Question

In a full wave rectifier does the positive half cylce produce an output dc voltage or...

In a full wave rectifier does the positive half cylce produce an output dc voltage or is the ouput dc voltage only produced at the negative half cycle ?

Homework Answers

Answer #1

Full wave rectifier means the entire wave (positive as well as negative half) is converted to DC.

So, Both the positive half and negative half are responsible for the output voltage.

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
True or false: Half wave and full wave rectifier circuits convert sinusoidal signal to approximaste dc...
True or false: Half wave and full wave rectifier circuits convert sinusoidal signal to approximaste dc signal.
1-Draw the schematics of a full-wave rectifier circuit without smoothing capacitor. Sketch the input and output...
1-Draw the schematics of a full-wave rectifier circuit without smoothing capacitor. Sketch the input and output voltage waveforms? 2- Draw the schematics of a full-wave rectifier circuit with smoothing capacitor. Sketch the input and output voltage waveforms?
The controlled full wave rectifier is connected to the grid. The rms grid voltage is 230...
The controlled full wave rectifier is connected to the grid. The rms grid voltage is 230 Volt at 50 Hz. 24 Volt battery will be charged with 15A. An inductor, which is series connected to the battery, is used to limit the current ripple. Only The second harmonics of the output voltage is taken into account. The inductor R/L ratio is 50. The current ripple is allowed to be 4 amp peak to peak. Determine the firing angle and R...
Design and simulate a Half and Full wave rectifier for a 12V AC supply with 60...
Design and simulate a Half and Full wave rectifier for a 12V AC supply with 60 Hz frequency.
Design a full-wave bridge rectifier circuit to deliver 10 volts DC with less than 0.1 volt...
Design a full-wave bridge rectifier circuit to deliver 10 volts DC with less than 0.1 volt peak-to-peak ripple into a 1 k load. Assume a 60 Hz input sin wave.
1. Design a full-wave bridge rectifier power supply to deliver an average voltage of 9V with...
1. Design a full-wave bridge rectifier power supply to deliver an average voltage of 9V with a peak-to-peak riple of 2V to a load. The average load current is 100 mA. Assume that ideal diodes and 60-Hz ac volatage sources of any amplitudes needed are avaialable. Draw the circuit diagram for your design, Specify the values of all components used. 2. Repeat Problem 1 with 2 diodes and out-of-phase voltage sources to form a full-wave rectifier.
Develop an expression for current in a controlled half-wave rectifier circuit that has a load consisting...
Develop an expression for current in a controlled half-wave rectifier circuit that has a load consisting of a series Resitor R and dc voltage VDC. The source is vs=Vm sin wt, and the delay angle is alpha. (a) Determine the average current if Vm=100 V,R=100 ohms, Vdc=24 V,w= 2p60 rad/s, and alpha= 75°.
For three-phase, Full-wave, Semi-controlled rectifier, sketch the waveforms for following at firing angle Alpha = 90...
For three-phase, Full-wave, Semi-controlled rectifier, sketch the waveforms for following at firing angle Alpha = 90 and over-lap angle Gama = 10 Gama of the diode = 10 Gama of the Thyristor=5 a- The positive and negative voltage relative to neutral. b- The input current for phase (a) Gama diode 10 Gama Thyristor 5 Sketeh a and b
In a full-wave rectifier with two diodes, calculate a) The value of V0, I0 b) Vr...
In a full-wave rectifier with two diodes, calculate a) The value of V0, I0 b) Vr and R.F c) Draw the complete circuit with proposed data and calculated data Consider that the voltage of the secondary of the transformer is 30 V, the diodes are IN4003, the capacitor C1 is 1000 Nf and Rl is 100 Ω
One of the important blocks of a power supply is the Rectifier. For instance, a Full...
One of the important blocks of a power supply is the Rectifier. For instance, a Full wave rectifier is excited by a sinusoidal waveform xsinωt. In this connection, obtain the first five realizable components of the output using Fourier series in addition to the dc output (if any). Use sketches to represent the Fourier series outputs. Please note: Hand drawn neat sketches are sufficient. However, students can use any other software like MS-Excel, MATLAB, etc., for sketches. The value of...