Question

A 660W electric heater operates at 120V. What is the resistance? What intensity of current flows...

A 660W electric heater operates at 120V. What is the resistance? What intensity of current flows through the resistance? What is the amount of heat developed in [Cal/s]? If the line voltage drops to 110V, what power will the heater absorb in W? Suppose R = constant

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
During 3.2 hours of operation, a charge of 72 kC flows through an electric space heater,...
During 3.2 hours of operation, a charge of 72 kC flows through an electric space heater, while the heater generates heat at a rate of 1.5kJ/s. The heater is connected to a constant DC voltage source. Assume that the heating wire inside the heater has a circular cross-section of a 0.5 mm radius and is made of a material with a resistivity of 490 *10^-9m. How long is the wire?
An electric current of 1 A flows for 10 s in a reservoir of resistance 25...
An electric current of 1 A flows for 10 s in a reservoir of resistance 25 W which is submerged in a large volume of water, the temperature of which is 280 K. Calculate (a) the change in the entropy of the resistance, and (b) the change in the entropy of the water.
When a current I(measured in amperes) flows through a resistance R(measured in ohms), the power generated...
When a current I(measured in amperes) flows through a resistance R(measured in ohms), the power generated is given by W = I^2R (measured in watts). Suppose that I and R are independent random variables with densities: f(i) = 6i(1-i) for 0 < i < 1 f(r) = 2r for 0 < r < 1 Determine the pdf of W
A heater dissipates 1900 W  of power when it is connected to a 100 V  battery. Part A...
A heater dissipates 1900 W  of power when it is connected to a 100 V  battery. Part A What current will flow through the heater when it is connected to the battery? Part B What is R, the resistance of the heater? Part C How long does it take to raise the temperature of the air in a good-sized living room that is 6.00 m  × 6.00 m  × 10.0 m by 10.0∘C? Note that the specific heat of air is 1006...
1)Electrical resistance for a wire of any size can be calculated using the relation: R =...
1)Electrical resistance for a wire of any size can be calculated using the relation: R = pL/A where R = resistance ?, p = resistivity (?-cm), L = wire length (cm), p = 112 u? cm. For a 10-m length of 16-gauge (diameter = 1.291 mm) nichrome wire, find the resistance. If a current of 4 A flows in the wire, find the voltage drop and power dissipation. 2)A standard power value for a household incandescent lightbulb is 60 W....
The resistivity of copper is 1.68 x 10-8 W-m.  The resistance per unit length (R/L) of a...
The resistivity of copper is 1.68 x 10-8 W-m.  The resistance per unit length (R/L) of a certain copper cable is 1.61 x 10-5W/m. (a) What is the cross sectional area of the cable? (b) The above cable is used to transmit electricity from a power station to an electrical substation 42.8 km distant.  If the voltage at the substation is 2480 V, what is the required voltage at the power station when the current running through the cable is 856 A?...
A small dry-cell battery of zinc, ammonium chloride, and MnO2 weighing 85 g will operate continuously...
A small dry-cell battery of zinc, ammonium chloride, and MnO2 weighing 85 g will operate continuously through a 4-ohm resistance for 450 min before its voltage falls below 0.75V. The initial voltage is 1.60, and the effective voltage over the whole life of the battery is taken to be 1.00V. How much work is obtained from the battery, in Joules? How many moles of Zn are converted to ZnCl2 in this process, and what is the weight of this amount...
2. If a current of 3 Adc flows in the series field winding of your motor,...
2. If a current of 3 Adc flows in the series field winding of your motor, what would the resultant voltage drop be? 3. If the rheostat were connected in series with the shunt field winding and the combination placed across a 120 Vdc line, what shunt field current variations could be obtained from your motor?             I minimum = Adc      I maximum = Adc 4. All of the windings and even the commutator of your motor are made of...
1. What is the resistance of a NichromeTM wire at 0.0 ∘C∘C if its resistance is...
1. What is the resistance of a NichromeTM wire at 0.0 ∘C∘C if its resistance is 106.9 ΩΩ at 12.5 ∘C∘C? The temperature coefficient of resistivity for NichromeTM is 4.00×10−4 (∘C)−1(∘C)−1 . Enter your answer with four significant figures. 2. A heart defibrillator is used to enable the heart to start beating if it has stopped. This is done by passing a large current of 12 AA through the body at 30 VV for a very short time, usually about...
1.What famous royal figure attended a formal lecture given by Michael Faraday in the lat 1700’s...
1.What famous royal figure attended a formal lecture given by Michael Faraday in the lat 1700’s at the Royal Institute? 2. The metropolitan water district supplies power to what major US city? 3. One Ampere is one Coulomb of charge flowing through a circuit in how many seconds? 4. Oerstead used the current flowing in a wire due to a voltaic pile to show the link between electricity and magnetism, today simply known as _________________________. 5. Wheatstone and Ohm showed...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT