Question

True or false: Half wave and full wave rectifier circuits convert sinusoidal signal to approximaste dc...

True or false: Half wave and full wave rectifier circuits convert sinusoidal signal to approximaste dc signal.

Homework Answers

Answer #1

Rectifier is an electrical device which converts an alternating current into direct current by allowing a current to flow through it in one Direction only .

Half wave rectifier is a rectifier circuit which converts the alternating current into direct current using only one half cycle of input voltage the input supply may be Single Phase II multiphase

Full wave rectifier is a rectifier circuit which converts an AC voltage into DC voltage using both of cycles of the applied voltage

Therefore both Half wave and full wave rectifer circuits convert sinusoidal signal to approximate dc signal.

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
In a full wave rectifier does the positive half cylce produce an output dc voltage or...
In a full wave rectifier does the positive half cylce produce an output dc voltage or is the ouput dc voltage only produced at the negative half cycle ?
Can a controlled half-wave rectifier with a series inductance, resistance and dc source in the load...
Can a controlled half-wave rectifier with a series inductance, resistance and dc source in the load side operate as an inverter (Power direction from DC source to AC source)? Why?
Full wave rectifier is used to design a DC power supply. The DC power supply has...
Full wave rectifier is used to design a DC power supply. The DC power supply has an average output voltage of 12v on which the maximum ripple allowed is 1v (peak to peak). The rectifier feeds a load of 200ohm . The rectifier is supplied from 170v at 60 hz ac line through a transformer. Assume Vy= 0.7v . a) Find the transformer tarns ratio? b) Find the required value of the capacitor? c) Specify the PIV rating of the...
Design and simulate a Half and Full wave rectifier for a 12V AC supply with 60...
Design and simulate a Half and Full wave rectifier for a 12V AC supply with 60 Hz frequency.
Design a full-wave bridge rectifier circuit to deliver 10 volts DC with less than 0.1 volt...
Design a full-wave bridge rectifier circuit to deliver 10 volts DC with less than 0.1 volt peak-to-peak ripple into a 1 k load. Assume a 60 Hz input sin wave.
One of the important blocks of a power supply is the Rectifier. For instance, a Full...
One of the important blocks of a power supply is the Rectifier. For instance, a Full wave rectifier is excited by a sinusoidal waveform xsinωt. In this connection, obtain the first five realizable components of the output using Fourier series in addition to the dc output (if any). Use sketches to represent the Fourier series outputs. Please note: Hand drawn neat sketches are sufficient. However, students can use any other software like MS-Excel, MATLAB, etc., for sketches. The value of...
Write a Report on the following – 1) Describe waveform characteristics for sinusoidal waveforms 2) What...
Write a Report on the following – 1) Describe waveform characteristics for sinusoidal waveforms 2) What is a Diode? Explain forward and reverse biased characteristics of a diode with circuit diagrams. 3) What is a rectifier? Explain half wave and full wave rectifier with circuit diagrams.
A full-wave rectifier has a 120 V rms, 60 Hz ac source. The load is a...
A full-wave rectifier has a 120 V rms, 60 Hz ac source. The load is a series inductance, resistance and dc voltage source, with L = 100 mH, R = 10 Ω, and Vdc = 50 V. a). Determine an expression for load current. b). Determine the power absorbed by the dc voltage source. c). Determine the power absorbed by the resistance. d). Determine the power factor of the source.
Develop an expression for current in a controlled half-wave rectifier circuit that has a load consisting...
Develop an expression for current in a controlled half-wave rectifier circuit that has a load consisting of a series Resitor R and dc voltage VDC. The source is vs=Vm sin wt, and the delay angle is alpha. (a) Determine the average current if Vm=100 V,R=100 ohms, Vdc=24 V,w= 2p60 rad/s, and alpha= 75°.
1-Draw the schematics of a full-wave rectifier circuit without smoothing capacitor. Sketch the input and output...
1-Draw the schematics of a full-wave rectifier circuit without smoothing capacitor. Sketch the input and output voltage waveforms? 2- Draw the schematics of a full-wave rectifier circuit with smoothing capacitor. Sketch the input and output voltage waveforms?
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT