Question

The wall shear stress in a fully developed flow portion of a 18-in.-diameter pipe carrying water...

The wall shear stress in a fully developed flow portion of a 18-in.-diameter pipe carrying water is 1.65 lb/ft2. Determine the pressure gradient, ∂p/∂x, where x is in the flow direction, if the pipe is (a) horizontal, (b) vertical with flow up, or (c) vertical with flow down.

Homework Answers

Answer #1

Answers

a. -4.4 lb/ft3

b. -66.80 lb/ft3

c. 58 lb/ft3

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
A fully developed flow of an oil is taking place in a pipe of diameter 300mm....
A fully developed flow of an oil is taking place in a pipe of diameter 300mm. The velocity atthe centre of the pipe is 2.0m/s. Given the specific gravity and dynamic viscosity of the oilflowing to be 0.8 and 2.5×10−3N s/m2respectively. Determine the following: i Average velocity of water in the pipe. ii Diameter at which the the velocity of water is equal to the average velocity. iii Velocity at 30mmand 40mmfrom the wall.iv Reynolds number of the flow.
Consider the fully developed flow of glycerin at 40C Trough a 70m long, 4 cm diameter,...
Consider the fully developed flow of glycerin at 40C Trough a 70m long, 4 cm diameter, horizontal, circular pipe. if the flow velocity at the centerline is measured to be 6 m/s, determinate the velocity profile and the pressure difference across this 70m long section of the pipe, and the useful pumping power required to maintain this flow.
Using Bernoulli Equation : 1) A water pump forces water up a vertical pipe with diameter...
Using Bernoulli Equation : 1) A water pump forces water up a vertical pipe with diameter 12 cm at a flow rate of 300 L/s. The pressure at the pump is 2.8 x 106 N/m2 . Two meters above the pump, the pipe reduces to a diameter of 8 cm. What is the pressure at that point?
Inside the wall of a house, an L-shaped section of hot-water pipe consists of three parts:...
Inside the wall of a house, an L-shaped section of hot-water pipe consists of three parts: a straight, horizontal piece h = 28.0 cm long, an elbow, and a straight vertical piece ℓ = 156 cm long (figure below). A stud and a second-story floorboard hold the ends of this section of copper pipe stationary. Find the magnitude and direction of the displacement of the pipe elbow when the water flow is turned on, raising the temperature of the pipe...
Water flow horizontally for 4 m through a 65mm diameter cast iron pipe at an average...
Water flow horizontally for 4 m through a 65mm diameter cast iron pipe at an average velocity of 2 ms-1before an 90 degree elbow changes the direction of the flow downwards for a further 9 m. A ball valve is fitted at the end of the 9 m length of pipe. Determine the pressure at the pipe inlet if the ball valve is fully opend.(density of water = 998 kgm-3 , u=8.9*10^-4 Pas) I just calculated the friction losses before...