Question

2. AC supply voltage V= 230 Vrms at 60 Hz is connected to a RL
load of resistance, R = 10 ohms and

inductance, L= 20 mH. Predicts the current lagging and power loss
due to lagging effect.

Answer #1

A full-wave rectifier has a 120 V rms, 60 Hz ac source. The load
is a series inductance, resistance and dc voltage source, with L =
100 mH, R = 10 Ω, and Vdc = 50 V.
a). Determine an expression for load current.
b). Determine the power absorbed by the dc voltage source.
c). Determine the power absorbed by the resistance.
d). Determine the power factor of the source.

Two AC loads connected in parallel draw power from a 60 Hz,
120-Vrms source. Load 1 draws 350 W at a lagging power factor of
0.7. Load 2 draws 500 VA at a leading power factor of 0.5. a. (5)
Calculate the effective (rms magnitude) current drawn by load 1. b.
(10) Calculate the impedance of Load 1. c. (5) Calculate the total
complex power drawn by both loads combined. d. (5) Determine the PF
of the combined load. Specify...

An ac generator with an rms voltage 120 V is and a frequency of
60 Hz is connected with a 15 µF capacitor, and a 30 mH inductor and
a resistor R.
What value must R have if the rms
current in this circuit it to be 5 mA?
Calculate the rms voltage across the
resistor.

(15-17) An AC
series RL circuit has a source RMS voltage of 100 V, an inductance
of 50 mH, and a resistance of 10 W. The AC source operates at 60
Hz.
15. For this
circuit, which of the following is true?
Group of answer choices
The current leads the source voltage.
The current lags the source voltage.
The current and source voltage are in phase.
None of the above.
Which of the following for this circuit has the greater...

A single phase half wave converter in is operated from a 120 V
60 Hz supply and a freewheeling diode is connected across the load.
the load consists of series connected resistance R= 10 ohm
inductance L= 5mH and battery E=20V. Express the instantaneous
output voltage in fourirer series and determine the rms value of
the lowest order output harmonic current.

1. An ac generator has a frequency of 2.5 kHz and a voltage of
240 V. An inductance L1 = 6.0 mH is connected across its terminals.
Then a second inductance L2 = 8.0 mH is connected in parallel with
L1. Find (a) the current that the generator delivers to L1
2. A 8.3-mH inductor is connected to an ac generator (11 V rms,
750 Hz). Determine the peak value of the current supplied
by the generator. Note: The ac...

In RLC series circuit, an AC source with a rms voltage of 220 V
and frequency 60 Hz is connected to a resistor, a capacitor 65 µF
and an inductor of inductance 185 mH. If the observed current is
4.4 A, evaluate the resistance of the resistor.

An AC generator supplies an rms voltage of 230 V at 60.0 Hz. It
is connected in series with a 0.250 H inductor, a 5.60 μF capacitor
and a 366 Ω resistor.
What is the impedance of the circuit?
Tries 0/20
What is the rms current through the resistor?
Tries 0/20
What is the average power dissipated in the circuit?
Tries 0/20
What is the peak current through the resistor?
Tries 0/20
What is the peak voltage across the inductor?...

An AC source has a frequency f = 1200 HZ and peak voltage 3.5 V.
It is connected in series to a resistor resistance R = 15 Ohms, an
inductor of inductance L = 5 mH and a capacitor of capacitance C =
2 microfarads.
How would you optimize the power factor ( make it equal to
1)?
a. Add a capacitor in series with the existing
one
b. Add a capacitor in parallel with the existing
one
c. Add a capacitor in...

Three loads are connected in parallel across a 1500 Vrms - 60
hz. Load 1 absorbs 23 kW and 14 kVAr capacitive. Load 2 absorbs 70
kVA with power factor 0.7 lagging. Load 3 absorbs 22kW with power
factor = 1. Find: a) Complex impedance, seen from power source b)
Power Factor of the setup and module of Rms current supplied by the
source c) Complex impedance of Load 2 d) Value of capacitor to be
connected to the combination...

ADVERTISEMENT

Get Answers For Free

Most questions answered within 1 hours.

ADVERTISEMENT

asked 23 minutes ago

asked 40 minutes ago

asked 50 minutes ago

asked 1 hour ago

asked 1 hour ago

asked 1 hour ago

asked 1 hour ago

asked 2 hours ago

asked 2 hours ago

asked 2 hours ago

asked 2 hours ago

asked 2 hours ago