Question

A severe weathering clay brick was tested for absorption and saturation coefficient according to ASTM C67...

A severe weathering clay brick was tested for absorption and saturation coefficient according to ASTM C67 procedure and produced the following data: Dry mass of specimen = 2.635 kg Saturated mass after 24-hour submersion in cold water = 2.83 kg Saturated mass after 5-hour submersion in boiling water = 2.866 kg Please round to the nearest hundredth (i.e., 0.01). 1. Calculate absorption by 24-hour submersion = Answer % 2. Calculate absorption by 5-hour boiling = Answer % 3. Calculate saturation coefficient = Answer 4. Does the brick satisfy the ASTM requirements? Write down either yes or no. No spaces, and case is unimportant. Answer

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
Bricks are to be used for the veneer of the building in Question #1. Medium weathering...
Bricks are to be used for the veneer of the building in Question #1. Medium weathering bricks are specified, and a sample of those provided by the brick vendor yields the following test results: • Dry weight: 5.25 lbs. • Weight after 24-hour submersion: 6.32 lbs. • Weight after 5-hour boiling: 6.45 lbs. Based on the provided information, determine: • The minimum compressive strength, maximum 5-hour absorption, and saturation coefficient for the brick (1 pt.) • Whether the brick meets...
The coefficient of absorption (COA) for a clay brick is the ratio of the amount of...
The coefficient of absorption (COA) for a clay brick is the ratio of the amount of cold water to the amount of boiling water that the brick will absorb. An article presents measurements of the (COA) and the pore volume (in cm3/g) for seven bricks. The results are presented in the following table Pore Volume COA 1.750 0.8 1.632 0.78 1.594 0.77 1.623 0.75 1.495 0.71 1.465 0.66 1.28 0.63 a. Compute the least-squares line for predicting COA from pore...
In order to determine the density of a clay soil, an undisturbed sample was taken in...
In order to determine the density of a clay soil, an undisturbed sample was taken in a sampling tube of volume 2 litres. The following data were obtained: •     Mass of tube (empty) = 1900g •     Mass of tube and clay sample = 5280g •     Mass of tube and clay sample after drying = 4850g. Calculate the water content, the bulk, and the dry densities (in kg/m3). If the particle specific gravity was 2.75, determine the void ratio and the...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT