer.) b. The 3rd harmonic frequency is 180 Hz. If there is reactance XL = 2 Ω/phase in the line, what is the per phase capacitance (mF) of a...
•The 3-phase system consists of a generator, circuit breaker, power transformer and extra high voltage transmission...
•The 3-phase system consists of a generator, circuit breaker, power transformer and extra high voltage transmission line. •The generator is rated at 60Hz, 1559Mva and 24kV. The sub-transient reactance is 2*%. The winding connection is wye with the neutral grounded. •The transformer is a 1550Mva, 3-phase, shell type, 2-winding transformer with a 24kV delta winding and a 525kV grounded wye winding. Neglect saturation and core losses. The exciting current is 1.0% of the rated current. The capacitance of each low...
THESE ARE QUESTION FROM THE TOPIC POWER FACTOR IMPROVEMENT FROM THE SUBJECT POWER SYSTEM FUNDAMENTALS PLEASE...
THESE ARE QUESTION FROM THE TOPIC POWER FACTOR IMPROVEMENT FROM THE SUBJECT POWER SYSTEM FUNDAMENTALS PLEASE DO THE QUESTIONS STEP BY STEP AND IN NEAT HAND WRITTING THE ANSWERS ARE GIVEN WITH THE QUESTIONS 1) 1. What should be the kVA rating of a capacitor which would raise the power factor of load of 100 kW from 0·5 lagging to 0·9 lagging    ANS (125 KVA) 2)    A 3-phase, 50 Hz, 3300 V star connected induction motor develops 250 H.P....
3. Gains from trade Consider two neighboring island countries called Dolorium and Arcadia. They each have...
3. Gains from trade Consider two neighboring island countries called Dolorium and Arcadia. They each have 4 million labor hours available per month that they can use to produce rye, jeans, or a combination of both. The following table shows the amount of rye or jeans that can be produced using 1 hour of labor. Country Rye Jeans (Bushels per hour of labor) (Pairs per hour of labor) Dolorium 5 20 Arcadia 8 16 Initially, suppose Arcadia uses 1 million...
1) A nozzle is a device for increasing the velocity of a steadily flowing stream of...
1) A nozzle is a device for increasing the velocity of a steadily flowing stream of fluid. At the inlet to a certain nozzle the enthalpy of the fluid is 3025 kJ/kg and the velocity is 60 m/s. At the exit from the nozzle the enthalpy is 2790 kJ/kg. The nozzle is horizontal and there is negligible heat loss from it. (i) Find the velocity at the nozzle exit. (ii) If the inlet area is 0.1 m2 and specific volume...
1) Describe an example of each of the following that may be found of your kitchen:...
1) Describe an example of each of the following that may be found of your kitchen: Explain how your choice falls into this category, and if there is a chemical name or symbol for it, provide that as well. Provide a photo of your example with your ID card in it. a) a compound b) a heterogeneous mixture c) an element (symbol) Moving to the Caves… Lechuguilla Caves specifically. Check out this picture of crystals of gypsum left behind in...
Can you paraphrase the following rationale for me: Male Reproductive System 1. Which of the following...
Can you paraphrase the following rationale for me: Male Reproductive System 1. Which of the following accurately describes spermiogenesis? a. Occurs before puberty b. Involves stem cells, meiosis, and spermatogenesis c. Involves cytodifferentiation of early spermatids d. Occurs in diploid cells e. Results in the formation of primary spermatocytes Rationale: Spermatogenesis, the first part of sperm production involves mainly mitosis and meiosis and is followed by spermiogenesis, the final differentiation process occurring in the haploid male germ cells. Spermatogenesis begins...
for the scenario below: 1) Apply the qualitative analysis by identifying at least 3 issues in...
for the scenario below: 1) Apply the qualitative analysis by identifying at least 3 issues in the above process. Analyse these issues by using a. Adding-value and Waste Analysis b. Issue register, If you find that there are more than three issues, you can focus on the three issues that have the highest impact. 2). Calculate the cycle time efficiency of the as-is process. You can assume a working week of 40 hours. In case there is missing information, you...