Question

1. Design a full-wave bridge rectifier power supply to deliver an average voltage of 9V with...

1. Design a full-wave bridge rectifier power supply to deliver an average voltage of 9V with a peak-to-peak riple of 2V to a load. The average load current is 100 mA. Assume that ideal diodes and 60-Hz ac volatage sources of any amplitudes needed are avaialable. Draw the circuit diagram for your design, Specify the values of all components used.

2. Repeat Problem 1 with 2 diodes and out-of-phase voltage sources to form a full-wave rectifier.

Engineering   Electrical-Engineering   
0 0
Add a commentTranscribed image text
Next >

Homework Answers

Answer #1

0 0
Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Log In

Sign Up

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
Full wave rectifier is used to design a DC power supply. The DC power supply has...
Full wave rectifier is used to design a DC power supply. The DC power supply has an average output voltage of 12v on which the maximum ripple allowed is 1v (peak to peak). The rectifier feeds a load of 200ohm . The rectifier is supplied from 170v at 60 hz ac line through a transformer. Assume Vy= 0.7v . a) Find the transformer tarns ratio? b) Find the required value of the capacitor? c) Specify the PIV rating of the...
Design a full-wave bridge rectifier circuit to deliver 10 volts DC with less than 0.1 volt...
Design a full-wave bridge rectifier circuit to deliver 10 volts DC with less than 0.1 volt peak-to-peak ripple into a 1 k load. Assume a 60 Hz input sin wave.
Design and simulate a Half and Full wave rectifier for a 12V AC supply with 60...
Design and simulate a Half and Full wave rectifier for a 12V AC supply with 60 Hz frequency.
The controlled full wave rectifier is connected to the grid. The rms grid voltage is 230...
The controlled full wave rectifier is connected to the grid. The rms grid voltage is 230 Volt at 50 Hz. 24 Volt battery will be charged with 15A. An inductor, which is series connected to the battery, is used to limit the current ripple. Only The second harmonics of the output voltage is taken into account. The inductor R/L ratio is 50. The current ripple is allowed to be 4 amp peak to peak. Determine the firing angle and R...
Your group has been asked to design a portion of a power supply which reduces the...
Your group has been asked to design a portion of a power supply which reduces the variation due to ripple from the rectifier stage. The completed power supply is intended to provide 300W of 48V DC power to an RF transmitter. The transformer stage transforms a 3-phase AC power source at 60 Hz from 120 V RMS to 50V RMS, which is rectified before being applied to your circuit. You are designing the regulator, not the rectifier. The input to...
Design a DC power supply that will deliver 100mA of current to a load with a...
Design a DC power supply that will deliver 100mA of current to a load with a ripple of 5%. Use a full wave rectifier and a 17 Peak Voltage Source with F= 60 Hz. Load resistance = 1k So Basically you just need to find the capacitance of the filtering capacitor. Please tell me how. This is what I did, but I think I'm wrong. The Vripple I got is (.05)*17 = .85 V. Then according to my manual, C...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT