Question

what is the RMS value of a 169 volt peak, 60 hertz sine wave? What is...

what is the RMS value of a 169 volt peak, 60 hertz sine wave?

What is the average value of that same waveform?

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
a)Draw a sine wave and point out the Amplitude, Peak Amplitude, Peak-to-Peak Amplitude, and the period...
a)Draw a sine wave and point out the Amplitude, Peak Amplitude, Peak-to-Peak Amplitude, and the period of the wave. b) What is the formula for a sine wave? – the Period and the Frequency? c) Draw two sine waves where one is 90 deg phase shifted from the other and label the leading and lagging wave. Why are sine waves important in electronics?
If an AC signal has an RMS Voltage of 1 V. What is the peak-to-peak and...
If an AC signal has an RMS Voltage of 1 V. What is the peak-to-peak and average value of the signal?
In MATLAB create a sine wave with slow varying frequency. The average freqeuncy is 20hz. The...
In MATLAB create a sine wave with slow varying frequency. The average freqeuncy is 20hz. The slow frequency is 1Hz. The [f min, fmax] = [15, 25]Hz. Plot the waveform, power spectrum, and spectrogram.
The controlled full wave rectifier is connected to the grid. The rms grid voltage is 230...
The controlled full wave rectifier is connected to the grid. The rms grid voltage is 230 Volt at 50 Hz. 24 Volt battery will be charged with 15A. An inductor, which is series connected to the battery, is used to limit the current ripple. Only The second harmonics of the output voltage is taken into account. The inductor R/L ratio is 50. The current ripple is allowed to be 4 amp peak to peak. Determine the firing angle and R...
Design a full-wave bridge rectifier circuit to deliver 10 volts DC with less than 0.1 volt...
Design a full-wave bridge rectifier circuit to deliver 10 volts DC with less than 0.1 volt peak-to-peak ripple into a 1 k load. Assume a 60 Hz input sin wave.
Question 6 (1 point) The derivative of a sine wave is a maximum at the peak...
Question 6 (1 point) The derivative of a sine wave is a maximum at the peak amplitude of the waveform. Question 6 options: True False Save Question 7 (1 point) The voltage across an inductor leads the current through it by 90%. Question 7 options: True False Save Question 8 (1 point) The length of a phasor is called the modulus or magnitude. Question 8 options: True False Save Question 9 (1 point) Which one of the following values is...
Suppose we listen to a 500 Hz sine wave at an SIL of 20 dB. At...
Suppose we listen to a 500 Hz sine wave at an SIL of 20 dB. At what SIL would a 60 Hz sine wave be perceived to be as loud as the 500 Hz sine wave?
Suppose we listen to a 500 Hz sine wave at an SIL of 20 dB. At...
Suppose we listen to a 500 Hz sine wave at an SIL of 20 dB. At what SIL would a 60 Hz sine wave be perceived to be as loud as the 500 Hz sine wave? Group of answer choices 70 dB SIL 20 dB SIL 35 dB SIL 50 dB SIL 90 dB SIL Suppose you record an electric bass guitar and a singer at a concert. Then you go home and listen to your recording at an SIL...
Compute a value of pi using the fourier swries representation of a sine wave. In addition,...
Compute a value of pi using the fourier swries representation of a sine wave. In addition, compute the rate of convergence.
1.) A 2k resistor has a peak voltage of 10 v applied to it, calulate the...
1.) A 2k resistor has a peak voltage of 10 v applied to it, calulate the instantaneous value of current at 62 degrees? 2.) A sine wave with a peak value of 120 v has an rms value of? 3.) A 0.047 uF capacitor will provide 100k of reactance at ___ Hz? 4.)what is the Xc if a 120 V 60Hz source is connected to a capacitor and the IC is Equal to 0.12 A? 5.) A 60 uH inductor...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT