Question

The controlled full wave rectifier is connected to the grid. The rms grid voltage is 230...

The controlled full wave rectifier is connected to the grid. The rms grid voltage is 230 Volt at 50 Hz. 24 Volt battery will be charged with 15A. An inductor, which is series connected to the battery, is used to limit the current ripple. Only The second harmonics of the output voltage is taken into account. The inductor R/L ratio is 50. The current ripple is allowed to be 4 amp peak to peak.

Determine the firing angle and R for the circuit, for this design.

Write the mat equations and Show the solution with detail.

A) alfa=? ( in rad )

B) R=?

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
An AC generator supplies an rms voltage of 230 V at 60.0 Hz. It is connected...
An AC generator supplies an rms voltage of 230 V at 60.0 Hz. It is connected in series with a 0.250 H inductor, a 5.60 μF capacitor and a 366 Ω resistor. What is the impedance of the circuit? Tries 0/20 What is the rms current through the resistor? Tries 0/20 What is the average power dissipated in the circuit? Tries 0/20 What is the peak current through the resistor? Tries 0/20 What is the peak voltage across the inductor?...
Design a full-wave bridge rectifier circuit to deliver 10 volts DC with less than 0.1 volt...
Design a full-wave bridge rectifier circuit to deliver 10 volts DC with less than 0.1 volt peak-to-peak ripple into a 1 k load. Assume a 60 Hz input sin wave.
It is desired to charge 24 V battery with 10 Amps from 220 Volt rms 50...
It is desired to charge 24 V battery with 10 Amps from 220 Volt rms 50 Hz network by a controlled rectifier . Determine the inductor value to be the least (min. L). Set up the circuit in proteus
An AC generator supplies an rms voltage of 120V at 60.0 Hz. It is connected in...
An AC generator supplies an rms voltage of 120V at 60.0 Hz. It is connected in series with a 160 H inductor, a 5.40 µF capacitor and 110 Ω resistor. (a) What is the impedance of the circuit? (b) What is the rms current through the resistor? (c) What is the peak voltage across the inductor? (d) What is the resonance frequency?
1. Design a full-wave bridge rectifier power supply to deliver an average voltage of 9V with...
1. Design a full-wave bridge rectifier power supply to deliver an average voltage of 9V with a peak-to-peak riple of 2V to a load. The average load current is 100 mA. Assume that ideal diodes and 60-Hz ac volatage sources of any amplitudes needed are avaialable. Draw the circuit diagram for your design, Specify the values of all components used. 2. Repeat Problem 1 with 2 diodes and out-of-phase voltage sources to form a full-wave rectifier.
A full-wave rectifier has a 120 V rms, 60 Hz ac source. The load is a...
A full-wave rectifier has a 120 V rms, 60 Hz ac source. The load is a series inductance, resistance and dc voltage source, with L = 100 mH, R = 10 Ω, and Vdc = 50 V. a). Determine an expression for load current. b). Determine the power absorbed by the dc voltage source. c). Determine the power absorbed by the resistance. d). Determine the power factor of the source.
1.An AC generator supplies an rms voltage of 220 V at 60.0 Hz. It is connected...
1.An AC generator supplies an rms voltage of 220 V at 60.0 Hz. It is connected in series with a 0.750 H inductor, a 3.50 μF capacitor and a 211 Ω resistor. What is the impedance of the circuit? You have to calculate the impedance for a series RLC-combination. 2. What is the rms current through the resistor? You can use a similar equation fo Ohm's law for an RLC circuit. 3. What is the average power dissipated in the...
A generator with rms voltage of rms = 120 V drives an RLC circuit at frequency...
A generator with rms voltage of rms = 120 V drives an RLC circuit at frequency f = 60 Hz. The load resistance R and reactance values of the inductor L and the capacitor C of the circuit are given by R = 50 , XL = 50 , XC = 150 , respectively What is the impedance of the circuit? What is the peak current amplitude in the circuit? What is the phase angle  of the circuit? The...
An AC generator supplies an rms voltage of 115 V at 60.0 Hz. It is connected...
An AC generator supplies an rms voltage of 115 V at 60.0 Hz. It is connected in series with a 0.700 H inductor, a 3.00 μF capacitor and a 266 Ω resistor. 1. What is the impedance of the circuit? Tries 0/20 2. What is the rms current through the resistor? Tries 0/20 3. What is the average power dissipated in the circuit? Tries 0/20 4. What is the peak current through the resistor? Tries 0/20 5. What is the...
Develop an expression for current in a controlled half-wave rectifier circuit that has a load consisting...
Develop an expression for current in a controlled half-wave rectifier circuit that has a load consisting of a series Resitor R and dc voltage VDC. The source is vs=Vm sin wt, and the delay angle is alpha. (a) Determine the average current if Vm=100 V,R=100 ohms, Vdc=24 V,w= 2p60 rad/s, and alpha= 75°.
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT