Question

In half wave rectifier circuit, the diode conduct for? a) one half cycle b) full cycle...

In half wave rectifier circuit, the diode conduct for?

a) one half cycle

b) full cycle

c) alternate half cycle

d) none of these

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
In a full wave rectifier does the positive half cylce produce an output dc voltage or...
In a full wave rectifier does the positive half cylce produce an output dc voltage or is the ouput dc voltage only produced at the negative half cycle ?
1-Draw the schematics of a full-wave rectifier circuit without smoothing capacitor. Sketch the input and output...
1-Draw the schematics of a full-wave rectifier circuit without smoothing capacitor. Sketch the input and output voltage waveforms? 2- Draw the schematics of a full-wave rectifier circuit with smoothing capacitor. Sketch the input and output voltage waveforms?
Full wave rectifier is used to design a DC power supply. The DC power supply has...
Full wave rectifier is used to design a DC power supply. The DC power supply has an average output voltage of 12v on which the maximum ripple allowed is 1v (peak to peak). The rectifier feeds a load of 200ohm . The rectifier is supplied from 170v at 60 hz ac line through a transformer. Assume Vy= 0.7v . a) Find the transformer tarns ratio? b) Find the required value of the capacitor? c) Specify the PIV rating of the...
True or false: Half wave and full wave rectifier circuits convert sinusoidal signal to approximaste dc...
True or false: Half wave and full wave rectifier circuits convert sinusoidal signal to approximaste dc signal.
Design and simulate a Half and Full wave rectifier for a 12V AC supply with 60...
Design and simulate a Half and Full wave rectifier for a 12V AC supply with 60 Hz frequency.
Design a full-wave bridge rectifier circuit to deliver 10 volts DC with less than 0.1 volt...
Design a full-wave bridge rectifier circuit to deliver 10 volts DC with less than 0.1 volt peak-to-peak ripple into a 1 k load. Assume a 60 Hz input sin wave.
In a full-wave rectifier with two diodes, calculate a) The value of V0, I0 b) Vr...
In a full-wave rectifier with two diodes, calculate a) The value of V0, I0 b) Vr and R.F c) Draw the complete circuit with proposed data and calculated data Consider that the voltage of the secondary of the transformer is 30 V, the diodes are IN4003, the capacitor C1 is 1000 Nf and Rl is 100 Ω
Develop an expression for current in a controlled half-wave rectifier circuit that has a load consisting...
Develop an expression for current in a controlled half-wave rectifier circuit that has a load consisting of a series Resitor R and dc voltage VDC. The source is vs=Vm sin wt, and the delay angle is alpha. (a) Determine the average current if Vm=100 V,R=100 ohms, Vdc=24 V,w= 2p60 rad/s, and alpha= 75°.
For three-phase, Full-wave, Semi-controlled rectifier, sketch the waveforms for following at firing angle Alpha = 90...
For three-phase, Full-wave, Semi-controlled rectifier, sketch the waveforms for following at firing angle Alpha = 90 and over-lap angle Gama = 10 Gama of the diode = 10 Gama of the Thyristor=5 a- The positive and negative voltage relative to neutral. b- The input current for phase (a) Gama diode 10 Gama Thyristor 5 Sketeh a and b
I want to design a full wave rectifier with bandwidth 50mHz and gain 1. What is...
I want to design a full wave rectifier with bandwidth 50mHz and gain 1. What is the circuit and component values? What type of amplifier should I use?